Publication Date:
2019-06-28
Description:
This report presents the results of an investigation to determine the behavior of dural strip with flanged holes in the center when subjected to shear stresses. They buckle under a certain load just as a flat sheet. There is one optimum hole spacing and a corresponding buckling load in shear for each sheet width, sheet thickness, and flange form. Comparison with non-flanged sheets revealed a marked increase of buckling load in shear due to the flanging and a slightly greater displacement. Strips were clamped between two stationary end rails and one sliding center rail at which the shear is applied. The force was measured with a tension stirrup up to 20 tons and a compression dynamometer up to 10 tons. The displacement was recorded with the Zeiss dial gauge. The following were investigated: 1) effect of strip width; 2) strip thickness; 3) diameter of flanging; 4) depth of flanging; 5) and hole distance.
Type:
NACA-TM-756
Format:
application/pdf
