ALBERT

All Library Books, journals and Electronic Records Telegrafenberg

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
  • 1
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Die Makromolekulare Chemie 183 (1982), S. 801-820 
    ISSN: 0025-116X
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Notes: Aromatic heterocyclic polymers are exceedingly attractive high performance materials because of their unusually high mechanical strength, chemical resistance and thermal stability, but are very difficult to process unless “swivel” atoms or groups are inserted along the chains to increase conformational flexibility. The present theoretical investigation employs the CNDO/2 method with direct geometry optimization to calculate such flexibility for the wholly aromatic swivels biphenyl, 2,2′-bipyridyl, 2-phenylpyridine, 2,2′-bipyrimidyl, and 2-phenylpyrimidine. The most important result is the prediction that both flexibility and accessibility of coplanar conformations should increase significantly with the number of ortho-CH groups replaced by N-atoms. The calculations also provide information on other conformation-dependent properties such as optimized geometries, charge distributions, and dipole moments, and these results are found to be in satisfactory agreement with the results of previous theoretical and experimental studies. Finally, since these chains are soluble only in strongly acidic media, the species mono- and diprotonated 2,2′-bipyridyl, 2,2′-bipyridyl · H3O+, and 2,2′-bipyrimidyl · 2H2O were also investigated with regard to some of these conformational characteristics.
    Additional Material: 7 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Journal of Polymer Science Part A-2: Polymer Physics 6 (1968), S. 825-831 
    ISSN: 0449-2978
    Keywords: Physics ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Notes: Extended chain crystals of polyoxymethylene were irradiated with x-rays of about 105 r./min. An immediate decrease in superheating on melting was noted. After 90 min. of irradiation the melting point level, refractive indices, and density also decreased. After 480 min. the DTA melting peak at a heating rate of 20°C./min. had decreased 25°C., the melting point decreased about 18°C., and the density calculated from refractive indices decreased 0.031 g./cm.-3. These effects are interpreted as indication of chain scission and formation of amorphous defects.
    Additional Material: 3 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 3
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Journal of Polymer Science Part A-2: Polymer Physics 4 (1966), S. 765-775 
    ISSN: 0449-2978
    Keywords: Physics ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Notes: The behavior of films of polyelectrolytes at the water-organic liquid interface depends on the nature of the interface and the pH of the substratum. The present paper investigates the influence of these two factors on the cohesive forces between monomer units. Two polyelectrolytes were studied: poly(methacrylic acid) (APM) and poly-2-vinylpyridine (2-PVP). In the case of uncharged films, the collapse pressure decreases when the polarity of the organic phase becomes more important, whereas the term ω/kT, which appears in the theory of Motomura and Matuura, increases. A quantitative relation between the parameter ω/kT and the collapse pressure may be deduced. The behavior of the ionized surface film at different pH values is modified by the choice of the interface. However, there exists a competition between two phenomena: the dissolution of ionized residues in the substratum and the electrostatic repulsion between charges in the surface plane. Depending upon whether the first or the second parameter is more important, we observed that the surface pressure decreased or increased with the degree of ionization.
    Additional Material: 6 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 4
    Electronic Resource
    Electronic Resource
    Bognor Regis [u.a.] : Wiley-Blackwell
    Journal of Polymer Science Part A: Polymer Chemistry 29 (1991), S. 1207-1212 
    ISSN: 0887-624X
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology
    Additional Material: 2 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 5
    Electronic Resource
    Electronic Resource
    Bognor Regis [u.a.] : Wiley-Blackwell
    Journal of Polymer Science Part B: Polymer Physics 34 (1996), S. 1741-1745 
    ISSN: 0887-6266
    Keywords: Liquid crystalline polymer ; permeability ; crystallinity ; annealing ; gases ; Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Notes: The copolyester formed from 40 mol% p-hydroxybenzoic acid (H), 30 mol% isophthalic acid (I), and 30 mol% hydroquinone (Q), designated as HIQ-40, forms isotropic, amorphous films when appropriately cast from a solvent. Thermal annealing leads to a mesogenic texture and some level of crystallinity. It is shown that these ordering processes lead to dramatic reductions in gas permeability; the magnitude of the decrease increases with the size of the penetrant. The current results are consistent with previously reported sorption data for acetone in HIQ-40. © 1996 John Wiley & Sons, Inc.
    Additional Material: 2 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 6
    Electronic Resource
    Electronic Resource
    Weinheim : Wiley-Blackwell
    Macromolecular Chemistry and Physics 199 (1998), S. 1013-1017 
    ISSN: 1022-1352
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Notes: By using the Lifshitz-Van der Waals-Acid-Base theory, we have determined the surface tensions (γs) of three commercially available liquid crystalline polymers (LCPs) from the measurement of contact angles on thin films. The values obtained are 43.1, 41.1 and 41.5 mJ/m2 (dyn/cm) for Vectra™ A-950, Vectra™ B-950 and Xydar™ SRT-900, respectively. Experimental data suggest that all the three LCPs are monopolar. The strength of Lewis base (tendency to donate a pair of electrons for the formation of a covalent bond) for these three LCPs is as follows: Vectra™ B-950 〉 Xydar™ SRT-900 〉 Vectra™ A-950. We also theoretically estimated γs from both parachor (Ps) and cohesive energy (Ecoh) utilizing the concept of molecular group contribution. It was found that γs's calculated from Hoftyzer & Van Krevelen and Hayes' Ecoh values are close to our experimental results obtained from contact angle measurements. This is especially true for Xydar™ SRT-900 LCP, where γs obtained from contact angle measurements is 41.5 mJ/m2, while from Hoftyzer and Van Krevelen, and Hayes it is 42.4 and 41.8 mJ/m2, respectively. However, more adequate group contributions for naphthalene and amide groups are urgently needed.
