ISSN:
1432-1181
Source:
Springer Online Journal Archives 1860-2000
Topics:
Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
,
Physics
Description / Table of Contents:
Zusammenfassung Mit einem Glattrohr und einem Hochleistungs-Rippenrohr aus Kupfer wurde der Wärmeübergang beim Blasensieden von fünf Kohlenwasserstoffen und vier Halogenkältemitteln, darunter die zwei z.Zt. noch in Erprobung befindlichen Stoffe R134a und R227, in einem großen Bereich der Wärmestromdichte und des Siededruckes gemessen. Das Rippenrohr besitzt aus dem Vollen gewalzte Rippen, die nachträglich zum Teil wieder plattgewalzt wurden und am Grund der Rippenzwischenräume zusätzlich Kerben zur Verbesserung des Wärmeübergangs enthalten (Typ: GEWA-TX). Während sich der Einfluß der Wärmestromdichte, des Siededruckes und der Stoffeigenschaften auf den Wärmeübergangskoeffizienten beim Glattrohr für alle neun Stoffe in guter Näherung einheitlich darstellen läßt, sind die entsprechenden Zusammenhänge bei den Rippenrohren wegen der besonderen Form der Blasenbildung komplexer, als von herkömmlichen Rippenrohren bekannt ist. Im Vergleich zum Glattrohr verspricht dieses Rippenrohr besonders bei nicht zu hohen Siededrücken und beim Einsatz mit Kohlenwasserstoffen und den neuen Kältemitteln R134a und R227 Vorteile.
Notes:
Abstract Heat transfer with pool boiling of five hydrocarbons and two halogenated refrigerants was measured for a plain and a high performance finned tube over an extended range of heat fluxes and saturation pressures. The finned tube with T-shaped cross sections of the fins contains additional cavities at the bottom of the channels between the fins to enhance heat transfer (type: GEWA-TX). For the plain tube, the influence of heat flux, saturation pressure and thermophysical properties of the boiling liquid can be represented in a rather uniform manner with all of the nine substances. In the case of the finned tube, the corresponding relations are more complex than is known from traditional finned tubes, because of the special form of bubble release with this tube. Compared to the plain tube, the finned tube investigated seems to be favourable when used for hydrocarbons and the new refrigerants, and for boiling conditions at comparatively low saturation pressures.
Type of Medium:
Electronic Resource
URL:
http://dx.doi.org/10.1007/BF01589999
Permalink