ALBERT

All Library Books, journals and Electronic Records Telegrafenberg

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
Filter
  • Wiley-Blackwell
Collection
  • 1
    Electronic Resource
    Electronic Resource
    Hoboken, NJ : Wiley-Blackwell
    AIChE Journal 18 (1972), S. 928-934 
    ISSN: 0001-1541
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Process Engineering, Biotechnology, Nutrition Technology
    Notes: Mass transfer into dilute polymeric solutions was studied by using a short wetted-wall column. Oxygen was absorbed into thin films of water and aqueous polymeric solutions. The polymer systems studied included dilute solutions of carboxymethylcellulose, polyethylene oxide, Carbopol, and Cyanamer. All of the above systems were moderately non-Newtonian with power law indexes less than unity. Methocel (a Newtonian fluid with a power law index of one) was also studied. The flow of liquid films was well within the laminar flow regime.The rheological properties of these solutions as well as equilibrium solubility of oxygen in these solutions were determined. In all of the polymer systems studied except Polyox the equilibrium so ubility of oxygen decreased with an increase in polymer concentration. In Polyox solutions, however, the equilibrium solubility of oxygen increased with an increase in polymer concentration.For all of the systems investigated (including Polyox) the mass transfer coefficient for absorption of oxygen at a given flow rate decreased with an increase in polymer concentration. The mass transfer coefficient was highest for water at all flow rates.The diffusivity of oxygen in all of the systems considered except Polyox was lower than that in water. This was attributed to the increased viscosity of the polymeric solutions. The diffusivity of oxygen in Polyox solutions was higher than it was in water. This was found to be due to the complex chemical reactions which occur in this system. In all of the pseudoplastic systems studied the diffusivity of oxygen increased with increasing wall shear rate (decreasing viscosity).
    Additional Material: 8 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    Hoboken, NJ : Wiley-Blackwell
    AIChE Journal 21 (1975), S. 799-804 
    ISSN: 0001-1541
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Process Engineering, Biotechnology, Nutrition Technology
    Notes: This paper presents the development and real-time implementation of a time-optimal control algorithm for a continuous stirred-tank reactor. A multivariable time-optimal control law is derived and an Extended Kalman Filter formuated for on-line estimation and filtering. The work demonstrates the powerful capability of real-time computation and decision-making in optimal control and optimal estimation of process states.
    Additional Material: 11 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 3
    Electronic Resource
    Electronic Resource
    Hoboken, NJ : Wiley-Blackwell
    AIChE Journal 36 (1990), S. 1796-1806 
    ISSN: 0001-1541
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Process Engineering, Biotechnology, Nutrition Technology
    Notes: A combined experimental and theoretical investigation of the effect of forced feed composition cycling for CO oxidation on platinum has been performed. A novel approach to forced composition cycling was examined, in which the phase angle between the two input streams was varied. Reaction rate enhancement is shown to occur, and by varying the phasing of the feed streams it is possible to achieve a global maximum in the time-average reaction rate. This phenomenon can be explained quantitatively by a model based on an adsorbate-induced phase change of the Pt surface combined with CO adsorption self-exclusion. This mathematical model can also quantitatively describe the complex steady-state behavior (uniqueness-multiplicity transitions) observed for this reaction. The predictions of the model have been validated further through a detailed experimental study of the effects of feed flow rate, temperature, size of catalyst charge, and cycling frequency on the instantaneous and time-average conversions during forced cycling of the feed composition.
