ALBERT

Description: This study presents a high-resolution (~ 5.5 km) estimate of Surface Mass Balance (SMB) over the period 1979–2014 for the Antarctic Peninsula (AP), generated by the regional atmospheric climate model RACMO2.3 and a Firn Densification Model (FDM). RACMO2.3 is used to force the FDM, which calculates processes in the snowpack, such as meltwater percolation, refreezing and runoff. We evaluate model output with 132 in-situ SMB observations and discharge rates from 6 glacier drainage basins, and find that the model realistically simulates the strong spatial variability in precipitation, but that significant biases remain as a result of the highly complex topography of the AP. It is also clear that the observations significantly underrepresent the high-accumulation regimes. The SMB map reveals large accumulation gradients, with precipitation values above 3000 mm we yr−1 over the western AP (WAP) and below 500 mm we yr−1 on the eastern AP (EAP), not resolved by coarser data-sets such as ERA-Interim. The other SMB components are one order of magnitude smaller, with drifting snow sublimation the largest ablation term removing up to 100 mm we yr−1 of mass. Snowmelt is widespread over the AP, reaching 500 mm we yr−1 towards the northern ice shelves, but the meltwater mostly refreezes. As a result runoff fluxes are low, but still considerable (200 mm we yr−1) over the Larsen (B/C), Wilkins and George VI ice shelves. The average AP ice sheet integrated SMB, including ice shelves (an area of 4.1 × 105 km2), is estimated at 351 Gt yr−1 with an interannual variability of 58 Gt yr−1, which is dominated by precipitation (PR) (365 ± 57 Gt yr−1). The WAP (2.4 × 105 km2) SMB (276 ± 47 Gt yr−1), where PR is large (276 ± 47 Gt yr−1), dominates over the EAP (1.7 × 105 km2) SMB (75 ± 11 Gt yr−1) and PR (84 ± 11 Gt yr−1). Total sublimation is 11 ± 2 Gt yr−1 and meltwater runoff into the ocean is 4 ± 4 Gt yr−1. There are no significant trends in any of the AP SMB components, except for snowmelt that shows a significant decrease over the last 36 years (−0.36 Gt yr−2).

Description: We present Bedmap2, a new suite of gridded products describing surface elevation, ice-thickness and the seafloor and subglacial bed elevation of the Antarctic south of 60° S. We derived these products using data from a variety of sources, including many substantial surveys completed since the original Bedmap compilation (Bedmap1) in 2001. In particular, the Bedmap2 ice thickness grid is made from 25 million measurements, over two orders of magnitude more than were used in Bedmap1. In most parts of Antarctica the subglacial landscape is visible in much greater detail than was previously available and the improved coverage of data has in many areas revealed the full scale of mountain ranges, valleys, basins and troughs, only fragments of which were previously indicated in local surveys. The derived statistics for Bedmap2 show that the volume of ice contained in the Antarctic ice sheet (27 million km3) and its potential contribution to sea-level rise (58 m) are similar to those of Bedmap1, but the mean thickness of the ice sheet is 4.6 % greater, the mean depth of the bed beneath the grounded ice sheet is 72 m lower and the area of ice sheet grounded on bed below sea level is increased by 10 %. The Bedmap2 compilation highlights several areas beneath the ice sheet where the bed elevation is substantially lower than the deepest bed indicated by Bedmap1. These products, along with grids of data coverage and uncertainty, provide new opportunities for detailed modelling of the past and future evolution of the Antarctic ice sheets.

Description: The measured rise in eustatic sea level over the 20th century was dominated by mass loss from the world's mountain glaciers and ice caps, and predictions suggest that these fresh water reservoirs will remain significant into the 21st century. However, estimates of this mass transfer to the ocean are based on a limited number of observations extrapolated to represent not only regional changes but often changes across individual glaciers. Combining high resolution elevation data from contemporary laser-altimetry surveys and archived aerial photography makes it possible to measure historical changes across a glacier's entire surface. Here we present a high spatial resolution time-series for six Arctic glaciers in the Svalbard Archipelago spanning 1961 to 2005. We find increasing thinning rates before and after 1990 with elevation losses occurring most notably in the glaciers' upper reaches. In the absence of a clear meteorological driver, we recommend further investigation into a possible albedo amplification of prevailing meteorological trends to explain these higher elevation changes, which could have important consequences on the region's mass balance due to the sensitivity of its hypsometric distribution. However, the strong influence of decadal-scale variability, while explaining lower rates of mass loss reported in earlier studies, highlights that caution must be exercised when interpreting thinning rates when averaged over long periods.

