ISSN:
0032-3888
Schlagwort(e):
Chemistry
;
Chemical Engineering
Quelle:
Wiley InterScience Backfile Collection 1832-2000
Thema:
Chemie und Pharmazie
,
Maschinenbau
,
Physik
Notizen:
Experimental studies were performed with low density polyethylene, acrylonitrile-butadiene-styrene polymers and on polyvinyl chloride to elucidate the nature of the plasticating process in a reciprocating-screw injection molding machine. Melting data, obtained by use of the “cooling experiment,” and plastic temperature data reveal that the screw recharge process is a transient plasticating extrusion process which gradually approaches the equilibrium extrusion behavior as the screw rotates. If the screw rotation time is a high percentage of the total cycle time, the plasticating behavior is very similar to steady-state extrusion behavior, but if the screw rotation time is a small percentage of the total cycle time, the plasticating behavior is significantly different. Furthermore, better plasticating is obtained by use of a low RPM and high percentage rotation time than by a high RPM and low percentage rotation time.
Zusätzliches Material:
19 Ill.
Materialart:
Digitale Medien
URL:
http://dx.doi.org/10.1002/pen.760110502
Permalink