ISSN:
1436-736X
Source:
Springer Online Journal Archives 1860-2000
Topics:
Agriculture, Forestry, Horticulture, Fishery, Domestic Science, Nutrition
,
Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
Description / Table of Contents:
Picea abies ) wurden dynamische und statische Prüfungen vorgenommen. Die Proben hatten drei verschiedene Querschnitte: 38×89 mm2, 38×140 mm2 und 38×184 mm2. Anhand der vorgelegten Ergebnisse wurden auch zwei Prüfmethoden verglichen. Die Mittelwerte der dynamischen MOE-Prüfung lagen etwa 10% höher als die statisch ermittelten Werte. Die Korrelation beider MOE-Werte ist sehr streng. Beide Werte können zur Vorhersage der Festigkeit verwendet werden. Der Querschnitt und die Anwesenheit von Markanteilen beeinflussen das Ergebnis wesentlich. Je tiefer die Balken waren d.h. je näher sie der Markröhre lagen, desto geringer waren E-Modul und Biegefestigkeit. Die Gründe dafür werden teils einem Volumeneffekt zugeschrieben (im Falle der Festigkeit), teils auf das Auswahlverfahren der Stämme im Sägebetrieb zurückgeführt. Schnittholz mit Markanteil hatte allgemein. einen geringeren E-Modul und niedrigere Biegefestigkeit als Proben aus äußeren Stammbereichen; die Scherfestigkeit lag dagegen höher.
Notes:
Picea abies ) of three different cross sectional sizes: 38×89 mm2, 38×140 mm2, and 38×184 mm2. Specific material characteristics for the lumber are presented. The tests also enabled comparison between results from two testing methodologies. The mean value for the modulus of elasticity established from the dynamic tests was found to be approximately 10% higher than the corresponding value established from static tests. The statistical correlation between statically and dynamically established moduli is very strong. The dynamic E modulus was found to be as good a strength predictor as the static E modulus. Cross sectional size and the existence of the pith in the sawn lumber were found to significantly influence the material properties. In general terms, it was found that deeper beams correspond to lower values for the E modulus and for the bending strength. The reason for this tendency is believed to be a combination of a volumetric effect (in the case of strength) and a phenomenon related to the log selection and sawing process in the mills. Lumber that comprises the pith has been found to have generally lower values of the E modulus and bending strength while the shear modulus is higher, compared to lumber without pith sawn further out in the log.
Type of Medium:
Electronic Resource
URL:
http://dx.doi.org/10.1007/s001070050329
Permalink