ALBERT

All Library Books, journals and Electronic Records Telegrafenberg

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 75 (1994), S. 6351-6353 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: This article reports the effect of Al doping into MnBiSi films on the structure and magneto-optical properties of the parent. Under suitable Al doping, the x-ray diffraction peaks of (002) and (004) move to a larger 2aitch-theta value related to that of MnBiSi. Moreover, two satellite peaks appear beside the main (002) and (004) peaks of MnBiAlSi. Such structural distortion due to Al doping results in an increased Kerr rotation angle, an effective perpendicular anisotropy constant Ku, as well as improvement of the thermal stability of MnBiSi.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 2
    ISSN: 1365-2109
    Source: Blackwell Publishing Journal Backfiles 1879-2005
    Topics: Agriculture, Forestry, Horticulture, Fishery, Domestic Science, Nutrition
    Notes: The effects of blocking polar body I (PB1) or polar body II (PB2) with four different dosages of cytochalasin B (CB) on the development and ploidy of resultant embryos were studied in the small abalone, Halitis diversicolor supertexta (Lischke). To block the release of PBI, the fertilized eggs were treated with 0.25, 0.5, 1.0 or 2.0 mgL−1 of CB for 10min beginning at 3 min post-fertilization at 24°C. To block the release of PB2, the fertilized eggs were treated under the same conditions as PB1, except that the treatment was begun 10min post-fertilization. In the control group, only 41.8% of the cells had a diploid number of 32 chromosomes, although spontaneous haploids (9.0%). tripolids (7.5%) and aneuploids (41.7%) were also observed. In CB treatment of PB1 and PB2 groups. 5.0-28.6% of the cells remained as diploid. triploids (10.0-18.9%) and aneuploids (41-1-61.0%). With regard to the development of the resultant embryos, the proportion of normal embryos in the control group was 87%, while in the treatment groups, the proportions of normal embryos in the FBI and PB2 groups were 57-58% and 53-56% in the 0.25 mg L−1 and 0.5mg L−1 CB treatments, respectively. From this data on induced triploids and the resultant development of normal embryos, the proportions suggest that 0.25-0.5 mg L−1 of CB for 10min was sufficient for blocking the release of FB1 or PB2 to produce triploids in the small abalone.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 3
    Electronic Resource
    Electronic Resource
    Oxford, UK : Blackwell Science Ltd
    European journal of soil science 51 (2000), S. 0 
    ISSN: 1365-2389
    Source: Blackwell Publishing Journal Backfiles 1879-2005
    Topics: Geosciences , Agriculture, Forestry, Horticulture, Fishery, Domestic Science, Nutrition
    Notes: The difficulties in using complicated models of carbon mineralization and the poor performance of simple ones call for new models that are simple in use and robust in performance. We have developed a model for the mineralization of carbon from experimental data in which the organic matter is treated as a single component. The logarithm of the average relative mineralization rate, K, or rate constant, of a substrate considered as a whole was found to be linearly related to the logarithm of time, t, provided prevailing soil conditions remained unchanged. The equation is: logK = logR–S logt, or K = R t–S, in which R (dimension tS − 1) represents K at t = 1, and S (dimensionless, 1 ≥ S≥ 0) is a measure of the rate at which K decreases over time, also called the speed of ‘ageing’ of the substrate. The quantity of the remaining substrate, Yt, is calculated by Yt = Y0 exp(–Rt1 – S), where Y0 is the initial quantity of the substrate. The actual relative mineralization rate, k, at time t is proportional to K, according to k = (1 − S)K. The model was tested against an assembly of 136 sets of data collected from trials conducted in 14 countries all over the world. They cover materials ranging from glucose, cellulose and plant residues, to farmyard manure, peat and soil organic matter. The results lead to the conclusion that the model describes well the dynamics of organic matter in soil over time varying from months to tens of years, provided major environmental conditions remain unchanged. It can easily be applied in practice and is attractive because of its modest input requirements.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 4
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Journal of Applied Physics 77 (1995), S. 5452-5454 
    ISSN: 1089-7550
    Source: AIP Digital Archive
    Topics: Physics