    Additional Material: 8 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 4
    Electronic Resource
    Electronic Resource
    Hoboken, NJ : Wiley-Blackwell
    AIChE Journal 15 (1969), S. 707-711 
    ISSN: 0001-1541
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Process Engineering, Biotechnology, Nutrition Technology
    Notes: Red blood cell damage and destruction are important problems in the use of artificial valves, heart-lung machines, and other devices which pump or process blood. An experimental study has been made on the mechanism of cell damage. Damage was defined by three types of observations on blood which had been subjected to trauma: (a) release of hemoglobin from cells (hemolysis), (b) morphological changes observed microscopically, and (c) red cell life span studies in rabbits using a Cr51 tagging technique.Three types of physical forces which might be injurious to red cells were studied; shearing stress (of known, constant magnitudes from a concentric cylinder viscometer), pressure variations (from studies in a static pressure cell), and direct impact of solid surfaces (from studies in a device which simulates the seating action of artificial heart valves).The study shows that high shearing stress may be primarily responsible for mechanical cell damage under certain important circumstances. There is a critical shearing stress above which cell damage increases markedly. Much of the cell damage does not appear as an immediate release of hemoglobin. Many cells undergo morphological changes and exhibit shortened average life span in vivo. The morphological changes due to shearing stress are very similar to the changes observed in patients who have hemolytic anemia associated with artificial valves.
    Additional Material: 5 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 5
    Electronic Resource
    Electronic Resource
    Hoboken, NJ : Wiley-Blackwell
    AIChE Journal 34 (1988), S. 1528-1538 
    ISSN: 0001-1541
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Process Engineering, Biotechnology, Nutrition Technology
    Notes: Monte Carlo simulations of sintering and redispersion of supported metal catalysts, based on an atomic migration mechanism, are presented. The support surface was modeled as a square grid with metal atoms located at various grid points. Interaction energies between metal atoms, and between metal atoms and support sites were specified. The probability of movement of each metal atom during one time increment (iteration) was calculated from the interaction energies. The effects of interaction energies, metal loading and initial distribution of the metal were examined. The model predictions are in good qualitative agreement with experimental observations. The model predicts “apparent” movement, splitting and coalescence of entire metal particles; these experimentally observed phenomena have usually been cited as evidence that sintering occurs by a particle migration mechanism.
    Additional Material: 15 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 6
    Electronic Resource
    Electronic Resource
    Hoboken, NJ : Wiley-Blackwell
    AIChE Journal 33 (1987), S. 792-800 
    ISSN: 0001-1541
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Process Engineering, Biotechnology, Nutrition Technology
    Notes: An experimental determination of the steady state behavior for the supported platinum catalyzed oxidation of carbon monoxide in a recycle reactor was performed. Steady state multiplicity was observed. The effects of the size of catalyst charge, feed flow rate, feed composition, and reactor temperature on the location of the boundaries of the steady state multiplicity region were determined. The sensitivity of these bifurcation points to variations in reactor parameters was used to discriminate among five reaction mechanisms. Only an elementary step model incorporating carbon monoxide self-exclusion from the catalyst surface could quantitatively describe all observed steady state data. An explicit rate function based on this model is presented.
    Additional Material: 6 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 7
    Electronic Resource
    Electronic Resource
    Hoboken, NJ : Wiley-Blackwell
    AIChE Journal 1 (1955), S. 9-19 
    ISSN: 0001-1541
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Process Engineering, Biotechnology, Nutrition Technology
    Notes: Water was vaporized into air, helium, and Freon-12 in turbulent gas flow over a wet-bulb thermometer and through a 1-ft.-diam. tower packed with 1-in. Rasching rings.The wet. and dry-bulb measurements indicate that the gas-film mass transfer coefficient varies with the Schmidt number to the  - 1/2 power for flow perpendicular to single cylinders.Heights of a transfer unit, H.T.U., were measured in the packed tower for flow of the gases countercurrent to water over a range of gas and liquid rate. H.T.U. varied as the 0.9 power of the Schmidt group. When compared at equal values of ρu2(ρ = gas density, u = velocity), H.T.U. varied as the 0.47 power of the Schmidt group. With reference to the psychrometric study, the latter method of comparison of H.T.U.'s seems preferable and indicates that further study of criteria for dimensional similitude in packed columns may be needed.
