ALBERT

All Library Books, journals and Electronic Records Telegrafenberg

feed icon rss

Ihre E-Mail wurde erfolgreich gesendet. Bitte prüfen Sie Ihren Maileingang.

Leider ist ein Fehler beim E-Mail-Versand aufgetreten. Bitte versuchen Sie es erneut.

Vorgang fortführen?

Exportieren
  • 1
    Digitale Medien
    Digitale Medien
    Hoboken, NJ : Wiley-Blackwell
    AIChE Journal 34 (1988), S. 567-573 
    ISSN: 0001-1541
    Schlagwort(e): Chemistry ; Chemical Engineering
    Quelle: Wiley InterScience Backfile Collection 1832-2000
    Thema: Chemie und Pharmazie , Werkstoffwissenschaften, Fertigungsverfahren, Fertigung
    Notizen: A study was carried out of the momentum and the heat transfer to fine alumina particles injected into a DC plasma jet. Measurements are reported of particle number flux distribution, particle velocity, and inflight particle surface temperature under different operating conditions. The results show that the particle trajectories and associated particle flux distribution depends to a large extent on the particle injection velocity. The maximum particle velocity and surface temperature are noted, however, to remain close to the centerline of the jet, independent of the particle injection conditions. The maximum surface temperature reached by the particles increases with increasing plasma power and the use of an Ar/H2 plasma gas (17 vol. % H2) compared to that for a pure argon plasma.The particle velocity data are in good agreement with the predictions of a two-dimensional mathermatical model used for the calculation of the particle trajectories and temperature history. The model predictions, however, agreed only in trend with the measured particle surface temperatures. Deviations between the two could still be observed at large distances from the point of injection of the powder. The computed particle number flux distributions were narrower than the measured profiles, which can be attributed to the fact that the model did not include, at this stage, turbulent particle diffusion effects.
    Zusätzliches Material: 17 Ill.
    Materialart: Digitale Medien
    Standort Signatur Erwartet Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 2
    Digitale Medien
    Digitale Medien
    Hoboken, NJ : Wiley-Blackwell
    AIChE Journal 27 (1981), S. 358-364 
    ISSN: 0001-1541
    Schlagwort(e): Chemistry ; Chemical Engineering
    Quelle: Wiley InterScience Backfile Collection 1832-2000
    Thema: Chemie und Pharmazie , Werkstoffwissenschaften, Fertigungsverfahren, Fertigung
    Notizen: Laser Doppler Anemometry (LDA) was used for the simultaneous measurement of the gas and particle velocities in a gas-solid, two-phase flow. The flow configuration consists of an air jet at ambient temperature in which a spherical glass powder of a mean particle diameter of 97.0 or 13.7 μm was injected from one side using a secondary air jet. Both principal and secondary jets were also seeded with talcum powder with a mean particle diameter of about 1 μm which served as a tracer.The probability density distribution function (PDF) of the LDA output showed two distinct peaks corresponding to the particle and gas velocities. As the particles were accelerated by the flow, the slip velocity between the gas and the particles decreased causing the gap between these two peaks to narrow. The measured mean particle velocity profiles were in agreement with the predictions of a theoretical model.The objectives of the present investigation was to obtain experimental data on the dependence of the particle trajectories and their mean velocities on the injection conditions in a free jet stream. The principal question, however, was whether such data could be obtained using Laser Doppler Anemometry (LDA). In other words, whether LDA could be effectively used in two-phase flow systems for the simultaneous measurement of the gas and particle velocities? Obviously, the answer to this last question can affect far beyond this particular study and more than justified the effort for this detailed investigation. It should be pointed out that, while LDA has been known for sometime, and the necessary equipments for an LDA system are available on a commercial bases, relatively little attention has been given to its application to other than single-phase, fluid-flow measurements.
    Zusätzliches Material: 10 Ill.
    Materialart: Digitale Medien
    Standort Signatur Erwartet Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 3
    Digitale Medien
    Digitale Medien
    Hoboken, NJ : Wiley-Blackwell
    AIChE Journal 29 (1983), S. 236-243 
    ISSN: 0001-1541
    Schlagwort(e): Chemistry ; Chemical Engineering
    Quelle: Wiley InterScience Backfile Collection 1832-2000
    Thema: Chemie und Pharmazie , Werkstoffwissenschaften, Fertigungsverfahren, Fertigung
    Notizen: Measurements were made of the two-dimensional flow and temperature field in a d.c. plasma jet under different operating conditions. The particle velocity and the in-flight particle temperature were also measured for narrow cuts of alumina powders, of mean particle diameters of 18, 23, 39 and 46 μm, injected in the jet. The results are compared with the predictions of a one-dimensional mathematical model. The measured and computed particle velocities are in good agreement. This is, however, not the case for the particle temperature where considerable differences are observed. An attempt is made to determine the parameters which are often unduly neglected in modelling work and to identify the areas where further work is needed.
    Zusätzliches Material: 15 Ill.
    Materialart: Digitale Medien
    Standort Signatur Erwartet Verfügbarkeit
    BibTip Andere fanden auch interessant ...
Schließen ⊗
Diese Webseite nutzt Cookies und das Analyse-Tool Matomo. Weitere Informationen finden Sie hier...