ALBERT

Description: The growth in atmospheric methane (CH4) concentrations over the past two decades has shown large variability on a timescale of many years. Prior to 1999 the globally averaged CH4 concentration was increasing at a rate of 6.0 ppb/yr, but during a stagnation period from 1999 to 2006 this growth rate slowed to 0.6 ppb/yr. Since 2007 the growth rate has again increased to 4.9 ppb/yr. These changes in growth rate are usually ascribed to variations in CH4 emissions. We have used a 3-D global chemical transport model, driven by meteorological reanalyses and variations in global mean hydroxyl (OH) concentrations derived from CH3CCl3 observations from two independent networks, to investigate these CH4 growth variations. The model shows that between 1999 and 2006, changes in the CH4 atmospheric loss contributed significantly to the suppression in global CH4 concentrations relative to the pre-1999 trend. The largest factor in this is relatively small variations in global mean OH on a timescale of a few years, with minor contributions of atmospheric transport of CH4 to its sink region and atmospheric temperature. Although changes in emissions may be important during the stagnation period, these results imply a smaller variation is required to explain the observed CH4 trends. The contribution of OH variations to the renewed CH4 growth after 2007 cannot be determined with data currently available.

Description: We present a compact and versatile cryofocusing thermodesorption unit, which we developed for quantitative analysis of halogenated trace gases in ambient air. Possible applications include aircraft-based in-situ measurements, in situ monitoring and laboratory operation for the preconcentration of analytes from flask samples. Analytes are trapped on adsorptive material cooled by a Stirling cooler to low temperatures (e.g. −80 °C) and desorbed subsequently by rapid heating of the adsorptive material (e.g. +200 °C). The setup neither involves exchange of adsorption tubes nor any further condensation or refocusation steps. No moving parts are used that would require vacuum insulation. This allows a simple and robust single stage design. Reliable operation is ensured by the Stirling cooler, which does not require refilling of a liquid refrigerant while allowing significantly lower adsorption temperatures compared to commonly used Peltier elements. We use gas chromatography mass spectrometry for separation and detection of the preconcentrated analytes after splitless injection. A substance boiling point range of approximately −80 °C to +150 °C and a substance mixing ratio range of less than 1 ppt (pmol mol−1) to more than 500 ppt in preconcentrated sample volumes of 0.1 to 10 L of ambient air is covered, depending on the application and its analytical demands. We present the instrumental design of the preconcentration unit and demonstrate capabilities and performance through the examination of injection quality, analyte breakthrough and analyte residues in blank tests. Application examples are given by the analysis of flask samples collected at Mace Head Atmospheric Research Station in Ireland using our laboratory GC TOFMS instrument and by data obtained during a research flight with our in-situ aircraft instrument GhOST MS.

Description: Atmospheric greenhouse gas (GHG) concentrations are at unprecedented, record-high levels compared to the last 800 000 years. Those elevated GHG concentrations warm the planet and – partially offset by net cooling effects by aerosols – are largely responsible for the observed warming over the past 150 years. An accurate representation of GHG concentrations is hence important to understand and model recent climate change. So far, community efforts to create composite datasets of GHG concentrations with seasonal and latitudinal information have focused on marine boundary layer conditions and recent trends since the 1980s. Here, we provide consolidated datasets of historical atmospheric concentrations (mole fractions) of 43 GHGs to be used in the Climate Model Intercomparison Project – Phase 6 (CMIP6) experiments. The presented datasets are based on AGAGE and NOAA networks, firn and ice core data, and archived air data, and a large set of published studies. In contrast to previous intercomparisons, the new datasets are latitudinally resolved and include seasonality. We focus on the period 1850–2014 for historical CMIP6 runs, but data are also provided for the last 2000 years. We provide consolidated datasets in various spatiotemporal resolutions for carbon dioxide (CO2), methane (CH4) and nitrous oxide (N2O), as well as 40 other GHGs, namely 17 ozone-depleting substances, 11 hydrofluorocarbons (HFCs), 9 perfluorocarbons (PFCs), sulfur hexafluoride (SF6), nitrogen trifluoride (NF3) and sulfuryl fluoride (SO2F2). In addition, we provide three equivalence species that aggregate concentrations of GHGs other than CO2, CH4 and N2O, weighted by their radiative forcing efficiencies. For the year 1850, which is used for pre-industrial control runs, we estimate annual global-mean surface concentrations of CO2 at 284.3 ppm, CH4 at 808.2 ppb and N2O at 273.0 ppb. The data are available at https://esgf-node.llnl.gov/search/input4mips/ and http://www.climatecollege.unimelb.edu.au/cmip6. While the minimum CMIP6 recommendation is to use the global- and annual-mean time series, modelling groups can also choose our monthly and latitudinally resolved concentrations, which imply a stronger radiative forcing in the Northern Hemisphere winter (due to the latitudinal gradient and seasonality).