ALBERT

Description: Comparison of rates of accumulation of organic carbon in surface marine sediments from the central North Pacific, the continental margins off northwest Africa, northwest and southwest America, the Argentine Basin, and the western Baltic Sea with primary production rates suggests that the fraction of primary produced organic carbon preserved in the sediments is universally related to the bulk sedimentation rate. Accordingly, less than 0.01% of the primary production becomes fossilized in slowly accumulating pelagic sediments [(2 to 6 mm (1000 y)**-1] of the Central Pacific, 0.1 to 2% in moderately rapidly accumulating [2 to 13 cm (1000 y)**-1] hemipelagic sediments off northwest Africa, northwest America (Oregon) and southeast America (Argentina), and 11 to 18% in rapidly accumulating [66 to 140 cm (1000 y)**-1] hemipelagic sediments off southwest America (Peru) and in the Baltic Sea. The emiprical expression: %Org-C = (0.0030*R*S**0.30)/(ps(1-Theta)) implies that the sedimentary organic carbon content (% Org-C) doubles with each 10-fold increase in sedimentation rate (S), assuming that other factors remain constant; i.e., primary production (R), porosity and sediment density (ps). This expression also predicts the sedimentary organic carbon content from the primary production rate, sedimentation rate, dry density of solids, and their porosity; it may be used to estimate paleoproductivity as well. Applying this relationship to a sediment core from the continental rise off northwest Africa (Spanish Sahara) suggests that productivity there during interglacial oxygen isotope stages 1 and 5 was about the same as today but was higher by a factor of 2 to 3 during glacial stages 2, 3, and 6.

Description: Accumulation rates of Mg, Al, Si, Mn, Fe, Ni, Cu, Zn, opal, and calcium carbonate have been calculated from their concentrations in samples from equatorial Deep Sea Drilling Project sites. Maps of element accumulation rates and of Q-mode factors derived from raw data indicate that the flux of trace metals to equatorial Pacific sediments has varied markedly through time and space in response to changes in the relative and absolute influence of several depositional influences: biogenic, detrital, authigenic, and hydrothermal sedimentation. Biologically derived material dominates the sediment of the equatorial Pacific. The distributions of Cu and Zn are most influenced by surface-water biological activity, but Ni, Al, Fe, and Mn are also incorporated into biological material. All of these elements have equatorial accumulation maxima similar to those of opal and calcium carbonate at times during the past 50 m.y. Detritus distributed by trade winds and equatorial surface circulation contributes Al, non-biogenic Si, Fe, and Mg to the region. Detrital sediment is most important in areas with a small supply of biogenic debris and low bulk-accumulation rates. Al accumulation generally increases toward the north and east, indicating its continental source and distribution by the northeast trade winds. Maxima in biological productivity during middle Eocene and latest Miocene to early Pliocene time and concomitant well-developed surface circulation contributed toward temporal maxima in the accumulation rates of Cu, Zn, Ni, and Al in sediments of those ages. Authigenic material is also important only where bulk-sediment accumulation rates are low. Ni, Cu, Zn, and sometimes Mn are associated with this sediment. Fe is almost entirely of hydrothermal origin. Mn is primarily hydrothermal, but some is probably scavenged from sea water by amorphous iron hydroxide floes along with other elements concentrated in hydrothermal sediments, Ni, Cu, and Zn. During the past 50 m.y. all of these elements accumulated over the East Pacific Rise at rates nearly an order of magnitude higher than those at non-rise-crest sites. In addition, factor analysis indicates that some of this material is carried substantial distances to the west of the rise crest. Accumulation rates of Fe in basal metalliferous sediments indicate that the hydrothermal activity that supplied amorphous Fe oxides to the East Pacific Rise areas was most intense during middle Eocene and late Miocene to early Pliocene time.

Description: Stable isotopic analyses of Middle Miocene to Quaternary foraminiferal calcite from east equatorial and central north Pacific DSDP cores have provided much new informatlon on the paleoceanography of the Pacific Neogene The history of delta18O change in planktonic foraminifera reflects the changing Isotopic composition and temperature of seawater at the time of test formation. Changes in the isotopic composition of benthonic foraminifera largely reflect changes m the volume of continental ice. Isotopic data from these cores indicates the following sequence of events related to continental glaciation (1) A permanent Antarctic ice sheet developed late in the Middle Miocene (about 13 to 11.5 m.y. ago) (2) The Late Miocene (about 11.5 to 5 m.y. ago) is marked by significant variation in delta18O of about 0.5‰ throughout, indicating instability of Antarctic ice cap size or bottom-water temperatures (3) The early Pliocene (5 to about 3 m.y. ago) was a time of relative stability in ice volume and bottom-water temperature (4) Growth of permanent Northern Hemisphere ice sheets is referred to have begun about 3 m.y. ago (5) The late Pliocene (3 to about 1.8 m.y. ago) is marked by one major glaciation or bottom-water cooling dated between about 2.1 to 2.3 m.y. (6) There is some evidence that the frequency of glacial-interglacial cycles increased at about 0.9 m.y. There is significant variation in delta13C at these sites but no geochemical interpretation is offered in this paper. The most outstanding feature of delta13C results is a permanent shift of about -0.8‰ found at about 6.5 m.y. in east equatorial and central north Pacific benthonic foraminifera. This benthonic carbon shift may form a useful marker in deep-sea cores recovering Late Miocene carbonates.

Description: Analyses of the total alpha radioactivity distribution in 31 North Pacific manganese nodules yield an average growth rate of 6.8 ( 2) mm /m.y. Samples from a single box core show almost identical total activity vs. depth profiles, regardless of nodule size or shape. A characteristic feature of many nodules examined is an apparent change (steepening) in slope of the alpha activity profile between depths of 0.5-1.5 mm. This feature may reflect a fundamental feature of nodule growth, possibly mobility of 230Th or its daughters in a regular way, interrupted growth, or nodule turnover. Near-surface decreases in total alpha activity probably result from 226Ra loss.

Description: The thermal structure of the Pacific Ocean between water depths of about 1 and 4.5 kilometers is estimated from the oxygen isotopic ratio of benthonic foraminifera from deep-drilled and piston cores of early Pliocene age (about 3 to 5 million years ago). The ratio of oxygen-18 to oxygen-16 in the early Pliocene at each site varies by an average of only ± 0.12 per mil (1 standard deviation). A plot of the oxygen isotopic ratio against modern bottom-water temperature is adequately fit by a line having a slope of - 0.26 per mil per degree Celsius (the equilibrium temperature dependence of calcite-water fractionation), suggesting that the temperature gradient of the Pacific Ocean during the early Pliocene was similar to that of today.