    Additional Material: 5 Tab.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 7
    Electronic Resource
    Electronic Resource
    New York, NY [u.a.] : Wiley-Blackwell
    Journal of Applied Polymer Science 53 (1994), S. 609-620 
    ISSN: 0021-8995
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: Two aromatic copoyester compositions were prepared from p-hydroxybenzoic acid, hydroquinone, and isophthalic acid with compositions 2 : 1 : 1 (HIQ50) and 1 : 1 : 1 (HIQ33). For each of these compositions, one random copolyester and one known sequence copolymer was prepared. The random compositions were prepared by melt condensation, whereas controlled sequence polymers were prepared by low-temperature solution polymerization. For the 1 : 1 : 1 composition, the controlled sequence polymer had higher crystallinity than that of the random, whereas the 2 : 1 : 1 composition random copolymer had higher crystallinity. The difference in crystallinity is attributed to the sequence distributions in the copolymers. All compositions were thermotropic in nature. © 1994 John Wiley & Sons, Inc.
    Additional Material: 10 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 8
    Electronic Resource
    Electronic Resource
    New York : Wiley-Blackwell
    Journal of Polymer Science Part A-2: Polymer Physics 8 (1970), S. 817-832 
    ISSN: 0449-2978
    Keywords: Physics ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Physics
    Notes: The surface potentials of monolayers of poly(methacrylic acid) (PMA) have been studied as a function of the pH of the subsolution. The influence of the macromolecular configuration on the properties of the ionizable groups was more particularly investigated. Orientation of molecules in the monolayer may be imposed by the stereoregularity of PMA (isotactic, atactic) and by the nature of the interface (air-water, cyclohexane-water). The results are analyzed in terms of theories of the ionic double layer (Gouy model, Donnan equilibrium) which permit the determination of the degree of ionization α of the film. The value of α gives indications about the orientation of specific groups of the macromolecular chain, i.e., of the ionized monomer units. Indeed, at the air-water interface, the film of isotactic PMA is more acid than that of the atactic sample, and at the cyclohexane-water interface, the degree of ionization is greater than at the air-water interface. These properties are the consequence of a modification of orientation of the hydrophilic groups with respect to the aqueous phase as a function of the stereoregularity of the sample and the nature of the interface. The variation of α with the pH of the substrate phase may be used to calculate an intrinsic dissociation constant Ks° of the molecules in the film. The value of Ks° is not modified by spreading conditions and remains very similar to that obtained in solution.
    Additional Material: 7 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 9
    Electronic Resource
    Electronic Resource
    New York, NY : Wiley-Blackwell
    Polymers for Advanced Technologies 2 (1991), S. 25-30 
    ISSN: 1042-7147
    Keywords: Blends ; Liquid crystalline polymers ; Thermal analysis ; Orientation ; Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
    Notes: Blends containing two, wholly aromatic, naphthalene-based liquid crystalline polymers (LCPs) are studied. Experimental results show that the viscosities of the resulting blends are lower than the parent LCPs over the entire shear-rate range investigated. The orientation development following capillary flow demonstrates, that over a defined blend composition range, some blends have higher orientability than the constituent polymers. This is further manifested in the tensile and flexural properties of injection-molded specimens. A detailed analysis indicates that in the composition range where synergistic effects are observed in orientation development as well as in mechanical properties, only one glass transition temperature is detected. This suggests that “miscibility” is desirable for obtaining maximum properties in these blend systems.
    Additional Material: 4 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 10
    Electronic Resource
    Electronic Resource
    New York, NY [u.a.] : Wiley-Blackwell
    Journal of Applied Biomaterials 5 (1994), S. 191-193 
    ISSN: 1045-4861
    Keywords: Chemistry ; Polymer and Materials Science
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Medicine , Technology
    Notes: Tissue specimens retrieved from four regions adjacent to hip implants during revision surgery were subjected to a novel treatment to make possible the quantitative separation of residual metal particulates and metal reaction products (metal ions and metal-protein complexes). The tissues were exposed to sodium hypochlorite solution that degraded and solubilized them, liberating metal reaction products and leaving behind metal wear particles, which were separated by centrifugation. Atomic absorption spectrophotometry was used to analyze the concentrations of the separated metal ions and wear particles. Co ion concentrations were 0.05 to 0.9 mM, Cr ion concentrations were 0.04 to 2.1 mM, and Ti ion concentrations were 0.30 to 0.60 mM. The weight of Co metal particles was 0.1 to 4.9 mg/100 mg tissue, of Cr metal particles 0.07 to 2.2 mg/100 mg tissue, and of Ti particles 0.09 to 5.2 mg/100 mg tissue; one black tissue sample contained 3333 mg Ti/100 mg tissue. No correlation was found between the concentrations of these two entities in the samples examined, probably due to the complex and varied processes creating them. The procedures discussed here will result in data that can help elucidate the separate contributions of metal reaction products and metal particulates to implant loosening. © 1994 John Wiley & Sons, Inc.
    Additional Material: 1 Tab.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...