ALBERT

Description: On 12 September 2007, an Mw 8.4 earthquake occurred within the southern section of the Mentawai segment of the Sumatra subduction zone, where the subduction thrust had previously ruptured in 1833 and 1797. Traveltime data obtained from a temporary local seismic network, deployed between December 2007 and October 2008 to record the aftershocks of the 2007 event, was used to determine two-dimensional (2-D) and three-dimensional (3-D) velocity models of the Mentawai segment. The seismicity distribution reveals significant activity along the subduction interface and within two clusters in the overriding plate either side of the forearc basin. The downgoing slab is clearly distinguished by a dipping region of high Vp (8.0 km/s), which can be a traced to ∼50 km depth, with an increased Vp/Vs ratio (1.75 to 1.90) beneath the islands and the western side of the forearc basin, suggesting hydrated oceanic crust. Above the slab, a shallow continental Moho of less than 30 km depth can be inferred, suggesting that the intersection of the continental mantle with the subducting slab is much shallower than the downdip limit of the seismogenic zone despite localized serpentinization being present at the toe of the mantle wedge. The outer arc islands are characterized by low Vp (4.5–5.8 km/s) and high Vp/Vs (greater than 2.0), suggesting that they consist of fluid saturated sediments. The very low rigidity of the outer forearc contributed to the slow rupture of the Mw 7.7 Mentawai tsunami earthquake on 25 October 2010.

Description: On 2012 May 20 and 29, two damaging earthquakes with magnitudes Mw 6.1 and 5.9, respectively, struck the Emilia-Romagna region in the sedimentary Po Plain, Northern Italy, causing 26 fatalities, significant damage to historical buildings and substantial impact to the economy of the region. The earthquake sequence included four more aftershocks with Mw ≥ 5.0, all at shallow depths (about 7–9 km), with similar WNW–ESE striking reverse mechanism. The timeline of the sequence suggests significant static stress interaction between the largest events. We perform here a detailed source inversion, first adopting a point source approximation and considering pure double couple and full moment tensor source models. We compare different extended source inversion approaches for the two largest events, and find that the rupture occurred in both cases along a subhorizontal plane, dipping towards SSW. Directivity is well detected for the May 20 main shock, indicating that the rupture propagated unilaterally towards SE. Based on the focal mechanism solution, we further estimate the co-seismic static stress change induced by the May 20 event. By using the rate-and-state model and a Poissonian earthquake occurrence, we infer that the second largest event of May 29 was induced with a probability in the range 0.2–0.4. This suggests that the segment of fault was already prone to rupture. Finally, we estimate peak ground accelerations for the two main events as occurred separately or simultaneously. For the scenario involving hypothetical rupture areas of both main events, we estimate Mw = 6.3 and an increase of ground acceleration by 50 per cent. The approach we propose may help to quantify rapidly which regions are invested by a significant increase of the hazard, bearing the potential for large aftershocks or even a second main shock.

Description: In the framework of the Dead Sea Integrated Research project (DESIRE), 59 seismological stations were deployed in the region of the Dead Sea Basin. Twenty of these stations recorded data of sufficiently high quality between May and September 2007 to be used for ambient seismic noise analysis. Empirical Green’s functions are extracted from cross-correlations of long term recordings. These functions are dominated by Rayleigh waves, whose group velocities can be measured in the frequency range from 0.1 to 0.5 Hz. Analysis of positive and negative correlation lags of the Green’s functions makes it possible to identify the direction of the source of the incoming energy. Signals with frequencies higher than 0.2 Hz originate from the Mediterranean Sea, while low frequencies arrive from the direction of the Red Sea. Travel times of the extracted Rayleigh waves were measured between station pairs for different frequencies, and tomographically inverted to provide independent velocity models. Four such 2D models were computed for a set of frequencies, all corresponding to different sampling depths, and thus together giving an indication of the velocity variations in 3D extending to a depth of 10 km. The results show low velocities in the Dead Sea Basin, consistent with previous studies suggesting up to 8 km of recent sedimentary infill in the Basin. The complex structure of the western margin of the Basin is also observed, with sedimentary infill present to depths not exceeding 5 km west of the southern part of the Dead Sea. The high velocities associated with the Lisan salt diapir are also observed down to a depth of ~5 km. The reliability of the results is confirmed by checkerboard recovery tests.

