ISSN:
0032-3888
Schlagwort(e):
Chemistry
;
Chemical Engineering
Quelle:
Wiley InterScience Backfile Collection 1832-2000
Thema:
Chemie und Pharmazie
,
Maschinenbau
,
Physik
Notizen:
Rockwell hardness measurement at an elevated temperature has been proposed as an evaluation method for the curing characteristics of thermosetting molding compounds. This method is convenient and has a high accuracy over a wide range of curing, Using a cone indenter, the following advantages are brought about: a good correspondence with acetone extraction test, in showing the degree of cure of the internal part of a molding rather than that of the skin layer, and a higher sensitivity in measuring higher degrees of cure. On examining curing behavior of commercial phenolic molding compounds by this method, an inflection point was observed on a plot of the hardness vs log curing time. This critical point has been called “the minimum cure time”, beyond which the molding exhibits good physical properties.
Zusätzliches Material:
18 Ill.
Materialart:
Digitale Medien
URL:
http://dx.doi.org/10.1002/pen.760200905
