ALBERT

Beschreibung: Barnacles are one of the most prominent hardfouling organisms in the marine environment. They are able to adhere efficiently to nearly every surface underwater including artificial ones like ship hulls and maritime installations. This overgrowing can lead to huge economical costs. Previous studies have shown that specific microstructure types including micropillars can reduce the initial settlement of barnacles. However, it is not clear how adult barnacles are influenced by microstructured surfaces and whether microstructures can even decrease the resulting adhesion strength of them under natural conditions. Therefore, the aim of this study was to systematically investigate the influence of height, diameter, aspect ratio and flexibility of fibrillar microstructures made from polydimethylsiloxane (PDMS) on initial settlement of barnacles as well as the permanent attachment of adult ones. Micropillars with three different heights (50 µm, 100 µm, 200 µm) and two different diameters (25 µm, 50 µm) were exposed to the Baltic Sea for 12 weeks. On a weekly basis, all barnacles (Balanus [= Amphibalanus] improvisus) were tracked individually to calculate the release-to-settlement ratio and to capture the average attachment duration prior to detachment. The results have shown that with increasing height, both initial settlement and fouling density development were reduced. An increase of diameter showed a similar relationship but at a much smaller scale. All tested microstructures decreased the detachment rates of barnacles from the surface compared to a flat PDMS control. However, they appear to complicate the development of a strong adhesive joint in the young adult phase. Some grade of flexibility in the microstructures appeared to increase the fouling retention. The results shed light in the interaction between adult barnacle adhesion and microstructures and may help in the development of new antifouling technologies.

Beschreibung: DLC:Si and DLC:N (diamond-like carbons doped with Si or N) functional layers in different configurations are deposited on polyurethane (PU) for bioengineering applications using CCP (capacitively coupled plasma) discharge generated in the PE CVD (plasma-enhanced chemical vapor deposition) system. Scanning electron microscopy (SEM) observations show that the obtained single and multilayers are continuous and well adherent to the substrates, but they differ in surface morphologies. DLC:Si layers form granular-like outer surfaces, while DLC:N ones a mosaic structure of plain areas. Topography analyses by atomic force microscopy (AFM) and optical profilometry reveal that Si-doped layers are characterized by significantly higher surface roughness (Ra ca. 5 nm) in comparison to N-doped layers (Ra ca. 0.3 nm) and also higher values of profile roughness parameter Rz (up to 32 μm vs. about 13 μm). Energy-dispersive X-ray spectroscopy (EDS) analysis indicates the homogenous chemical composition of the layers. DLC:N layers, are characterized by significantly higher polar component of surface free energy (up to ca. 5.0 mJ/m2). DLC:Si layers exhibit higher values of diiodomethane contact angle (up to ca. 90°) compared with DLC:N layers (up to ca. 55°). The attenuated total reflectance Fourier transform infrared spectroscopic measurements (ATR-FTIR) of the layers reveal that the addition of silicon to the DLC structure increases the content of terminal CHn bonds (n = 1, 2, 3) as well as beneficial Si–H and Si–CHn bonds, which significantly reduce the internal stresses in the layers. Both DLC:Si and DLC:N layers exhibit no cytotoxic effects using the human osteoblast-like cell line and human keratinocytes.