ALBERT

Description: No abstract available

Description: Numerical and experimental investigations of both far-field and near-field supersonic steady jet interactions with a flat surface at various atmospheric pressures are presented in this paper. These studies were done in assessing the landing hazards of both the NASA Mars Science Laboratory and Phoenix Mars spacecrafts. Temporal and spatial ground pressure measurements in conjunction with numerical solutions at altitudes of approx.35 nozzle exit diameters and jet expansion ratios (e) between 0.02 and 100 are used. Data from steady nitrogen jets are compared to both pulsed jets and rocket exhaust plumes at Mach approx.5. Due to engine cycling, overpressures and the plate shock dynamics are different between pulsed and steady supersonic impinging jets. In contrast to highly over-expanded (e 〈1) and underexpanded exhaust plumes, results show that there is a relative ground pressure load maximum for moderately underexpanded (e approx.2-5) jets which demonstrate a long collimated plume shock structure. For plumes with e much 〉5 (lunar atmospheric regime), the ground pressure is minimal due to the development of a highly expansive shock structure. We show this is dependent on the stability of the plate shock, the length of the supersonic core and plume decay due to shear layer instability which are all a function of the jet expansion ratio. Asymmetry and large gradients in the spatial ground pressure profile and large transient overpressures are predominantly linked to the dynamics of the plate shock. More importantly, this study shows that thruster plumes exhausting into martian environments possess the largest surface pressure loads and can occur at high spacecraft altitudes in contrast to the jet interactions at terrestrial and lunar atmospheres. Theoretical and analytical results also show that subscale supersonic cold gas jets adequately simulate the flow field and loads due to rocket plume impingement provided important scaling parameters are in agreement. These studies indicate the critical importance of testing and modeling plume-surface interactions for descent and ascent of spacecraft and launch vehicles.

Description: We proposed to develop a new landing approach that significantly reduces development time and obviates the most complicated, most expensive, and highest-risk phase of a landing mission. The concept is a blanket- or carpet-like two-dimensional (2D) lander (~1-m 1-m surface area and 〈1-cm thick) with a low mass/drag ratio, which allows the lander to efficiently shed its approach velocity and provide a more robust structure for landing integrity. The form factor of these landers allows dozens to be stacked on a single spacecraft for transport and distributed en masse to the surface. Lander surfaces will be populated on both sides by surface-mount, low-profile sensors and instruments, surface-mount telecom, solar cells, batteries, processors, and memory. Landers will also incorporate thin flexible electronics, made possible in part by printable electronics technology. The mass and size of these highly capable technologies further reduces the required stiffness and mass of the lander structures to the point that compliant, lightweight, robust landers capable of passive landings are possible. This capability avoids the costly, complex use of rockets, radar, and associated structure and control systems. This approach is expected to provide an unprecedented science payload mass to spacecraft mass ratio of approximately 80% (estimated based on current knowledge). This compared to ~1% for Pathfinder, ~17% for MER, and 22% for MSL rovers. Clearly, one difference is rovers vs. a lower capability lander. An outcome of the Phase I study is a clear roadmap for near-term demonstration and long-term technology development.