ALBERT

All Library Books, journals and Electronic Records Telegrafenberg

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Call number: ZSP-202-347
    In: Research report / Cold Regions Research and Engineering Laboratory, 347
    Description / Table of Contents: CONTENTS: Abstract. - Preface. - Introduction. - Experimental. - Results and discussion. - Applications. - Literature cited.
    Description / Table of Contents: Chemical analysis of century-old ice from continuous 5 to 7 year intervals of three ice cores from south and central Greenland (Dye 3, Milcent and Crete) show maximum concentrations of Na, Mg,Ca, K, and Al during early spring and minimum concentrations during late summer and early fall. Peak spring values are as much as 10 times greater than fall values. Because of the large seasonal chemical variations, samples used for depth-age or annual deposition rate studies must represent accumulation from exactly one year or whole multiples of a year. The seasonal chemical variations seem promising as a new method of defining annual layers and thus dating old ice cores.
    Type of Medium: Series available for loan
    Pages: iii, 5 Seiten , Illustrationen
    Series Statement: Research report / Cold Regions Research and Engineering Laboratory 347
    Language: English
    Location: AWI Archive
    Branch Library: AWI Library
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 2
    Call number: ZSP-201-76/24
    In: CRREL Report, 76-24
    Description / Table of Contents: Chemical analysis of surface snows and deeper ice core samples from Milcent, Greenland, indicates a marine origin for Na and Cl and a terrestrial origin for Al, Mn and V. Pre-1900 enrichment factors, based on average crustal composition, are high for Zn and Hg and appear to be related to their volatility. A comparison of pre-1900 and 1971-1973 concentrations of V and Hg shows no decided increase from industrial production; however, the abundance of Zn (relative to Al) increased three-fold during this time period. The chemical composition of ancient ice is extremely useful in interpreting modern aerosols.
    Type of Medium: Series available for loan
    Pages: ii, 6 Seiten , Illustrationen
    Series Statement: CRREL Report 76-24
    Language: English
    Location: AWI Archive
    Branch Library: AWI Library
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 3
    Series available for loan
    Series available for loan
    Hanover, NH : U.S. Army Cold Regions Research and Engineering Laboratory
    Associated volumes
    Call number: ZSP-201-78/26
    In: CRREL Report, 78-26
    Description / Table of Contents: Ice fog suppression experiments on the Fort Wainwright Power Plant cooling pond were conducted during the winters of 1974-76. Baseline information studies occupied a sizable portion of the available ice fog weather in 1974-75. Then hexadecanol was added to the pond and dramatically improved visibility by reducing fog generated from water vapor released by the pond at -14 C. Although this temperature was not low enough to create ice fog, the cold vapor fog created was equally as devastating to visibility in the vicinity of the pond. During the winter of 1975-76, suppression tests were continued using films of hexadecanol, mixes of hexadecanol and octadecanol, and ethylene glycol monobutyl ether (EGME). Suppression effectiveness at colder temperatures was stuided and limits to the techniques were probed. A reinforcing grid was constructed that prevented breakup of the film by wind and water currents. Lifetime tests indicated that EGME degrades much more slowly than either hexadecanol or the hexadecanol-octadecanol mix. The films were found to be very effective fog reducers at warmer temperatures but still allowed 20% to 40% of normal evaporation to occur. The vapor thus produced was sufficient to create some ice fog at lower temperatures, but this ice fog occurred less frequently and was more quickly dispersed than the thick fog that was present before application of the films.
    Type of Medium: Series available for loan
    Pages: iv, 27 Seiten , Illustrationen
    Series Statement: CRREL Report 78-26
    Language: English
    Note: CONTENTS Abstract Preface Introduction Ice fog from cooling ponds Evaporation Relative humidity and cold air Ice fog suppression Air movement Plastic films Rafts Injection wells Cooling towers Chemical films Reinforced film experiments Meteorological data collection Floating reinforcement grid Application of the hexadecanol film Hexadecanol, octadecanol mixes Ethylene glycol monobutyl ether Laboratory tests of suppression effectiveness Conclusions Literature cited Appendix A. Design for an automatic thin chemical film applicationsystem Appendix B. Meteorological data
    Location: AWI Archive
    Branch Library: AWI Library
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 4
    Series available for loan
    Series available for loan
    Hanover, NH : U.S. Army Cold Regions Research and Engineering Laboratory
    Associated volumes
    Call number: ZSP-201-79/6
    In: CRREL Report, 79-6
    Description / Table of Contents: Nondestructive repetitive plate bearing (RPB) tests were conducted on various test sections in state highways in Maine during 13-15 April 1976. The RPB test consists of making resilient surface deflection measurements during repetitive loadings at various radii from the load plate. The pavement system stiffness was calculated and the resilient modulus values for the various pavement layers were determined with the Chevron computer program for a layered elastic system. A thawed analysis using nondimensional deflection curves for the various sections provided a guide to the susceptibility of the pavement systems to surface failure and pothole development. Some comparisons between stabilized and nonstabilized aggregate and soil were made with calculated stiffness values. The moduli of the various materials were also compared. The residual surface deflections during testing for several pavement systems indicated a linear logarithmic relationship with number of load applications. A relationship between the modulus of the asphalt cement concrete pavement and pavement temperature was developed for the limited temperature range during the testing.
