ISSN:
0021-8995
Keywords:
Chemistry
;
Polymer and Materials Science
Source:
Wiley InterScience Backfile Collection 1832-2000
Topics:
Chemistry and Pharmacology
,
Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
,
Physics
Notes:
The standardization of notched Izod impact test data to normalized values of foot pounds per inch of notch is based on the assumption of a 1:1 increase in breaking strength with increasing notch width. This assumed relation is not supported by experimental tests on commercial thermoplastics. As notch width was increased from 1/8 to 1/4 to 3/8 to 1/2 in., nine of ten thermoplastics tested showed a decrease in normalized impact strength. Each material appears to show a characteristic loss in breaking strengths as the notch width increases. A technique developed for calibration of pendulum impact testers has been used to examine the variation of impact breaking strength in relation to the total kinetic energy of the hammer. Experimental tests show practically no change in impact strengths up to values that take 2/3 of the available hammer energy. Experimental work on the comparison of the impulse transferred by the hammer during breaking with impulse curves photographed by the Autographic Impact test show very good agreement for catastrophic breaks and fair agreement for plastic type breaks. The reduction in recorded impulse is attributed to the degrading of the sample during the plastic portion of the breaking cycle. The peak force of thermoplastics as measured by the Autographic Impact test increases as the temperature decreases from 100°C. or above to 0°C. Over the same temperature range flexural tests on small cantilever samples of these thermoplastics show the same thermal dependence for the flexural yield or permanent distortion stress. Plots of the impact peak forces and flexural yield stress at corresponding temperatures give a linear correlation. Each thermoplastic material exhibits a unique relation for this correlation between impact yielding and flexural yielding. This correlation between the impact and flexural tests over the range of temperatures is the first known experimental indication of a direct relation between impact properties and standard physical tests.
Additional Material:
11 Ill.
Type of Medium:
Electronic Resource
URL:
http://dx.doi.org/10.1002/app.1964.070080109
Permalink
