ISSN:
1573-0840
Schlagwort(e):
marble
;
frequency dependent complex conductivity
;
pressure
;
fracture
;
precursor
Quelle:
Springer Online Journal Archives 1860-2000
Thema:
Energietechnik
,
Geographie
,
Geologie und Paläontologie
Notizen:
Abstract Pressure induced variations of the pore geometry werestudied by means of complex electrical dispersionmeasurements on natural marble (97% calcite, 3%quartz) and synthetic calcite samples (95% calcite,5% quartz; Siddiqi et al., 1997). Hydrostatic (up to 160 MPa) pressures were used toexamine the closing of fractures, whereas, triaxial pressures (Pc = 3 MPa; Pu = 1 to100 MPa) revealed information on forming and growth ofcracks. Porosity data ranged from 1 to 4 vol%.Permeabilities of the synthetic samples covered therange from 0.02 to 4 μD, whereas the naturalmarble exhibited a permeability of less than 5 nD. BETinner surface areas ranged from 0.29 to 0.7m2/g. The frequency dispersion was measured inthe frequency range 1 kHz to 1 MHz. This frequencyrange is extensive enough to fit model data to themeasured data. The interpretation of the model datarevealed information on bulk conduction processes andinterfacial phenomena as well. The latter one isdirectly related to variations in the pore geometryand resulted in a correlation between the BET surfaceand the model parameter sensitive to the closing,opening, forming and growth of fractures. Asignificant `precursor' signal before failure wasfound in the triaxial experiments.
Materialart:
Digitale Medien
URL:
http://dx.doi.org/10.1023/A:1008122012610
Permalink