    Additional Material: 14 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 8
    Electronic Resource
    Electronic Resource
    Weinheim : Wiley-Blackwell
    Chemical Engineering & Technology - CET 12 (1989), S. 103-109 
    ISSN: 0930-7516
    Keywords: Chemistry ; Industrial Chemistry
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Process Engineering, Biotechnology, Nutrition Technology
    Notes: During the past decade, the sintering of model supported metal catalysts, i.e. catalysts consisting of metal deposited on very thin and flat oxide films, has been intensively investigated by transmission electron microscopy. In the current paper, a mathematical model, based on an atomic migration mechanism, for the sintering of these catalysts is presented. The predictions of the model, based on Monte Carlo simulations, are in very good agreement with the experimental observations, i.e. phenomena such as ‘apparent’ particle migration, splitting and neck formation between particles are predicated by the model.
    Additional Material: 3 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 9
    Electronic Resource
    Electronic Resource
    New York, NY [u.a.] : Wiley-Blackwell
    Biotechnology and Bioengineering 50 (1996), S. 169-183 
    ISSN: 0006-3592
    Keywords: liposomes ; biotin ; aggregation kinetics ; Chemistry ; Biochemistry and Biotechnology
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Biology , Process Engineering, Biotechnology, Nutrition Technology
    Notes: The aggregation of biotinylated phospholipid vesicles (liposomes) cross-linked by antibiotin IgG was studied experimentally and theoretically. The liposomes were either low density liposomes that contained 0.4 mol% biotinylated phospholipid (≈100 exposed biotin molecules per liposome), or high density liposomes that contained 2.7 mol% biotinylated phospholipid (≈1000 exposed biotin molecules per liposome). The solution turbidity and mean particle size measured by quasi-elastic light scattering (QLS) were monitored throughout the aggregation. Three different lots of antibiotin antibodies, each with different association constants and binding heterogeneities, were used. The antibody binding characteristics affected the aggregation rates. The aggregation kinetics were analyzed using a model based on the Smoluchowski theory of aggregation, fractal concepts of aggregate microstructure, and Rayleigh and Mie light scattering theory. The experimental conditions of liposome concentration, protein concentration, and ligand density under which aggregation occurred correlated well with calculated sticking probabilities based on isotherms describing the adsorption of antibiotin antibody to the liposomes. These results are compared with prior observations made when avidin was used as the cross-linking protein. © 1996 John Wiley & Sons, Inc.
    Additional Material: 11 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 10
    Electronic Resource
    Electronic Resource
    New York, NY [u.a.] : Wiley-Blackwell
    Biotechnology and Bioengineering 50 (1996), S. 151-168 
    ISSN: 0006-3592
    Keywords: avidin ; liposomes ; aggregation kinetics ; biotin ; Chemistry ; Biochemistry and Biotechnology
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Biology , Process Engineering, Biotechnology, Nutrition Technology
    Notes: The aggregation of biotin-modified phospholipid vesicles (liposomes) induced by binding the protein avidin in solution is analyzed experimentally and theoretically. Avidin has four binding sites that can recognize biotin specifically, and is able to cross-link the liposomes to form large aggregates. The aggregation kinetics were followed using quasi-elastic light scattering (QLS) to measure the mean particle size, and by measuring the solution turbidity. The rate and extent of aggregation were determined as a function of vesicle concentration, protein concentration, and the biotin density on the surface of the liposomes. A model based on Smoluchowski kinetics, fractal concepts, and Rayleigh and Mie light scattering theory was developed to analyze the experimental observations. Small aggregates (〈7800 Å diameter) may be treated as globular; however, the fractal nature of larger particles must be taken into account. Parameters in the model are taken from molecular simulations, or fit to the experimental observations. The aggregation kinetics are primarily determined by the biotin density on the liposome surface, the stoichiometric ratio of avidin molecules to liposomes, and the liposome concentration. Good agreement is found between the model and the experimental results. © 1996 John Wiley & Sons, Inc.
    Additional Material: 12 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...