ALBERT

All Library Books, journals and Electronic Records Telegrafenberg

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Electronic Resource
    Electronic Resource
    Springer
    Journal of thermal analysis and calorimetry 26 (1983), S. 263-268 
    ISSN: 1572-8943
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology
    Description / Table of Contents: Zusammenfassung Es wurde die an der Oxid-Aluminium-Grenzfläche während der Anodisierung in Schwefelsaure entwickelte Wärme gemessen. Die Temperatur steigt in der Aluminiumanode schnell an, erreicht einen konstanten Wert nach wenigen Minuten und sinkt bei Unterbrechung des Stromes abrupt ab. Der Temperaturanstieg ist proportional der Stromdichte. Auswirkungen von Konzentration und Temperatur des Elektrolyten und der Anodisierungsspannung auf die Wärmeentwicklung in Aluminium wurden untersucht. Die Ergebnisse wurden im Zusammenhang mit jener Diskussion diskutiert, die sich auf die nötigen Bedingungen der relativ grossen lokalen Dissolution auf Grund der Poren bezieht.
    Abstract: РЕжУМЕ ИжМЕРЕНА тЕплОтА ВыД ЕлЕНИь НА МЕжФАжНОИ гРАНИцЕ ОкИсь — АлУМИ НИИ ВО ВРЕМь АНОДИжАцИИ В сЕРНОИ к ИслОтЕ. тЕМпЕРАтУРА АлУМИНИЕВОгО АНОДА Б ыстРО УВЕлИЧИВАЕтсь, ДОстИгНУВ ДЕИстВИтЕ ль НОгО жНАЧЕНИь пОсл Е НЕскОлькИх МИНУт И жАтЕМ кАплИ РЕ жкО пРЕРыВАУт тОк. РОст тЕМпЕРАтУРы УВЕлИЧИВАЕтсь лИНЕИ НО с плОтНОстьУ тОкА. Иссл ЕДОВАНО ВлИьНИЕ кОНцЕНтРАцИИ, тЕМпЕР АтУРы ЁлЕктРОлИтА И А НОДНОгО НАпРьжЕНИь НА тЕплОл ОтУ ВыДЕлЕНИь В АлУМИНИИ.
    Notes: Abstract The heat developing at the oxide-aluminium interface during anodizing in sulfuric acid has been measured. The temperature of the aluminium anode increases rapidly to attain a steady value after a few minutes, and drops sharply upon current interruption. The rise in temperature increases linearly with the current density. The effects of the concentration and temperature of the electrolyte and the anodizing voltage on the heat developed in aluminium have been examined. The results are discussed with regard to the dispute concerning the conditions necessary at the base of the pores for the relatively high local dissolution.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    Weinheim [u.a.] : Wiley-Blackwell
    Materials and Corrosion/Werkstoffe und Korrosion 28 (1977), S. 26-31 
    ISSN: 0947-5117
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
    Description / Table of Contents: Besonderheiten des Verhaltens von Thioharnstoff als KorrosionsinhibitorDie Auflösung von Fe, Cu, Zn und Al in Salpeter-, Salz- und Schwefelsäure wird durch Thioharnstoff niedriger Konzentration verzögert, während bei höheren Thioharnstoffkonzentrationen mit einer Korrosionsbeschleunigung zu rechnen ist. In Salpetersäure wird der Thioharnstoff wahrscheinlich oxidiert (Wärmeentwicklung); das zunächst entstehende Dithioformamidin wird anschließend zu Diaminocarbonyldisulfid hydrolysiert, das an den kathodischen Stellen der Oberfläche zu Thiocarbaminsäure reduziert wird. Die dadurch bedingte Depolarisation führt zu beschleunigter Auflösung. In nichtoxidierenden Säuren wird zunächst eine monomolekulare Schicht Thioharnstoff am metall adsorbiert; die anschließende Reduktion zu Sulfid bzw. Hydrosulfid führt dann wieder zu einer Verstärkung der Korrosion. Die kritische Konzentration des Übergangs von Inhibierung zu Stimulierung ist abhängig von der Art der Säure und deren Konzentration.
    Notes: The dissolution of Fe, cu, Zn and Al in nitric, hydrochlorid and sulfuric acids is retarded by low concentrations of thiourea, while higher thiourea concentrations may bring about a stimulation of corrosion. In nitric acid thiourea is probably oxidised (heat evolution); the dithioformamidine formed at first is then hydrolysed to give diaminocarbonyl disulfide which again is reduced to thiocarbamic acid at the cathodic sites of the surface. The depolarisation thus produced gives rise to accelerated dissolution. In non-oxidising acids a monomolecular layer of thiourea is adsorbed at the metal at first; its subsequent reduction to sulfide and hydrogen sulfide again gives rise to an enhancement of corrosion. The critical concentration of the transition from inhibition to stimulation depends ont he type of the acid and its concentration.
    Additional Material: 8 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 3
    Electronic Resource
    Electronic Resource
    Springer
    Fresenius' Zeitschrift für analytische Chemie 336 (1990), S. 594-595 
    ISSN: 1618-2650
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 4
    Publication Date: 1990-01-01
    Print ISSN: 0937-0633
    Electronic ISSN: 1432-1130
    Topics: Chemistry and Pharmacology
    Published by Springer
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 5
    Publication Date: 2013-06-17
    Print ISSN: 1755-1307
    Electronic ISSN: 1755-1315
    Topics: Geography , Geosciences , Physics
    Published by Institute of Physics
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...