ALBERT

All Library Books, journals and Electronic Records Telegrafenberg

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    ISSN: 0992-7689
    Keywords: Atmospheric composition and structure (pollution – urban and regional) ; Meteorology and atmospheric dynamics (precipitation)
    Source: Springer Online Journal Archives 1860-2000
    Topics: Geosciences , Physics
    Notes: Abstract Orographic enhancement of wet deposition arising from the ‘seeder-feeder’ effect is, by necessity, highly parametrised in long-range transport models of acid deposition that are long-term (i.e. annual average) and spatially resolved at tens of kilometres. Here, we describe a mechanistic approach to the incorporation of these mechanisms into such a model. The model formulation required the following: precipitation rate by direction and quantification of the fractions that are orographic and non-orographic; treatment of the fast oxidation of sulfur dioxide in clouds; the directionality of the seeder-feeder process; and a quantitative basis for increasing wet deposition factors to account for the seeder-feeder process. The directionality of non-orographic precipitation was determined from meteorological data at 47 sites across the UK. Orographic precipitation varies on a much finer scale than can be interpolated from measurements, and thus a modelling approach was adopted. The directionality of the seeder-feeder effect was taken from measurements. The enhancement factor of the orographic component of precipitation, assumed to represent feeder-rain, was determined from a review of measurements. Fast oxidation of sulfur dioxide is an observed phenomenon in cap-cloud, but limited in duration. An adjustment was made to the sulfur dioxide oxidation rate in the model in locations where cap-cloud was assumed to be present. The results from the model were compared with UK deposition budgets and enhanced wet deposition maps. The Revised parametrisation underestimated the UK wet deposition budgets of oxidised N and S, but spatial patterns of deposition were improved for much of the UK. It was concluded that this was a satisfactory outcome given the constraints of the statistical approach of weighting of deposition at receptors utilising straight line trajectories. The sensitivity of the model to directional constraints of seeder-feeder enhancement was tested and it was concluded that a fairly narrow constraint resulted in similar estimations to a broader one, and the broader constraint was thus adopted as frontal conditions which result in the process arrive from a fairly broad band of directions. When enhancement was allowed to occur from all directions, UK wet deposition of oxidised N and S was increased by 10%. The sensitivity to the enhancement factor on wet deposition was tested and found to be relatively robust. An increase in the enhancement factor from 2 to 6 resulted in increases in UK wet deposition of oxidised N and S of 9 and 6%, respectively.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    Springer
    Journal of industrial microbiology and biotechnology 24 (2000), S. 89-93 
    ISSN: 1476-5535
    Keywords: Keywords: α-D-glucose-1-phosphate; glucose-6-phosphate; α-1,4-D-glucan phosphorylase; phosphoglucomutase; maltooligosaccharides; Thermus caldophilus GK24
    Source: Springer Online Journal Archives 1860-2000
    Topics: Biology , Process Engineering, Biotechnology, Nutrition Technology
    Notes: For the production of α-D-glucose-1-phosphate (G-1-P), α-1,4-D-glucan phosphorylase from Thermus caldophilus GK24 was partially purified to a specific activity of 13 U mg−1 and an enzyme recovery of 15%. The amount of G-1-P reached maximum (18%) when soluble starch was used as substrate, and the smallest substrate for G-1-P formation was maltotriose. The structure of purified G-1-P was confirmed by comparison to 13C-NMR data for an authentic sample. In addition to G-1-P, glucose-6-phosphate (12%) was simultaneously produced when 10 mM maltoheptaose was used as substrate. Journal of Industrial Microbiology & Biotechnology (2000) 24, 89–93.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 3
    ISSN: 1436-2449
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 4
    ISSN: 1573-4803
    Source: Springer Online Journal Archives 1860-2000
    Topics: Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
    Notes: Abstract Rapid solidification techniques in combination with HIPing have been used to produce Ti-48Al-2Mn-2Nb and a Ti-48Al-2Mn-2Nb+15 wt% HfC composite. While the composite does contain several second phases within the γ + α2 matrix, none was identified to be HfC. The elevated-temperature properties were determined by constant velocity compression and constant load tensile testing in air between 1000 and 1173 K. Such testing indicated that the elevated temperature strengths of the HfC-modified aluminide was superior to those of the unreinforced matrix with the best 1100 K temperature slow strain rate properties for both materials being achieved after high-temperature annealing prior to testing. Examination of the microstructures after deformation in combination with the measured stress exponents and activation energies suggest that creep resistance of the HfC-modified form is due to solid-solution strengthening from carbon and hafnium rather than the presence of second phases.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 5
    Electronic Resource
    Electronic Resource
    Springer
    Water, air & soil pollution 113 (1999), S. 175-202 
    ISSN: 1573-2932
    Keywords: aerosol ; ammonia ; composition ; ozone
    Source: Springer Online Journal Archives 1860-2000
    Topics: Energy, Environment Protection, Nuclear Power Engineering