Description: This study presents a high-resolution (∼  5.5 km) estimate of surface mass balance (SMB) over the period 1979–2014 for the Antarctic Peninsula (AP), generated by the regional atmospheric climate model RACMO2.3 and a firn densification model (FDM). RACMO2.3 is used to force the FDM, which calculates processes in the snowpack, such as meltwater percolation, refreezing and runoff. We evaluate model output with 132 in situ SMB observations and discharge rates from six glacier drainage basins, and find that the model realistically simulates the strong spatial variability in precipitation, but that significant biases remain as a result of the highly complex topography of the AP. It is also clear that the observations significantly underrepresent the high-accumulation regimes, complicating a full model evaluation. The SMB map reveals large accumulation gradients, with precipitation values above 3000 mm we yr−1 in the western AP (WAP) and below 500 mm we yr−1 in the eastern AP (EAP), not resolved by coarser data sets such as ERA-Interim. The average AP ice-sheet-integrated SMB, including ice shelves (an area of 4.1  ×  105 km2), is estimated at 351 Gt yr−1 with an interannual variability of 58 Gt yr−1, which is dominated by precipitation (PR) (365 ± 57 Gt yr−1). The WAP (2.4  ×  105 km2) SMB (276 ± 47 Gt yr−1), where PR is large (276 ± 47 Gt yr−1), dominates over the EAP (1.7  ×  105 km2) SMB (75 ± 11 Gt yr−1) and PR (84 ± 11 Gt yr−1). Total sublimation is 11 ± 2 Gt yr−1 and meltwater runoff into the ocean is 4 ± 4 Gt yr−1. There are no significant trends in any of the modelled AP SMB components, except for snowmelt that shows a significant decrease over the last 36 years (−0.36 Gt yr−2).

Description: Changes in the volume and extent of land ice of the Svalbard archipelago have been the subject of considerable research since their sensitivity to changes in climate was first noted. However, the measurement of these changes is often necessarily based on point or profile measurements which may not be representative if extrapolated to a whole catchment or region. Combining high-resolution elevation data from contemporary laser-altimetry surveys and archived aerial photography makes it possible to measure historical changes across a glacier's surface without the need for extrapolation. Here we present a high spatial resolution time-series for six Arctic glaciers in the Svalbard archipelago spanning 1961 to 2005. We find high variability in thinning rates between sites with prevalent elevation changes at all sites averaging −0.59 ± 0.04 m a−1 between 1961–2005. Prior to 1990, ice surface elevation was changing at an average rate of −0.52 ± 0.09 m a−1 which decreased to −0.76 ± 0.10 m a−1 after 1990. Setting the elevation changes against the glaciers' altitude distribution reveals that significant increases in thinning rates are occurring most notably in the glaciers' upper reaches. We find that these changes are coincident with a decrease in winter precipitation at the Longyearbyen meteorological station and could reflect a decrease in albedo or dynamic response to lower accumulation. Further work is required to understand fully the causes of this increase in thinning rates in the glaciers' upper reaches. If on-going and occurring elsewhere in the archipelago, these changes will have a significant effect on the region's future mass balance. Our results highlight the importance of understanding the climatological context of geodetic mass balance measurements and demonstrate the difficulty of using index glaciers to represent regional changes in areas of strong climatological gradients.

Description: We present Bedmap2, a new suite of gridded products describing surface elevation, ice-thickness and the seafloor and subglacial bed elevation of the Antarctic south of 60° S. We derived these products using data from a variety of sources, including many substantial surveys completed since the original Bedmap compilation (Bedmap1) in 2001. In particular, the Bedmap2 ice thickness grid is made from 25 million measurements, over two orders of magnitude more than were used in Bedmap1. In most parts of Antarctica the subglacial landscape is visible in much greater detail than was previously available and the improved data-coverage has in many areas revealed the full scale of mountain ranges, valleys, basins and troughs, only fragments of which were previously indicated in local surveys. The derived statistics for Bedmap2 show that the volume of ice contained in the Antarctic ice sheet (27 million km3) and its potential contribution to sea-level rise (58 m) are similar to those of Bedmap1, but the mean thickness of the ice sheet is 4.6% greater, the mean depth of the bed beneath the grounded ice sheet is 72 m lower and the area of ice sheet grounded on bed below sea level is increased by 10%. The Bedmap2 compilation highlights several areas beneath the ice sheet where the bed elevation is substantially lower than the deepest bed indicated by Bedmap1. These products, along with grids of data coverage and uncertainty, provide new opportunities for detailed modelling of the past and future evolution of the Antarctic ice sheets.