Description: The Sumatra-Andaman earthquake with a magnitude of 9.3, and the subsequent destructive tsunami which caused more than 225 000 fatalities in the region of the Indian Ocean, happened on 26 December 2004. Less than one month later, the United Nations (UN) World Conference on Disaster Reduction took place in Kobe, Japan to commemorate the 1995 Kobe earthquake. The importance of preparedness and awareness on regional, national and community levels with respect to natural disasters was discussed during this meeting, and resulted in the approval of the Hyogo Declaration on Disaster Reduction. Based on this declaration the UN mandated the Intergovernmental Oceanographic Commission (IOC) of UNESCO (United Nations Education, Science and Cultural Organization), taking note of its over 40 years of successful coordination of the Pacific Tsunami Warning System (PTWC), to take on the international coordination of national early-warning efforts for the Indian Ocean and to guide the process of setting up a Regional Tsunami Early Warning System for the Indian Ocean.

Description: Results obtained from S and P receiver functions produced a clear image of the top and bottom of the subducting Nazca lithosphere beneath northern Chile. Using data from the teleseismic events recorded at 15 permanent Integrated Plate Boundary Observatory Chile (IPOC) stations, we obtained new constraints on the geometry and thickness of the descending Nazca lithosphere. We observed the subducted crust of the Nazca plate at depths ranging from 50 km beneath the Coastal Cordillera down to 110 km beneath the Western Cordillera. We found significant along‐strike variations in the geometry of the Nazca plate beneath northern Chile. On closer inspection, it appears that the oceanic Nazca plate is divided into two distinct segments as it descends beneath the continental South American plate. The transition from the relatively steeper (∼23°) and deeper slab to the north of 21°S to the flatter southern segment (∼19°) is shown reasonably clearly by our data. This feature could well be associated with variations in the curvature of the plate margin and the geometry of the Chile trench, which is mainly curved to the north of 21°S. We have also mapped the continental Moho of the South American plate at depths ranging between 60 and 70 km to the east of the Longitudinal Valley. Beneath the Coastal Cordillera, this boundary becomes invisible, probably due to the serpentinization of the forearc mantle wedge that reduces the velocity in the uppermost mantle. The base of the subducted Nazca plate was clearly identified as a sharp boundary in the results obtained from the P and S receiver functions. The thickness of the subducted oceanic Nazca plate, which has an age of ∼50 My, is estimated to be ∼50 km. Although this thickness is consistent with that predicted by thermal gradients, the explanation of the sharpness of the lithosphere‐asthenosphere boundary may require another mechanism such as hydration or melting.

Description: An early detection of the presence of rupture directivity plays a major role in the correct estimation of ground motions and risks associated to the earthquake occurrence. We present here a simple method for a fast detection of rupture directivity, which may be additionally used to discriminate fault and auxiliary planes and have first estimations of important kinematic source parameters, such as rupture length and rupture time. Our method is based on the inversion of amplitude spectra from P-wave seismograms to derive the apparent duration at each station and on the successive modelling of its azimuthal behaviour. Synthetic waveforms are built assuming a spatial point source approximation, and the finite apparent duration of the spatial point source is interpreted in terms of rupture directivity. Since synthetic seismograms for a point source are calculated very quickly, the presence of directivity may be detected within few seconds, once a focal mechanism has been derived. The method is here first tested using synthetic datasets, both for linear and planar sources, and then successfully applied to recent Mw 6.2–6.8 shallow earthquakes in Peloponnese, Greece. The method is suitable for automated application and may be used to improve kinematic waveform modelling approaches.

Description: Multibeam bathymetry revealed the occurrence of numerous craterlike depressions, so-called pockmarks, on the sea floor of the Hammerfest Basin and the Loppa High, south-western Barents Sea. To investigate whether these pockmarks are related to ongoing gas seepage, microbial processes associated with methane metabolism were analyzed using geochemical, biogeochemical and microbiological techniques. Gravity cores were collected along transects crossing individual pockmarks, allowing a direct comparison between different locations inside (assumed activity center), on the rim, and outside of a pockmark (reference sites). Concentrations of hydrocarbons in the sediment, particularly methane, were measured as headspace (free) gas, and in the occluded and adsorbed gas fraction. Down to a depth of 2.6 m below sea floor (mbsf) sulfate reduction rates were quantified by radiotracer incubations. Concentrations of dissolved sulfate in the porewater were determined as well. Neither the sulfate profiles nor the gas measurements show any evidence of microbial activity or active fluid venting. Methane concentrations and sulfate reduction rates were extremely low or even below the detection limit. The results show that the observed sediment structures are most likely paleo-pockmarks, their formation probably occurred during the last deglaciation.

