ALBERT

Description: Concerning the significant increase in the negative effects of flash-floods worldwide, the main goal of this research is to evaluate the power of the Analytical Hierarchy Process (AHP), fi (kNN), K-Star (KS) algorithms and their ensembles in flash-flood susceptibility mapping. To train the two stand-alone models and their ensembles, for the first stage, the areas affected in the past by torrential phenomena are identified using remote sensing techniques. Approximately 70% of these areas are used as a training data set along with 10 flash-flood predictors. It should be remarked that the remote sensing techniques play a crucial role in obtaining eight out of 10 flash-flood conditioning factors. The predictive capability of predictors is evaluated through the Information Gain Ratio (IGR) method. As expected, the slope angle results in the factor with the highest predictive capability. The application of the AHP model implies the construction of ten pair-wise comparison matrices for calculating the normalized weights of each flash-flood predictor. The computed weights are used as input data in kNN–AHP and KS–AHP ensemble models for calculating the Flash-Flood Potential Index (FFPI). The FFPI also is determined through kNN and KS stand-alone models. The performance of the models is evaluated using statistical metrics (i.e., sensitivity, specificity and accuracy) while the validation of the results is done by constructing the Receiver Operating Characteristics (ROC) Curve and Area Under Curve (AUC) values and by calculating the density of torrential pixels within FFPI classes. Overall, the best performance is obtained by the kNN–AHP ensemble model.

Description: Water is essential for irrigation, drinking and industrial purposes from global to the regional scale. The groundwater considered a significant water resource specifically in regions where the surface water is not sufficient. Therefore, the research problem is focused on district-wise sustainable groundwater management due to urbanization. The number of impervious surface areas like roofing on built-up areas, concrete and asphalt road surface were increased due to the level of urban development. Thus, these surface areas can inhibit infiltration and surface retention by the impact of urbanization because vegetation/forest areas are decreased. The present research examines the district-wise spatiotemporal groundwater storage (GWS) changes under terrestrial water storage using the global land data assimilation system-2 (GLDAS-2) catchment land surface model (CLSM) from 2000 to 2014 in West Bengal, India. The objective of the research is mainly focused on the delineation of groundwater stress zones (GWSZs) based on ten biophysical and hydrological factors according to the deficiency of groundwater storage using the analytic hierarchy process by the GIS platform. Additionally, the spatiotemporal soil moisture (surface soil moisture, root zone soil moisture, and profile soil moisture) changes for the identification of water stress areas using CLSM were studied. Finally, generated results were validated by the observed groundwater level and groundwater recharge data. The sensitivity analysis has been performed for GWSZs mapping due to the deficit of groundwater storage. Three correlation coefficient methods (Kendall, Pearson and Spearman) are applied for the interrelationship between the most significant parameters for the generation of GWSZ from sensitivity analysis. The results show that the northeastern (max: 1097.35 mm) and the southern (max: 993.22 mm) parts have high groundwater storage due to higher amount of soil moisture and forest cover compared to other parts of the state. The results also show that the maximum and minimum total annual groundwater recharge shown in Paschim Medinipore [(361,148.51 hectare-meter (ham)] and Howrah (31,510.46 ham) from 2012 to 2013. The generated outcome can create the best sustainable groundwater management practices based upon the human attitude toward risk.