Description: Improvements in our ability to model runoff from glaciers remain an important scientific goal. This paper describes a new temperature-radiation-index glacier melt model specifically enhanced for use in High-Arctic environments, utilising high temporal and spatial resolution datasets while retaining relatively modest data requirements. The model employs several physically constrained parameters and was tuned using a lidar-derived surface elevation model of Midtre Lovénbreen, meteorological data from sites spanning ~70% of the glacier's area-altitude distribution and periodic ablation surveys during the 2005 melt season. The model explained 80% of the variance in observed ablation across the glacier, an improvement of ~40% on a simplified energy balance model (EBM), yet equivalent to the performance of a full EBM employed at the same location. Model performance was assessed further by comparing potential and measured runoff from the catchment and through application to an earlier (2004) melt season. The additive model form and consideration of a priori parameters for the Arctic locality were shown to be beneficial, with a planimetry correction eliminating systematic errors in potential runoff. Further parameterisations defining modelled incident radiation failed to yield significant improvements to model output. Our results suggest that such enhanced melt models may perform well for singular melt seasons, yet are highly sensitive to the choice of lapse rates, and their transferability to different locations and seasons may be limited. While modelling ablation requires detailed consideration of the transition between snow and ice melt, our study suggests that description of the ratio between radiative and turbulent heat fluxes may provide a useful step towards dynamic parameterisation of melt factors in temperature-index models. © 2012 John Wiley & Sons, Ltd.

Description: A high resolution surface topography Digital Elevation Model (DEM) is required to underpin studies of the complex glacier system on the Antarctic Peninsula. A complete DEM with better than 200 m pixel size and high positional and vertical accuracy would enable mapping of all significant glacial basins and provide a dataset for glacier morphology analyses. No currently available DEM meets this specification. We present a new 100-m DEM of the Antarctic Peninsula (63–70° S), based on ASTER Global Digital Elevation Model (GDEM) data. The raw GDEM products are of high-quality on the rugged terrain and coastal-regions of the Antarctic Peninsula and have good geospatial accuracy, but they also contain large errors on ice-covered terrain and we seek to minimise these artefacts. Conventional data correction techniques do not work so we have developed a method that significantly improves the dataset, smoothing the erroneous regions and hence creating a DEM with a pixel size of 100 m that will be suitable for many glaciological applications. We evaluate the new DEM using ICESat-derived elevations, and perform horizontal and vertical accuracy assessments based on GPS positions, SPOT-5 DEMs and the Landsat Image Mosaic of Antarctica (LIMA) imagery. The new DEM has a mean elevation difference of +3 m (±26 m RMSE) from ICESat, and a horizontal error of less than 2 pixels, although elevation accuracies are lower on mountain peaks and steep-sided slopes. The correction method significantly reduces errors on low relief slopes and therefore the DEM can be regarded as suitable for topographical studies such as measuring the geometry and ice flow properties of glaciers on the Antarctic Peninsula. The DEM is available for download from the NSIDC website: http://nsidc.org/data/dems/datasets.html (http://dx.doi.org/10.5060/D47P8W9D).

Description: A high resolution surface topography Digital Elevation Model (DEM) is required to underpin studies of the complex glacier system on the Antarctic Peninsula. A complete DEM with better than 200 m pixel size and high positional and vertical accuracy would enable mapping of all significant glacial basins and provide a dataset for glacier morphology analyses. No currently available DEM meets these specifications. We present a new 100-m DEM of the Antarctic Peninsula (63–70° S), based on ASTER Global Digital Elevation Model (GDEM) data. The raw GDEM products are of high-quality on the rugged terrain and coastal-regions of the Antarctic Peninsula and have good geospatial accuracy, but they also contain large errors on ice-covered terrain and we seek to minimise these artefacts. Conventional data correction techniques do not work so we have developed a method that significantly improves the dataset, smoothing the erroneous regions and hence creating a DEM with a pixel size of 100 m that will be suitable for many glaciological applications. We evaluate the new DEM using ICESat-derived elevations, and perform horizontal and vertical accuracy assessments based on GPS positions, SPOT-5 DEMs and the Landsat Image Mosaic of Antarctica (LIMA) imagery. The new DEM has a mean elevation difference of −4 m (± 25 m RMSE) from ICESat (compared to −13 m mean and ±97 m RMSE for the original ASTER GDEM), and a horizontal error of less than 2 pixels, although elevation accuracies are lower on mountain peaks and steep-sided slopes. The correction method significantly reduces errors on low relief slopes and therefore the DEM can be regarded as suitable for topographical studies such as measuring the geometry and ice flow properties of glaciers on the Antarctic Peninsula. The DEM is available for download from the NSIDC website: http://nsidc.org/data/nsidc-0516.html (doi:10.5060/D47P8W9D).