ALBERT

Description: Spectral mismatch between a solar simulator and a desired spectrum can result in nearly 20 percent measurement error in the output of photovoltaic devices. This occurs when a crystalline silicon cell monitors the intensity of an unfiltered large area pulsed solar simulator (LAPSS) simulating the ASTM air mass 1.5 direct spectrum and the test device is amorphous silicon. The LAPSS spectral irradiance is modified with readily available glass UV filters to closely match either the ASTM air mass 1.5 direct or global spectrum. Measurement error is reduced to about 1 percent when using either filter if the reference cell and test device are the same general type.

Description: A series of environmental tests were completed on one type of triple junction a-Si and two types of CuInSe2 thin film solar cells. The environmental tests include electron irradiation at energies of 0.7, 1.0, and 2.0 MeV, proton irradiation at energies of 0.115, 0.24, 0.3, 0.5, 1.0, and 3.0 MeV, post-irradiation annealing at temperatures between 20 C and 60 C, long term exposure to air mass zero (AM0) photons, measurement of the cells as a function of temperature and illumination intensity, and contact pull strength tests. As expected, the cells are very resistant to electron and proton irradiation. However, when a selected cell type is exposed to low energy protons designed to penetrate to the junction region, there is evidence of more significant damage. A significant amount of recovery was observed after annealing in several of the cells. However, it is not permanent and durable, but merely a temporary restoration, later nullified with additional irradiation. Contact pull strengths measured on the triple junction a-Si cells averaged 667 grams, and pull strengths measured on the Boeing CuInSe2 cells averaged 880 grams. Significant degradation of all cell types was observed after exposure to a 580 hour photon degradation test, regardless of whether the cells had been unirradiated or irradiated (electrons or protons). Although one cell from one manufacturer lost approximately 60 percent of its power after the photon test, several other cells from this manufacturer did not degrade at all.

Description: Literature on solar array angle of incidence corrections was found to be sparse and contained no tabular data for support. This lack along with recent data on 27 GaAs/Ge 4 cm by 4 cm cells initiated the analysis presented in this paper. The literature cites seven possible contributors to angle of incidence effects: cosine, optical front surface, edge, shadowing, UV degradation, particulate soiling, and background color. Only the first three are covered in this paper due to lack of sufficient data. The cosine correction is commonly used but is not sufficient when the incident angle is large. Fresnel reflection calculations require knowledge of the index of refraction of the coverglass front surface. The absolute index of refraction for the coverglass front surface was not known nor was it measured due to lack of funds. However, a value for the index of refraction was obtained by examining how the prediction errors varied with different assumed indices and selecting the best fit to the set of measured values. Corrections using front surface Fresnel reflection along with the cosine correction give very good predictive results when compared to measured data, except there is a definite trend away from predicted values at the larger incident angles. This trend could be related to edge effects and is illustrated by a use of a box plot of the errors and by plotting the deviation of the mean against incidence angle. The trend is for larger deviations at larger incidence angles and there may be a fourth order effect involved in the trend. A chi-squared test was used to determine if the measurement errors were normally distributed. At 10 degrees the chi-squared test failed, probably due to the very small numbers involved or a bias from the measurement procedure. All other angles showed a good fit to the normal distribution with increasing goodness-of-fit as the angles increased which reinforces the very small numbers hypothesis. The contributed data only went to 65 degrees from normal which prevented any firm conclusions about extreme angle effects although a trend in the right direction was seen. Measurement errors were estimated and found to be consistent with the conclusions that were drawn. A controlled experiment using coverglasses and cells from the same lots and extending to larger incidence angles would probably lead to further insight into the subject area.

Description: This paper discusses a task the objective of which is to characterize solar cell array AC impedance and develop scaling rules for impedance characterization of large arrays by testing single solar cells and small arrays. This effort is aimed at formulating a methodology for estimating the AC impedance of the Mars Pathfinder (MPF) cruise and lander solar arrays based upon testing single cells and small solar cell arrays and to create a basis for design of a single shunt limiter for MPF power control of flight solar arrays having very different inpedances.

Description: A methodology for estimating the AC impedance of solar arrays and in particular the Mars Pathfinder (MPF) cruise and lander solar arrays is presented.

Description: A small radioisotope powered TPV system was assumed. The system was simplified into a one-dimensional model with the emitter and heat rejection system as boundaries. Design equations were then developed which would allow parametric modeling of system efficiency, emitter radiation incident upon the TPV cell, energy converted in the TPV cell, and energy absorbed in the filter and cell-to-cell gaps. A figure of merit was then developed for the emitter, filter, and TPV cell.

Description: The present Jet Propulsion Laboratory (JPL) characterization test method for a single.

Description: The present Jet Propulsion Laboratory (JPL) characterization test method for a single thermophotovoltaic (TPV) cell is to illuminate the cell with black body emission. However, this method is inadequate for the performance testing of a string or an array of cells. This is simply because the black body aperture is too small to supply sufficient illumination for much more than a single, small cell.

Description: A total of four different types of coverglass/filter combinations were tested over a 0 to 85 degree angle of incidence range. One group of cells was irradiated to provide additional data.

Description: This paper presents test results from SCARLET (Solar Concentrator Array with Refractive Linear Element Technology) experiments performed on several Lewis Research Center Lear jet flights and two JPL balloon flights. The tests were performed in support of the BMDO sponsored SCARLET II program, which is building a 2.6 kW SCARLET solar array to supply the primary power for the JPL New Millennium Deep Space 1 Mission. The experiments involve TECSTAR dual junction GaInP2/GaAs/Ge cells flown bare and under two different types of SCARLET lenses. The two types of lenses tested were a developmental design consisting of monolithic THV fluoroplastic and the current baseline flight design consisting of ceria-doped microsheet and silicone. Measured lens and total module efficiencies are presented and the flight data is compared to various solar simulator test results.