ALBERT

Description: Battery electric vehicles (BEVs) represent a possible sustainable solution for personal urban transportation. Presently, the most limiting characteristic of BEVs is their short range, mainly because of battery technology limitations. A proper design and control of the drivetrain, aimed at reducing the power losses and thus increasing BEV range, can contribute to make the electrification of urban transportation a convenient choice. This paper presents a simulation-based comparison of the energy efficiency performance of six drivetrain architectures for BEVs. Although many different drivetrain and transmission architectures have been proposed for BEVs, no literature was found regarding BEVs equipped with infinitely variable transmissions (IVTs). The analyzed drivetrain configurations are: single- (1G) and two-speed (2G) gear drives, half toroidal (HT) and full toroidal (FT) continuously variable transmissions (CVTs), and infinitely variable transmissions (IVTs) with two different types of internal power flow (IVT-I and IVT-II). An off-line procedure for determining the most efficient control action for each drivetrain configuration is proposed, which allows selecting the optimal speed ratio for each operating condition. The energy consumption of the BEVs is simulated along the UDC (Urban Driving Cycle) and Japanese 10-15 driving cycle, with a backward facing approach. In order to achieve the lowest energy consumption, a trade-off between high transmission efficiency and flexibility in terms of allowed speed ratios is required.

Description: Energies, Vol. 10, Pages 1562: On the Energy Efficiency of Dual Clutch Transmissions and Automated Manual Transmissions Energies doi: 10.3390/en10101562 Authors: Fabio Vacca Stefano De Pinto Ahu Hartavi Karci Patrick Gruber Fabio Viotto Carlo Cavallino Jacopo Rossi Aldo Sorniotti The main benefits of dual clutch transmissions (DCTs) are: (i) a higher energy efficiency than automatic transmission systems with torque converters; and (ii) the capability to fill the torque gap during gear shifts to allow seamless longitudinal acceleration profiles. Therefore, DCTs are viable alternatives to automated manual transmissions (AMTs). For vehicles equipped with engines that can generate considerable torque, large clutch-slip energy losses occur during power-on gear shifts and, as a result, DCTs need wet clutches for effective heat dissipation. This requirement substantially reduces DCT efficiency because of the churning and ancillary power dissipations associated with the wet clutch pack. To the knowledge of the authors, this study is the first to analyse the detailed power loss contributions of a DCT with wet clutches, and their relative significance along a set of driving cycles. Based on these results, a novel hybridised AMT (HAMT) with a single dry clutch and an electric motor is proposed for the same vehicle. The HAMT architecture combines the high mechanical efficiency typical of AMTs with a single dry clutch, with the torque-fill capability and operational flexibility allowed by the electric motor. The measured efficiency maps of a case study DCT and HAMT are compared. This is then complemented by the analysis of the respective fuel consumption along the driving cycles, which is simulated with an experimentally validated vehicle model. In its internal combustion engine mode, the HAMT reduces fuel consumption by >9% with respect to the DCT.