ISSN:
1436-5073
Source:
Springer Online Journal Archives 1860-2000
Topics:
Chemistry and Pharmacology
Description / Table of Contents:
Zusammenfassung Eine Methode für die Bestimmung von Chlor und Brom in Milligramm hochhalogenierter Substanzen wird beschrieben. Die Proben werden in das Verbrennungssystem eingespritzt und in einem Sauerstoffstrom bei 1000° C über Platin und Quarz verbrannt. Die Verbrennungsgase werden in 80% Essigsäure absorbiert, die etwas Perhydrol, Salpetersäure und Quecksilberchlorid oder -bromid enthält. Das Halogen wird mit einer Quecksilber(II)-lösung titriert. Der Endpunkt wird mit Hilfe einer ionenspezifischen Elektrode ermittelt. Eine Analyse dauert etwa 15 Minuten. Die relative Standardabweichung ist ±1%. Die Reversibilität und Dauerhaftigkeit der Silbersulfidelektrode bleibt so lange unbeeinflußt, als die Konzentration der Quecksilberionen geringer ist als 10−3-m.
Abstract:
Résumé Une méthode pour le dosage du chlore ou du brome dans des échantillons milligramiques de composés organiques volatiles contenant des quantités élevées d'halogène a été décrite. Les échantillons sont introduits dans le système de combustion par injection et la combustion s'effectue sous courant d'oxygène à 1000° C sur platine et quartz. Les gaz de combustion sont absorbés dans une solution d'acide acétique 80% avec addition de faibles quantités de peroxyde d'hydrogène, acide nitrique et chlorure ou bromure mercurique. Puis l'haloide est titré avec une solution mercurique. Le point d'équivalence est établi à l'aide d'une électrode ion-spécifique. Un dosage prend approximativement 15 minutes et l'écart type est environ 1%. La réversibilité et la durabilité de l'électrode de sulphure d'argent restent intactes pourvu que la concentration mercurique ne surmonte pas celle de 10−3 M.
Notes:
Summary A method is described for the determination of chlorine and bromine in mg samples of highly halogenated volatile organic compounds. The samples are introduced into the combustion system by injection and burnt in a stream of oxygen at 1000° over platinum and quartz. The combustion gases are absorbed in a solution of 80% acetic acid containing some hydrogen peroxide, nitric acid and mercuric chloride or bromide. The halide is then titrated with mercury. The end-point is determined by an ion-specific electrode. One determination takes approximately 15 minutes. The relative standard deviation of the determination is about 1%. The reversibility and durability of the silver sulphide electrode are unaffected as long as the mercury ion concentration is less than 10−3 M.
Type of Medium:
Electronic Resource
URL:
http://dx.doi.org/10.1007/BF01219823
Permalink