ALBERT

Description: From October to December in 1996, Sites 1039 through 1043 were drilled on the lower continental slope and the bottom of the Middle American Trench. Planktonic foraminifers were obtained from 377 samples of the total 487 examined. The Pliocene- to Pleistocene-age sediments of Sites 1039 and 1043 are continuous from Zones N19 through N23. At Sites 1039 and 1040, middle Miocene sediments are also continuous, encompassing Zones N8 through N12. The sequences of the upper part of Sites 1040, 1041, 1042, and 1043 are décollements, tentatively assignable to Zone N19 for Sites 1040, 1041, and 1042 and to Zone N22 for Site 1043. The oldest sediments of these sites are assigned to Zone N7 (latest early Miocene), ~17 Ma in age.

Description: The following data paper summarizes diatom biostratigraphic data from sediments drilled in the Costa Rica accretionary wedge during Ocean Drilling Program Leg 170. Quaternary through lower Miocene diatom zones characteristic of the equatorial Pacific region are recognized in the reference section, Site 1039, which was drilled on the downgoing Cocos plate. At Sites 1040-1043, where the recovered silty clay units are primarily wedge and apron sediments that overlie the underthrust sections, diatoms are generally low in abundance, and complete zonation of the cores was not possible above the décollement surface.

Description: Three Pleistocene, five Pliocene, and thirteen late and middle Miocene calcareous nannofossil datums have been identified in the Leg 170 cored sequences collected from a transect across the Middle America Trench off the Nicoya Peninsula. Although some nannofossil zones could not be delineated, particularly in the Pliocene and upper Miocene, there appears to be a complete or very nearly complete Pleistocene through lower Miocene section at Sites 1039 and 1040. The oldest assemblages, observed at Site 1039 and 1040, are latest early Miocene in age (nannofossil Zone NN4). These assemblages are associated with gabbro intrusions into the basal sediments (one contact metamorphic hornfels sample contains relict nannofossils), indicating an age for the intrusion event of between 15.6 and 18.2 Ma at both Sites 1039 and 1040. Reference Site 1039, located on the Cocos plate, provides the best-preserved sequence of sediments of late Pleistocene to latest early Miocene age. The sediments cored in the prism sections at Sites 1040, 1041, 1042, and 1043 all indicate that the age of nannofossil assemblages in the prism sediments, including the toe, wedge, and apron, are all Pleistocene with a considerable amount of upper Miocene reworking. A period of low sediment accumulation rates (~5.3 m/m.y.) is recorded for Pliocene and upper Miocene sediments at Sites 1039, 1040, and 1043. Pliocene calcareous nannofossil assemblages characteristic of the ~2.5- to 3.75-m.y. time interval (nannofossil Zones NN16 and equivalent nannofossil Subzones CN12b and CN12a) were not resolved at any site. Nannofossil Zones NN15, NN14, NN13, and NN12 (early late Pliocene to early Pliocene) could not be resolved at any site either because of the absence of marker species. Within the Miocene at Sites 1039 and 1040, nannofossil Zones NN10-NN6 were difficult to differentiate because of the absence of several species that define the zonal boundaries. These intervals, where the nannofossil zones have not been resolved or are partially resolved, are primarily composed of carbonate ooze deposited during an ~8.5-m.y. (2.5-11 Ma) low sediment accumulation rate time interval. The absence of many of the marker species is attributed to warmer water conditions during those periods. Many of the same marker species are absent in the sediments recovered from nearby Deep Sea Drilling Project Site 155 in the Panama Basin.

Description: Data were presented to compare pore fluids from Sites 1037 and 1038 in the Escanaba Trough, Gorda Ridge. Site 1037 constitutes the reference site, and Site 1038 is the hydrothermally affected site. The program was undertaken for two purposes: (1) to make a detailed analysis of the halide chemistry of these two sites, with the specific aim of discerning any potential differences in the generation of dissolved halides as a result of sediment diagenesis in these drill sites and (2) to investigate the geochemistry of Ba2+ and Mn2+ at these two sites to discover potential hydrothermal effects reflected in the concentration-depth distributions of these elements.