Description: On 2001 May 7, following unintentional water injection, a moderate size induced earthquake struck the Ekofisk oil field, North Sea. Despite of its relatively moderate magnitude, clear low-frequency waveforms could be recorded up to more than 2000 km epicentral distance, suggesting a slow rupture at very shallow depth and wave propagation through low-velocity shallow structures. The event poses a rare opportunity to constrain rupture velocity, duration and rise time of a superficial M 〉 4 event occurring on a horizontal plane in soft, water-saturated sediments. Two previous studies discussed the earthquake point source finding vertical dip-slip focal mechanisms with opposite senses of P and T axes. A further investigation was thus required to provide a basis for a deeper discussion of the failure dynamics. We significantly improve the used data set, test different earth models and derive a point source as well as a kinematic rupture model. We carefully discuss parameter uncertainties and effects related to shallow sources and wave propagation through different crustal structures to resolve the previous controversy. We additionally provide a kinematic rupture model, based on apparent source times derived from Rayleigh and Love waves. The waveforms resolve a predominant unilateral rupture along a horizontal plane at about 2 km depth. We derive an unusually slow rupture, consequence of a slow rupture velocity of about 500 m s –1 and a long rise time of about 7 s. An independent modelling of GPS- based static displacements allows to confirm the focal mechanism polarity and to locate the centroid at the eastern side of the field, resulting in a much larger seismic moment in comparison with dynamic seismic moment. The rupture directivity is confirmed by the relative location of the centroid with respect to the epicentre, which is set at the site of water injection.

Description: The Dead Sea Transform (DST) is a major left-lateral strike-slip fault that accommodates the relative motion between the African and Arabian plates, connecting a region of extension in the Red Sea to the Taurus collision zone in Turkey over a length of about 1100 km. The Dead Sea Basin (DSB) is one of the largest basins along the DST. The DSB is a morphotectonic depression along the DST, divided into a northern and a southern sub-basin, separated by the Lisan salt diapir. We report on a receiver function study of the crust within the multidisciplinary geophysical project, DEad Sea Integrated REsearch (DESIRE), to study the crustal structure of the DSB. A temporary seismic network was operated on both sides of the DSB between 2006 October and 2008 April. The aperture of the network is approximately 60 km in the E—W direction crossing the DSB on the Lisan peninsula and about 100 km in the N—S direction. Analysis of receiver functions from the DESIRE temporary network indicates that Moho depths vary between 30 and 38 km beneath the area. These Moho depth estimates are consistent with results of near-vertical incidence and wide-angle controlled-source techniques. Receiver functions reveal an additional discontinuity in the lower crust, but only in the DSB and west of it. This leads to the conclusion that the internal crustal structure east and west of the DSB is different at the present-day. However, if the 107 km left-lateral movement along the DST is taken into account, then the region beneath the DESIRE array where no lower crustal discontinuity is observed would have lain about 18 Ma ago immediately adjacent to the region under the previous DESERT array west of the DST where no lower crustal discontinuity is recognized.

Description: The Van (Eastern Anatolia, Turkey) earthquake occurred on Sunday, October 23, 2011 with a moment magnitude of 7.2. The tectonics of this region is characterized by strike–slip faulting on the Bitlis Suture Zone, and thrusting in the Zagros fold and thrust belt. Using high-rate (1 second) GPS data from permanent GNSS stations from the CORS-TR network, co-seismic displacements of eleven stations were determined using precise point positioning during this earthquake. We used the time series of coordinate changes for fourteen CORS-TR stations, and calculated the crust movements before and after the earthquake. According to the PPP solutions computed using high frequency GPS data to determine the co-seismic motions of stations, we conclude for the Van earthquake an occurrence time of 10:41:22 (UTC). No pre-seismic horizontal movement of stations at the level more than 5 mm before the earthquake could be observed. That means that no kinematic warning or prediction before the earthquake exists. Along an east–west horizontal line north of the Van Sea with a length of about 100 km, the northern part of this line experienced extension of 0.2–1 ppm in a NW–SE direction. The southern part experienced N–S shortening of 0.5–1.5 ppm. The N–S shortening we estimated geodetically matches well with the N–S shortening and thrust focal mechanism derived independently using seismic data by the USGS. Co-seismic surface displacements derived from the GPS data are consistent with the teleseismic source model given by the USGS. The geodetic source model derived from the GPS data reproduces the same moment magnitude and centroid as the teleseismic model, but shows a higher spatial resolution of the slip distribution. We also analyzed the post-seismic surface displacements derived from the GPS data within the first two weeks after the mainshock. No reasonable slip distribution on the co-seismic fault plane could be found, indicating that the sources for the early post-seismic deformation might come from the widely scattered aftershocks.