    Notes: Abstract Measurements of sulphur dioxide, ozone, ammonia, and soluble inorganic components of the atmospheric aerosol were made at a site in central southern England. Ammonia, ozone, and nitrate aerosol in winter were shown to exhibit significant diurnal variation. Ozone showed a typical diurnal variability, the magnitude of which was dependent upon wind speed. The lower night-time ozone concentrations at lower wind speeds were attributed to depletion inside nocturnal boundary layers by dry deposition. Ammonia, in contrast, showed a different behaviour, whereby the diurnal cycle was more pronounced at higher wind speeds, indicating that the cycle was unlikely to be the result of dry deposition at night. Ammonia concentrations showed a temperature dependence and the diurnal cycle of ammonia at this site appears to be the result of a temperature-driven emission signal. Of the total reduced nitrogen, NHx (NHx = NH3 + NH4 + aerosol), the phase was dominant and it is likely that more than 60% of the boundary layer NHx is in this phase. The loss term of ammonia by reaction with acid sulphate aerosol is likely to be greater than that by dry deposition on a UK scale. Nitrate aerosol showed a positive correlation with sodium aerosol, once the effect of mutual correlations with sulphate and ammonium were removed. This correlation effect, in combination with evidence of a marine-oriented directional dependence of nitrate aerosol, and negative non sea-salt chloride aerosol from the same ‘marine’ sector, shows the potential importance of the formation of sodium nitrate aerosol from reaction of dinitrogen pentoxide, or possibly nitric acid or nitrogen dioxide with sodium chloride aerosol. It is likely that this provides the major route of nitrate into rain, not the scavenging of nitric acid vapour. Aerosol sulphate, nitrate, and ammonium have been measured at Harwell since 1954. Sulphate aerosol increased up until 1976 and has declined subsequently. Nitrate aerosol has increased over the whole period, whereas ammonium aerosol follows a similar pattern to that of sulphate, but with an equivocal direction of trend after 1976. Sulphate, nitrate and ammonium aerosol all show a similar statistically significant seasonality. A historical inventory of ammonia emissions shows a clear correlation with ammonium aerosol.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 6
    Electronic Resource
    Electronic Resource
    Springer
    The environmentalist 7 (1987), S. 299-307 
    ISSN: 1573-2991
    Source: Springer Online Journal Archives 1860-2000
    Topics: Biology , Energy, Environment Protection, Nuclear Power Engineering
    Notes: Summary Studies into acid rain were first initiated in North-West England and this paper describes the establishment and operation of the Acid Rain Information Centre in Manchester. The urban monitoring surveys conducted by the Centre provide a valuable educational link with local schools. Simple testing and sampling techniques undertaken by pupils support a valuable and comprehensive, local, urban acid deposition study.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 7
    Electronic Resource
    Electronic Resource
    Springer
    Water, air & soil pollution 85 (1995), S. 25-36 
    ISSN: 1573-2932
    Source: Springer Online Journal Archives 1860-2000
    Topics: Energy, Environment Protection, Nuclear Power Engineering
    Notes: Abstract Computer assessments of the atmospheric chemistry and air quality of the past, present, and future rely in part on inventories of emissions constructed on appropriate spatial and temporal scales and with appropriate chemical species. Accurate inventories are also of substantial utility to field measurement scientists and the regulatory and policy communities. The production of global emissions inventories is the task of the Global Emissions Inventory Activity (GEIA) of the International Global Atmospheric Chemistry Project (IGAC). This paper presents a summary of recent emissions inventories from GEIA and other programs for reference year 1985, with special attention directed to emissions of the acid-related compounds CO2 (≈6.2 Pg C yr−1 anthropogenic), SOx (≈65 Tg S yr−1 anthropogenic and 15 Tg S yr−1 natural), NOx (≈21 Tg N yr−1 anthropogenic and 15–20 Tg N yr−1 natural), HCl (≈55 Tg Cl yr−1 total), and NH3 (≈45 Tg N yr−1 total). The global acid-equivalent flux of about 4.2 Teq H+yr−1 is about equally attributable to SOx and NOx emissions. For some of the acid-related species, historic inventories are available for a century or more; all show dramatic emissions increases over that period. IPCC scenario IS92a is used here as the basis for constructing global acid-related emissions estimates for selected years to 2100; among the results are that acid equivalent emissions are expected to more than double in the coming century.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 8
    Electronic Resource
    Electronic Resource
    Springer
    Acta mechanica 120 (1997), S. 127-140 
    ISSN: 1619-6937
    Source: Springer Online Journal Archives 1860-2000
    Topics: Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: Summary This paper deals with the three-dimensional analysis of the stress distribution in a plate of finite thickness containing an embedded elliptical crack subjected to a constant pressure. By using the douboe Fourier transform, the problem is reduced to the solution of the integro-differential equation which is solved iteratively. A numerical solution of the integro-differential equation is also obtained. These solutions are compared with the results in the published accounts.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 9
    Electronic Resource
    Electronic Resource
    Springer
    Zeitschrift für angewandte Mathematik und Physik 50 (1999), S. 497-508 
    ISSN: 0044-2275
    Keywords: Key words. Bending, circular cylinder, thin cavity.
    Source: Springer Online Journal Archives 1860-2000
    Topics: Mathematics , Physics
    Notes: Abstract. This paper deals with the three dimensional analysis of the stress distribution in a long circular cylinder containing a concentric very thin spherical cap cavity. The central plane of the cavity is perpendicular to the axis of the cylinder, and the cylinder is subjected to bending. The equations of the classical theory of elasticity are solved in terms of an unknown function which is then shown to be the solution of a Fredholm integral equation of the second kind. Numerical solution of the integral equation is obtained. The resultant stress intensity factors are presented in a graphical form for various proximity ratios.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 10
    Publication Date: 1994-02-01
    Print ISSN: 0022-2461
    Electronic ISSN: 1573-4803
    Topics: Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Published by Springer
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...