Description: Massive sulfide samples from the Bent Hill area were analyzed for 230Th/234U and 231Pa/235U disequilibria. Apparent ages calculated from these ratios are between 8.2 and 〉300 ka. Concordant ages were found for only three samples that originate near the surface from the clastic sulfide zone and suggest "true" ages of between 8.5 and 16.0 ka (mean of 230Th and 231Pa ages). The uranium vs. depth distribution in the Bent Hill Massive Sulfide deposit suggests an open system for uranium for the deeper part of the deposit, which was probably caused by extensive recrystallization processes inhibiting true age determinations.

Description: Phospholipid fatty acids were measured in samples of 60°-130°C sediment taken from three holes at Site 1036 (Ocean Drilling Program Leg 169) to determine microbial community structure and possible community replacement at high temperatures. Five of six samples had similar concentrations of phospholipid fatty acids (2-6 pmol/g dry weight of sediment), and biomass estimates from these measurements compare favorably with direct microscopic counts, lending support to previous microscopic measures of deep sedimentary biomass. Very long-chain phospholipid fatty acids (21 to 30 carbons) were detected in the sediment and were up to half the total phospholipid fatty acid measured; they appear to increase in abundance with temperature, but their significance is not known. Community composition from lipid analysis showed that samples contained standard eubacterial membrane lipids but no detectable archaeal lipids, though archaea would be expected to dominate the samples at high temperatures. Cluster analysis of Middle Valley phospholipid fatty acid compositions shows that lipids in Middle Valley sediment samples are similar to each other at all temperatures, with the exception of very long-chain fatty acids. The data neither support nor deny a shift to a high-temperature microbial community in hot cores, so at the present time we cannot draw conclusions about whether the microbes observed in these hot sediments are active.

Description: Sulfide mineral major and trace element analyses were performed on more than 50 polished slabs representing mineralization from three seafloor hydrothermal massive sulfide deposits. Samples from the Bent Hill and ODP Mound massive sulfide deposits, both on the Juan de Fuca Ridge, can be contrasted with samples from the Trans-Atlantic Geotraverse (TAG) hydrothermal mound on the Mid-Atlantic Ridge. The massive sulfide at Bent Hill is predominantly pyrite and pyrrhotite, with increasing amounts of copper-bearing sulfide minerals at the base of the massive sulfide body and through the stockwork to an interval 200 m below seafloor that hosts high copper mineralization (Deep Copper Zone). ODP Mound contains much more abundant sphalerite and copper-bearing sulfides as compared to either Bent Hill or TAG, which are predominantly pyrite with much less abundant chalcopyrite. Copper-bearing sulfides from the Deep Copper Zone beneath Bent Hill and the lowest sampled interval of ODP Mound are petrographically and chemically similar, but distinct from copper-bearing minerals higher in either sequence.

Description: The results of 72 index properties analyses and 29 high-pressure velocity experiments on samples of sediment, basalt, and sulfide rocks recovered during Leg 169 of the Ocean Drilling Program are presented. The large sample set was subjected to shore-based index properties measurements from which wet bulk densities (b), grain densities (g), and porosities were calculated. The majority of samples are from Sites 856 and 1035 in the Bent Hill area of Middle Valley, part of the northern Juan de Fuca Ridge. Four basalts are from Holes 1037B and 1038I drilled in the Escanaba Trough of the Gorda Ridge. Reentry drilling of Hole 856H below 93.8 meters below seafloor (mbsf) resulted in penetration of a complete Bent Hill Massive Sulfide (BHMS) area reference section below the massive sulfide deposit drilled during Leg 139. Physical properties samples were obtained from the underlying sulfide feeder zone section of mineralized sediments (Unit VI), a deeper interbedded hemipelagic and turbiditic sediment interval (Unit II), the intercalated sills and sediment of "hydrothermal basement" (Unit VII), and the basaltic flows of interpreted oceanic basement (Unit VIII). Elevated-pressure velocity measurements of sediments from Units II and VI, sediment interbeds of Unit VII, and basalts of Unit VIII were made for the first time. The presence of sulfide minerals as disseminations, blebs, and vein infillings affects the velocity and density signatures of sediment samples from cores in the vicinity of the BHMS (Site 1035). Densities, velocities, and porosities of massive sulfides (Unit V; Holes 1035F and 1035H) and basaltic sills (Hole 856H) are comparable to Leg 139 data for sulfides from 0.0 to 93.8 mbsf in Hole 856H and Hole 857D sills.

