ALBERT

Description: The Hunt for Observable Signatures of Terrestrial Systems survey searches for dust near the habitable zones (HZs) around nearby, bright main-sequence stars. We use nulling interferometry in the N band to suppress the bright stellar light and to probe for low levels of HZ dust around the 30 stars observed so far. Our overall detection rate is 18%, including four new detections, among which are the first three around Sun-like stars and the first two around stars without any previously known circumstellar dust. The inferred occurrence rates are comparable for early-type and Sun-like stars, but decrease from 60(sup +16)(sub -21)% for stars with previously detected cold dust to 8(sup +10)(sub -3)% for stars without such excess, confirming earlier results at higher sensitivity. For completed observations on individual stars, our sensitivity is five to ten times better than previous results. Assuming a lognormal excess luminosity function, we put upper limits on the median HZ dust level of 13 zodis (95% confidence) for a sample of stars without cold dust and of 26 zodis when focusing on Sun-like stars without cold dust. However, our data suggest that a more complex luminosity function may be more appropriate. For stars without detectable Large Binocular Telescope Interferometer (LBTI) excess, our upper limits are almost reduced by a factor of two, demonstrating the strength of LBTI target vetting for future exo-Earth imaging missions. Our statistics are limited so far, and extending the survey is critical to informing the design of future exo-Earth imaging surveys.

Description: The problem of making very large glass mirrors for astronomical telescopes is examined, and the advantages of honeycomb mirrors made of borosilicate glass are discussed. Thermal gradients in the glass that degrade the figure of thick borosilicate mirrors during use can be largely eliminated in a honeycomb structure by internal ventilation (in air) or careful control of the radiation environment (in space). It is expected that ground-based telescopes with honeycomb mirrors will give better images than those with solid mirrors. Materials, techniques, and the experience that has been gained making trial mirrors and test castings as part of a program to develop 8-10-m-diameter lightweight mirrors are discussed.

Description: The distribution and concentrations of the standing crop of phytoplankton and nutrient salts in the Gulf of Mexico and the Caribbean Sea were investigated to provide ground truth for correlating temperature and chlorophyll-a measurements with observations from NASA U-2 aircraft equipped with specially designed sensors for measuring ocean color phenomena. The physical, chemical, and biological data obtained is summarized. Sampling procedures and methods used for determining plant pigments, species composition of phytoplankton, nutrient salt analysis, and the euphotic zones are described.

Description: Structural phospholipoprotein isolated from hydrogenomonas facilis and neurospora crassa

Description: Single silica fibers of the type developed for communications are useful in the design of astronomical spectrographs. They can be used to couple light from many objects over a wide field to a single spectrograph, or to eliminate wavelength errors from image motion and gravitational flexure. For many applications it will be advantageous to use small lenses to make the most efficient coupling into and out of a fiber. If the telescope pupil is imaged on the fiber core, an efficient coupling can be made that preserves image size over a certain range. This method is demonstrated by a laboratory test using sapphire spheres as coupling lenses.

Description: We present diffraction-limited K s band and L(prime) adaptive optics images of the edge-on debris disk around the nearby F2 star HD 15115, obtained with a single 8.4 m primary mirror at the Large Binocular Telescope. At the Ks band, the disk is detected at signal-to-noise per resolution element (SNRE) approx. 3-8 from approx. 1 to 2".5 (45-113 AU) on the western side and from approx. 1". 2 to 2".1 (63-90 AU) on the east. At L the disk is detected at SNRE approx. 2.5 from approx. 1 to 1".45 (45-90 AU) on both sides, implying more symmetric disk structure at 3.8 micrometers. At both wavelengths the disk has a bow-like shape and is offset from the star to the north by a few AU. A surface brightness asymmetry exists between the two sides of the disk at the Ks band, but not at L(prime). The surface brightness at the K s band declines inside 1"(approx. 45 AU), which may be indicative of a gap in the disk near 1".The K s L(prime) disk color, after removal of the stellar color, is mostly gray for both sides of the disk. This suggests that scattered light is coming from large dust grains, with 3-10 micrometers sized grains on the east side and 1-10 micrometers dust grains on the west. This may suggest that the west side is composed of smaller dust grains than the east side, which would support the interpretation that the disk is being dynamically affected by interactions with the local interstellar medium.

Description: The making of large astronomical mirrors with borosilicate glass honeycomb structure is discussed. Particular attention is given to a single casting technique for making borosilicate honeycomb mirror blanks up to 7 meters in diameter. Current work on the development of this technique involves the casting of blanks 60 cm in diameter which have the full thickness (33 cm), cell size (15 cm), and faceplate thickness (2.5 cm) needed for a 1.8-m mirror.

Description: The Large Binocular Telescope Interferometer uses a near-infrared camera to measure the optical path length variations between the two AO-corrected apertures and provide high-angular resolution observations for all its science channels (1.5-13 microns). There is however a wavelength dependent component to the atmospheric turbulence, which can introduce optical path length errors when observing at a wavelength different from that of the fringe sensing camera. Water vapor in particular is highly dispersive and its effect must be taken into account for high-precision infrared interferometric observations as described previously for VLTI/MIDI or the Keck Interferometer Nuller. In this paper, we describe the new sensing approach that has been developed at the LBT to measure and monitor the optical path length fluctuations due to dry air and water vapor separately. After reviewing the current performance of the system for dry air seeing compensation, we present simultaneous H-, K-, and N-band observations that illustrate the feasibility of our feed forward approach to stabilize the path length fluctuations seen by the LBTI nuller uses a near-infrared camera to measure the optical path length variations between the two AO-corrected apertures and provide high-angular resolution observations for all its science channels (1.5-13 microns). There is however a wavelength dependent component to the atmospheric turbulence, which can introduce optical path length errors when observing at a wavelength different from that of the fringe sensing camera. Water vapor in particular is highly dispersive and its effect must be taken into account for high-precision infrared interferometric observations as described previously for VLTI MIDI or the Keck Interferometer Nuller. In this paper, we describe the new sensing approach that has been developed at the LBT to measure and monitor the optical path length fluctuations due to dry air and water vapor separately. After reviewing the current performance of the system for dry air seeing compensation, we present simultaneous H-, K-, and N-band observations that illustrate the feasibility of our feed forward approach to stabilize the path length fluctuations seen by the LBTI nuller.

Description: The paper discusses an oceanographic remote sensing program conducted aboard the R/V Calypso in the Gulf of Mexico and the Caribbean Sea to provide information for correlating ocean measurements with remotely sensed observations. Remote sensors on satellites and aircraft are used as operations and experiment planning tools as well as for scientific data acquisition. Emphasis is on providing surface-truth measurements for OCS flights and on investigating the area of the Gulf affected by the outflow of the Mississippi River. The discussion covers the shipboard instrumentation, ocean color scanner data acquisition and results, NOAA/VHRR data analysis approach, and Landsat and APT/ATS as planning tools. The research effort has demonstrated the feasibility of using satellite data as a supportive method to aid an oceanographic research vessel on a near real-time basis.