ALBERT

Description: The more than 1000 km long trans-continental Dead Sea Transform (DST) forms the boundary between the African and Arabian plates in the Middle East. Magnetotelluric (MT) data were recorded at more than 200 sites, focusing on the DST in the Arava valley in Jordan. 2D inversion results of the MT data indicate very clearly that the DST is associated with a strong lateral conductivity contrast. The most prominent feature on the MT image is a conductive half-layer beginning at a depth of approximately 1.5 km, which may be caused by brines in porous sediments. The DST can be identified as a sharp vertical conductivity boundary on the east side of the feature and directly beneath the surface trace. On a coincident high-resolution seismic tomography image of the upper crust, a strong increase of the P wave velocities to values exceeding 5 km/s is observed west of the DST, where the MT model indicates lower conductivities. The seismic velocities are consistent with metamorphic basement rocks; however the observed resistivities (50-250 $Omega m$) are unusually low for unaltered metamorphic rocks. Fractured metamorphic rocks with interconnected fluid bearing veins could explain both the seismic and MT observations. However, the conductivity model suggests furthermore that the DST acts as an impermeable barrier to cross-fault fluid flow. In stark contrast, a prominent flower structure is observed along the central segment of the SAF and interpreted as evidence of pervasive along-fault fluid flow. Here, the high conductivity is attributed to the circulation of saline fluids within the damage zone of the fault system. The width of the conductive zone (0.5 km) is in the same order of magnitude as the width of a seismic low-velocity zone inferred from fault-zone-guided wave observations, while its depth extent (3 km) coincides with the occurrence of a cluster of small earthquakes. It is possible, that the damage zone of the DST is so narrow that it cannot be resolved even with the dense site spacing of the MT experiment. This observation is supported by preliminary results from geological mapping and a seismic study using fault-guided waves that suggest a very narrow low-velocity wave-guide of 3 to 10 m width. The reason for this difference between the DST (very narrow fault zone) and the SAF (wide gouge zone) is not yet clear, but seems to coincide with generally slower slip rates and the relatively low recent seismicity associated with this segment of the DST.