Description: Permeability, electrical resistivity, and thermal conductivity measurements were performed on samples from the Bent Hill area of the Middle Valley on the northern Juan de Fuca Ridge. Thermal conductivity measurements were also made on samples from the Trans-Atlantic Geotraverse (TAG) hydrothermal area in the Mid-Atlantic Ridge for direct comparison with previous studies and the Middle Valley results. Electrical resistivity and permeability measurements were made as a function of confining pressure on 15 samples comprising different lithologic compositions found in the Bent Hill area. The effect of pressure on electrical resistivity values is relatively small and the observed frequency dependence is highly controlled by the sulfide content in these rocks. Permeabilities are in the 10**-16 to 10**-20 m**2 (0.1-100 µD) range. Although permeability does not recover in samples that undergo significant permanent deformation, the elastic permeability dependence on confining pressure is relatively small. Permeability correlates with porosity. Permeability anisotropy correlates with the presence of oriented sulfide veins with increased flow parallel to the veins. Thermal conductivity measurements made on 41 samples from Middle Valley and 9 samples from the TAG area show systematic variations due to changes in composition and a weak relationship with porosity for sedimentary samples from Middle Valley. A comparison between the divided-bar and the half-space needle-probe methods of measuring thermal conductivity shows good agreement for the Leg 169 measurements unlike previous results from Legs 139 and 158. The discrepancies observed in earlier studies seem to be related to the long times used in the older measurements for the optimal T vs. ln(t) data interval. The apparatus used during Leg 169 was smaller, sampled a smaller volume of core, and in high conductivity material was not influenced by boundary effects.

Description: Sequences of late Pliocene to Holocene sediment lap onto juvenile igneous crust within 20 km of the Juan de Fuca Ridge in northwestern Cascadia Basin, Pacific Ocean. The detrital modes of turbidite sands do not vary significantly within or among sites drilled during Leg 168 of the Ocean Drilling Program. Average values of total quartz, total feldspar, and unstable lithic fragments are Q = 35, F = 35, and L = 30. Average values of monocrystalline quartz, plagioclase, and K-feldspar are Qm = 46, P = 49, and K = 5, and the average detrital modes of polycrystalline quartz, volcanic-rock fragments, and sedimentary-rock plus metamorphic-rock fragments are Qp = 16, Lv = 43, and Lsm = 41. Likely source areas include the Olympic Peninsula and Vancouver Island; sediment transport was focused primarily through the Strait of Juan de Fuca, Juan de Fuca Channel, Vancouver Valley, and Nitinat Valley. Relative abundance of clay minerals (〈2-µm-size fraction) fluctuate erratically with depth, stratigraphic age, and sediment type (mud vs. turbidite matrix). Mineral abundance in mud samples are 0%-35% smectite (mean = 8%), 18%-59% illite (mean = 40%), and 29%-78% chlorite + kaolinite (mean = 52%). We attribute the relatively low content of smectite to rapid mechanical weathering of polymictic source terrains, with little or no input of volcanic detritus from the Columbia River. The scatter in clay mineralogy probably was caused by converging of surface currents, turbidity currents, and near-bottom nepheloid clouds from several directions, as well as subtle changes in glacial vs. interglacial weathering products.