    Notes: Static thermomagnetic recording on MnBiAl films at 633 nm is reported. The intrinsic Kerr rotation of the sample investigated is 1.8° at 633 nm. A 14 mW pulsed laser was used to write stable domains with diameter of 1.2 μm under zero external applied magnetic field, and a 12 mW pulsed laser was utilized to erase the recorded domains using an external field 600 Oe. The direct observation of the homogeneously recorded domain arrays of 16×22 points on an area of approximately 0.01 mm2 shows that they possess a very good circular configuration, distinct margin, and a very high contrast between "0'', "1'' states due to large Kerr rotation θk and coercivity Hc. The number of write/erase cycles on MnBiAl is over 106 times, which is a significant improvement over the 103 times possible with MnBi. Measurements demonstrate that MnBiAl film is a promising magneto-optical recording medium. © 1995 American Institute of Physics.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 5
    Electronic Resource
    Electronic Resource
    [S.l.] : American Institute of Physics (AIP)
    Review of Scientific Instruments 68 (1997), S. 2542-2545 
    ISSN: 1089-7623
    Source: AIP Digital Archive
    Topics: Physics , Electrical Engineering, Measurement and Control Technology
    Notes: A novel technique is developed to measure quantitatively the adhesion strength of metallizations deposited on substrates such as silicon. Electrostatic adhesion testing employs electrostatic forces to generate delaminating stresses in thin metallic films. The interfacial adhesion strength is readily calculated from the electrode geometry and the applied electrostatic field at failure. Unlike other adhesion tests, this technique does not require any mechanical contact and is virtually independent of the plastic deformation of the film. Furthermore, this test provides direct strength measurements as opposed to work or energy of adhesion measurements obtained by the common peel test. The adhesion strengths of several metallizations (Cu, Al) are characterized using the electrostatic technique. The distribution of stress-at-failure data follows Weibull failure statistics. Field emission scanning electron microscopy reveals that the films are delaminated in a microblister-type mode. It is shown that electrostatic adhesion testing is effective in providing quantitative values for the adhesion strengths and failure probabilities of thin-film metallizations. © 1997 American Institute of Physics.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 6
    Electronic Resource
    Electronic Resource
    Amsterdam : Elsevier
    Chinese Astronomy and Astrophysics 5 (1981), S. 77-83 
    ISSN: 0275-1062
    Source: Elsevier Journal Backfiles on ScienceDirect 1907 - 2002
    Topics: Physics
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 7
    Electronic Resource
    Electronic Resource
    Amsterdam : Elsevier
    Chinese Astronomy and Astrophysics 5 (1981), S. 84-89 
    ISSN: 0275-1062
    Source: Elsevier Journal Backfiles on ScienceDirect 1907 - 2002
    Topics: Physics
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 8
    Electronic Resource
    Electronic Resource
    Amsterdam : Elsevier
    Chinese Astronomy and Astrophysics 7 (1983), S. 309-314 
    ISSN: 0275-1062
    Source: Elsevier Journal Backfiles on ScienceDirect 1907 - 2002
    Topics: Physics
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 9
    Electronic Resource
    Electronic Resource
    Springer
    Cellular and molecular life sciences 34 (1978), S. 702-702 
    ISSN: 1420-9071
    Source: Springer Online Journal Archives 1860-2000
    Topics: Biology , Medicine
    Notes: Summary A partial purification and some properties of adenylate kinase from the photosynthetic bacteriumRhodospirillum rubrum are described.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 10
    ISSN: 1573-4803
    Source: Springer Online Journal Archives 1860-2000
    Topics: Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
    Notes: Abstract Fine-grained AA7475 aluminium alloy sheets were produced in this study by a thermomechanical treatment involving solution anneal, overageing, rolling and recrystallization steps. It has been found that the cooling rate after the intermediate overageing treatment should be fast to obtain the finest grain size. The fast cooling rate ensured the presence of relatively large particles of MgZn2 and some supersaturation prior to cold rolling. Generally, the final grain structure was heterogeneous, with bands of fine grains lying parallel to the rolling direction. In material rapidly cooled after overageing, bands of fine grains were also observed in the transverse direction and these bands were associated with shear bands formed during rolling. The fine-grained AA7475 alloy sheets with an average grain size of about 9 μm showed large tensile elongations of about 800% when deformed at 516 °C and with an initial strain rate of 5×10−4s−1.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...