ALBERT

Description: In this study, we present an interpretation of seismic refraction profiles from the PISCO 94 experiment in northern Chile. As the PISCO experiment was a combined active and passive seismological study, we also discuss results of the passive part in the context of the seismic refraction model. Previous seismic refraction and gravimetric studies indicate a maximum crustal thickness of about 70 km beneath the Pre- and Western Cordillera. The new seismic refraction data lead to a differentiated image of the Andean crust which shows strong varying characteristics. The crustal discontinuities (up to five are detected) dip from W to E. The upper crust has a thickness of 18 km (Precordillera) to 23 km (magmatic arc) underlain by the recent middle crust down to 35-45 km where the velocity increases to about 7 km/s at its base. This crustal level is interpreted as old continental lower crust and its base as blurred continental (paleo) Moho. Beneath the Precordillera, a strong discontinuity at 70 km depth with a velocity increase to about 8 km/s was detected, interpreted as the recent geophysical Moho. For the magmatic arc, this deep discontinuity could not be found by active seismic measurements. The tomographic models of the seismological studies, in general, confirm the seismic refraction results. Anomalously high vp/vs rations in the deeper part of the forearc indicate a hydrated mantle wedge consisting of serpentine and amphibole-bearing peridotite and the 70 km discontinuity is interpreted as the boundary between these two different stages of the hydrated mantle wedge. A zone of high attenuation (Qp) and high vp/vs ratios beneath the magmatic arc coincides with the low velocity zones and indicates partially molten rocks from a depth of 20 km down to the asthenospheric wedge.

Description: The more than 1000 km long trans-continental Dead Sea Transform (DST) forms the boundary between the African and Arabian plates in the Middle East. Magnetotelluric (MT) data were recorded at more than 200 sites, focusing on the DST in the Arava valley in Jordan. 2D inversion results of the MT data indicate very clearly that the DST is associated with a strong lateral conductivity contrast. The most prominent feature on the MT image is a conductive half-layer beginning at a depth of approximately 1.5 km, which may be caused by brines in porous sediments. The DST can be identified as a sharp vertical conductivity boundary on the east side of the feature and directly beneath the surface trace. On a coincident high-resolution seismic tomography image of the upper crust, a strong increase of the P wave velocities to values exceeding 5 km/s is observed west of the DST, where the MT model indicates lower conductivities. The seismic velocities are consistent with metamorphic basement rocks; however the observed resistivities (50-250 $Omega m$) are unusually low for unaltered metamorphic rocks. Fractured metamorphic rocks with interconnected fluid bearing veins could explain both the seismic and MT observations. However, the conductivity model suggests furthermore that the DST acts as an impermeable barrier to cross-fault fluid flow. In stark contrast, a prominent flower structure is observed along the central segment of the SAF and interpreted as evidence of pervasive along-fault fluid flow. Here, the high conductivity is attributed to the circulation of saline fluids within the damage zone of the fault system. The width of the conductive zone (0.5 km) is in the same order of magnitude as the width of a seismic low-velocity zone inferred from fault-zone-guided wave observations, while its depth extent (3 km) coincides with the occurrence of a cluster of small earthquakes. It is possible, that the damage zone of the DST is so narrow that it cannot be resolved even with the dense site spacing of the MT experiment. This observation is supported by preliminary results from geological mapping and a seismic study using fault-guided waves that suggest a very narrow low-velocity wave-guide of 3 to 10 m width. The reason for this difference between the DST (very narrow fault zone) and the SAF (wide gouge zone) is not yet clear, but seems to coincide with generally slower slip rates and the relatively low recent seismicity associated with this segment of the DST.

Description: We use traveltime data of local earthquakes and controlled sources observed by a large, temporary, amphibious seismic network to reveal the anatomy of the southcentral Chilean subduction zone (37–39°S) between the trench and the magmatic arc. At this location the giant 1960 earthquake (M = 9.5) nucleated and ruptured almost 1000 km of the subduction megathrust. For the three-dimensional tomographic inversion we used 17,148 P wave and 10,049 S wave arrival time readings from 439 local earthquakes and 94 shots. The resolution of the tomographic images was explored by analyzing the model resolution matrix and conducting extensive numerical tests. The downgoing lithosphere is delineated by high seismic P wave velocities. High v p/v s ratio in the subducting slab reflects hydrated oceanic crust and serpentinized uppermost oceanic mantle. The subducting oceanic crust can be traced down to a depth of 80 km, as indicated by a low velocity channel. The continental crust extends to approximately a 50-km depth near the intersection with the subducting plate. This suggests a wide contact zone between continental and oceanic crust of about 150 km, potentially supporting the development of large asperities. Eastward the crustal thickness decreases again to a minimum of about a 30-km depth. Relatively low v p/v s at the base of the forearc does not support a large-scale serpentinization of the mantle wedge. Offshore, low v p and high v p/v s reflect young, fluid-saturated sediments of forearc basins and the accretionary prism.

Description: A 400-km-long seismic reflection profile (Andean Continental Research Project 1996 (ANCORP'96)) and integrated geophysical experiments (wide-angle seismology, passive seismology, gravity, and magnetotelluric depth sounding) across the central Andes (21°S) observed subduction of the Nazca plate under the South American continent. An east dipping reflector (Nazca Reflector) is linked to the down going oceanic crust and shows increasing downdip intensity before gradual breakdown below 80 km. We interpret parts of the Nazca Reflector as a fluid trap located at the front of recent hydration and shearing of the mantle, the fluids being supplied by dehydration of the oceanic plate. Patches of bright (Quebrada Blanca Bright Spot) to more diffuse reflectivity underlie the plateau domain at 15–30 km depth. This reflectivity is associated with a low-velocity zone, P to S wave conversions, the upper limits of high conductivity and high Vp/Vs ratios, and to the occurrence of Neogene volcanic rocks at surface. We interpret this feature as evidence of widespread partial melting of the plateau crust causing decoupling of the upper and lower crust during Neogene shortening and plateau growth. The imaging properties of the continental Moho beneath the Andes indicate a broad transitional character of the crust-mantle boundary owing to active processes like hydration of mantle rocks (in the cooler parts of the plate margin system), magmatic underplating and intraplating under and into the lowermost crust, mechanical instability at Moho, etc. Hence all first-order features appear to be related to fluid-assisted processes in a subduction setting