    Type of Medium: Series available for loan
    Pages: v, 20 Seiten , Illustrationen
    Series Statement: CRREL Report 79-6
    Language: English
    Note: CONTENTS Abstract Preface Conversion factors Introduction Descriptions of road test sections Test equipment and procedures. Field repetitive plate bearing tests Data analysis General Layered-elastic analysis of the pavement systems Statistical analysis. Flexural analysis Summary and conclusions Literature cited Appendix A: Resilient surface deflections for the test points
    Location: AWI Archive
    Branch Library: AWI Library
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 5
    Series available for loan
    Series available for loan
    Hanover, NH : U.S. Army Cold Regions Research and Engineering Laboratory
    Associated volumes
    Call number: ZSP-201-77/32
    In: CRREL Report, 77-32
    Description / Table of Contents: An experimental study of forced convective heat transfer over a vertical melting plate has been conducted. This study covers water velocities ranging from 1.7 to 9.8 mm/s and bulk water temperatures from 1.11 to 7.50 C. The experimental results are correlated in terms of Nusselt, Prandtl and Reynolds numbers with a moderate correlation coefficient of 0.843. The results are expected to be useful in predicting the heat transfer characteristics of a much larger prototype ice-water heat sink.
    Type of Medium: Series available for loan
    Pages: v, 12 Seiten , Illustrationen
    Series Statement: CRREL Report 77-32
    Language: English
    Note: CONTENTS Abstract Preface Nomenclature Summary Introduction Problem General review of the subject Experimental apparatus General considerations Water reservoir Test chamber assembly Pumping system Electrical control system Experimental procedure Experimental results Discussion and comparison of results Conclusions Literature cited
    Location: AWI Archive
    Branch Library: AWI Library
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 6
    Series available for loan
    Series available for loan
    Hanover, NH : U.S. Army Cold Regions Research and Engineering Laboratory
    Associated volumes
    Call number: ZSP-201-78/2
    In: CRREL Report, 78-2
    Description / Table of Contents: Many of the technical questions relating to iceberg transport are given brief, but quantitative, consideration. These include iceberg genesis and properties, the mechanical stability of icebergs at sea, towing forces and tug characteristics, drag coefficients, ablation rates, and handling and processing the iceberg at both the pick-up site and at the final destination. In particular the paper attempts to make technical information on glaciological and ice engineering aspects of the problem more readily available to the interested planner or engineer. Specific conclusions include: (1) No unprotected iceberg, no matter how long or wide, would be likely to survive the ablation caused by a long trip to low latitudes. (2) Icebergs that have a horizontal dimension exceeding 2 km may well be prone to breakup by long wavelength swells. (3) To avoid the dangers associated with an iceberg capsizing, the width of a 200-m thick iceberg should always be more than 300 m. (4) For towing efficiency the length/width ratio of a towed iceberg should be appreciably greater than unity. (5) For a pilot project, the selected iceberg would have to be quite small, if for no other reason than the practical availability of tug power.
