ISSN:
1420-9136
Keywords:
Mining-induced seismicity
;
faulting models
;
peak ground parameters
Source:
Springer Online Journal Archives 1860-2000
Topics:
Geosciences
,
Physics
Notes:
Abstract Source parameter estimates based on the homogeneous and inhomogeneous source models have been examined for an anomalous sequence of seven mine-induced events located between 640 and 825 m depth at Strathcona mine, Ontario, and having magnitudes ranging betweenm N 0.8 and 2.7. The derived Brune static stress drops were found to be similar to those observed for natural earthquakes (∼30 bars), whereas dynamic stress drops were found to range up to 250–300 bars. Source radii derived from Madariaga's model better fit documented evidence of underground damage. These values of source radii were similar to those observed for the inhomogeneous model. The displacement at the source, based on the observed attenuation relationship, was about 60 mm for three magnitude 2.7 events. This is in agreement with slip values calculated using peak velocities and assuming the asperity as a Brune source within itself (72 mm). By using Madariaga's model for the asperity, the slip was over 3 times larger than observed. Peak velocity and acceleration scaling relations with magnitude were investigated by incorporating available South African data, appropriately reduced to Canadian geophysical conditions. The dynamic stress drop scaled as the square root of the seismic moment, similar to reported results in the literature for crustal earthquakes. This behavior suggests that the size of the asperities responsible for the peak ground motion, with respect to the overall source size, follow distributions that may be similar over a wide range of magnitudes. Measurements of source rupture complexity (ranging from 2 to 4) were found to agree with estimates of overall source to asperity radii, suggesting, together with the observed low rupture velocities (0.3 β to 0.6 β), that the sources were somewhat complex. Validation of source model appropriateness was achieved by direct comparison of the predicted ground motion level to observed underground damage in Creighton mine, located within the same regional stress and geological regime as Strathcona mine. Close to the source (〈100 m), corresponding to relatively higher damage levels, a good agreement was found between the predicted peak particle velocities for the inhomogeneous model and velocities derived based on established geomechanical relationships. The similarity between asperity radii and the regions of the highest observed damage provided additional support for the use of the inhomogeneous source model in the assessment of damage potential.
Type of Medium:
Electronic Resource
URL:
http://dx.doi.org/10.1007/BF00879480
Permalink
