ISSN:
1573-1987
Source:
Springer Online Journal Archives 1860-2000
Topics:
Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
Notes:
Summary This paper presents experimentally measured heat transfer and friction coefficients for air and water flowing through a pipe with several types of inserts designed to induce a swirl in the flow. It was observed that inside-surface heat transfer coefficients in swirling flow can, under favourable conditions, be at least four times as large as heat transfer coefficients at the same mass flow rate in purely axial flow. At the same time the pumping power per unit rate of heat transfer can be reduced. The increase in heat transfer coefficients was found to depend on the degree of swirl and on the density or temperature gradient. However, at comparable Reynolds numbers and swirling motions the heat transfer coefficients for air were found to be smaller than the coefficients for water. The reason for this difference is not definitely known, but the phenomenon is qualitatively compatible with that causing the cooling effect in Ranque-Hilsch vortex tubes. The observed phenomena are analyzed qualitatively and it is shown that they are primarily the result of a centrifugal force which induces a radial inward motion of warmer fluid and a radial outward motion of cooler fluid. The application of vortex flow to boiling heat transfer and other high heat flux systems is discussed briefly.
Type of Medium:
Electronic Resource
URL:
http://dx.doi.org/10.1007/BF00411769
Permalink