ISSN:
0001-1541
Schlagwort(e):
Chemistry
;
Chemical Engineering
Quelle:
Wiley InterScience Backfile Collection 1832-2000
Thema:
Chemie und Pharmazie
,
Werkstoffwissenschaften, Fertigungsverfahren, Fertigung
Notizen:
Local and average holdup and drop size distribution as function of flow rates were measured for kerosene drops and water in a countercurrent, 15-cm. I.D., 160-cm. long, spray column. The range of flow rates was 5 to 40 liters/min. of kerosene and 0 to 50 liters/min. of water. At the same pairs of flow rates of the dispersed and the continuous phases in spray columns, three modes of drop packings can be obtained. These are termed, in order of increasing average holdup and increasing regularity of flow patterns, dispersed, restrained, and dense packings. For dispersed packing, at low flow rates of the two phases, the holdup and the drop size are constant along the column. At high flow rates the drop size increases from bottom to top of the column and the holdup increases from top to bottom of the column. The range of flow rates for the operation of a spray column is extended by the use of a conical entry section (Elgin design) at the bottom of the column, by the formation of an equilibrium region in the conical section.The average holdup increases with increased flow rates of both phases for dispersed and restrained packings, and with decreased flow rates of both phases for dense packing.The best definitions of flooding in a spray column are either the point of maximum average specific area of the drops, which corresponds to the onset of coalescence in the column, or the start of rejection of drops from the column proper.
Zusätzliches Material:
7 Ill.
Materialart:
Digitale Medien
URL:
http://dx.doi.org/10.1002/aic.690130311
Permalink