    Type of Medium: Series available for loan
    Pages: v, 31 Seiten , Illustrationen
    Series Statement: CRREL Report 78-2
    Language: English
    Note: CONTENTS Abstract Preface Introduction Sources and properties of tabular icebergs Sources Characteristics of ice shelves near the ice front Characteristics of tabular icebergs Towing Geophysical and engineering considerations Tug characteristics Handling and processing Cutting and boring with thermal devices Penetration with electrothermal devices Electrothermal cutting Making vertical cuts by pre-split blasting Primary fragmentation by blasting Primary fragmentation by mechanical sawing Comminuting ice with machines Slurry pipelines Conclusion Literature cited
    Location: AWI Archive
    Branch Library: AWI Library
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 7
    Series available for loan
    Series available for loan
    Hanover, NH : U.S. Army Cold Regions Research and Engineering Laboratory
    Associated volumes
    Call number: ZSP-201-79/8
    In: CRREL Report, 79-8
    Description / Table of Contents: Sea ice ridging statistics obtained from a series of laser surface roughnessprofiles are examined. Each set of profiles consists of six 200-km-long flight tracks oriented approximately perpendicular to the coastline of the Chukchi and Beaufort Seas. The landward ends of the profiles were located at Point Lay, Wainwright, Barrow, Lonely, Cross Island and Barter Island. The flights were made in February, April, August, and December 1976, and one additional profile was obtained north of Cross Island during March 1978. It was found that although there is a systematic variation in mean ridge height (h) with season (with the highest values occurring in late winter), there is no systematic spatial variation in h at a given time. The number of ridges/km (micron) is also high during the late winter, with the highest values occurring in the Barter and Cross Island profiles . In most profiles, the ice 20 to 60 km from the coast is more highly deformed (higher micron values) than the ice either nearer the coast or farther seaward. The Wadhams model for the distribution of ridge heights gives better agreement with observed values in the higher ridge categories than does the Hibler model. Estimates of the spatial recurrence frequency of large pressure ridges are made by using the Wadhams model and also by using an extreme value approach. In the latter, the distribution of the lagest ridges per 20 km of laser track was found to be essentially normal
    Type of Medium: Series available for loan
    Pages: iv, 28 Seiten , Illustrationen
    Series Statement: CRREL Report 79-8
    Language: English
    Note: CONTENTS Abstract Preface Introduction Data collection and processing Analysis General Variations in ridging Ridge height distributions Occurrence of high ridges The tail of the distribution Extreme values Applications to offshore design Conclusions Literature cited Appendix A. Tabulated ice ridge data
    Location: AWI Archive
    Branch Library: AWI Library
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 8
    Call number: ZSP-201-78/28
    In: CRREL Report, 78-28
    Type of Medium: Series available for loan
    Pages: x, 112 Seiten , Illustrationen
    Series Statement: CRREL Report 78-28
    Language: English
    Note: CONTENTS Abstract Preface Conversion factors Introduction Descriptions of road test sections Test equipment and procedures Field repetitive plate bearing tests Data analysis General Layered-elastic analysis of the pavement systems Statistical analysis Flexural analysis Summary and conclusions Literature cited Appendix A: Resilient surface deflections for the test points
    Location: AWI Archive
    Branch Library: AWI Library
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 9
    Call number: ZSP-201-78/23
    In: CRREL Report, 78-23
    Type of Medium: Series available for loan
    Pages: vi, 53 Seiten , Illustrationen
    Series Statement: CRREL Report 78-23
    Language: English
    Note: CONTENTS Abstract Preface Nomenclature Conversion factors: Metric (SI) to U.S. customary units of measurement Introduction Selection of experimental approach Previous investigations of effect of freeze-thaw on soil deform ability Selection of laboratory test method Selection of method of field validation tests Field repeated-load plate-bearing tests Test pavements, soils and materials Test procedures and results Resilient modulus of subgrade calculated from field tests Mathematical model Characterization of asphalt concrete Characterization of frozen silt Calculated resilient modulus of silt within the zone of freezing Laboratory repeated-load triaxial tests Specimens, equipment and testing procedures Apparatus Procedures Resilient properties calculated from laboratory tests Calculation methods Asphalt concrete - test results Asphalt concrete - statistical analysis and discussion Silt - test results Silt - statistical analysis Discussion and conclusions Literature cited Appendix A. Repeated-load plate-bearing test results Appendix B. Laboratory repeated-load triaxial test results Appendix C. Regression equation coefficients for resilient modulus and Poisson’s ratio from repeated-load triaxial test data on asphalt concrete and silt Appendix D. Detailed procedures for repeated-load triaxial testing
    Location: AWI Archive
    Branch Library: AWI Library
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 10
    Call number: ZSP-201-76/8
    In: CRREL Report, 76-8
    Description / Table of Contents: During the past decade a number of methods for measuring the amount of unfrozen water in partially frozen ground have emerged. Means of quickly and simply predicting unfrozen water contents in clay have become increasingly important with the growth of interest in encapsulating clay soils compacted at low water contents to serve as base courses for roads. Unfortunately the measurements require sophisticated equipment and, in most instances, specially trained operators. In an effort to simplify the task of obtaining water-ice phase composition data, methods of calculating phase composition curves from other, simpler measurements on soils have been sought. The paper presents a method of deriving the measurement of unfrozen water contents at various temperatures from liquid limit determinations.
    Type of Medium: Series available for loan
    Pages: iv, 9 Seiten , Illustrationen
    Series Statement: CRREL Report 76-8
    Language: English
    Location: AWI Archive
    Branch Library: AWI Library
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...