ALBERT

Description: To investigate the energy, matter and reactive and non-reactive trace gas exchange between the atmosphere and a spruce forest in the German mountain region, two intensive measuring periods were conducted at the FLUXNET site DE-Bay (Waldstein-Weidenbrunnen) in September/October 2007 and June/July 2008. They were part of the project "ExchanGE processes in mountainous Regions" (EGER). Beyond a brief description of the experiment, the main focus of the paper concerns the coupling between the trunk space, the canopy and the above-canopy atmosphere. Therefore, relevant coherent structures were analyzed for different in- and above canopy layers, coupling between layers was classified according to already published procedures, and gradients and fluxes of meteorological quantities as well as concentrations of non-reactive and reactive trace compounds have been sorted along the coupling classes. Only in the case of a fully coupled system, it could be shown, that fluxes measured above the canopy are related to gradients between the canopy and the above-canopy atmosphere. Temporal changes of concentration differences between top of canopy and the forest floor, particularly those of reactive trace gases (NO, NO2, O3, and HONO) could only be interpreted on the basis of the coupling stage. Consequently, only concurrent and vertically resolved measurements of micrometeorological (turbulence) quantities and fluxes (gradients) of trace compounds will lead to a better understanding of the forest-atmosphere interaction.

Description: Immediately following the breakup of the 2005 Arctic spring stratospheric vortex, a tropical air mass, characterized by low potential vorticity (PV) and high nitrous oxide (N2O), was advected poleward and became trapped in the easterly summer polar vortex. This feature, known as a "Frozen-In Anticyclone (FrIAC)", was observed in Earth Observing System (EOS) Aura Microwave Limb Sounder (MLS) data to span the potential temperature range from ~580 to 1100 K (~25 to 40 km altitude) and to persist from late March to late August 2005. This study compares MLS N2O observations with simulations from the Global Modeling Initiative (GMI) chemistry and transport model, the GEOS-5/MERRA Replay model, and the Van Leer Icosahedral Triangular Advection (VITA) isentropic transport model to elucidate the processes involved in the lifecycle of the FrIAC, which is here divided into three distinct phases. During the "spin-up phase" (March to early April), strong poleward flow resulted in a tight isolated anticyclonic vortex at ~70–90° N, marked with elevated N2O. GMI, Replay, and VITA all reliably simulated the spin-up of the FrIAC, although the GMI and Replay peak N2O values were too low. The FrIAC became trapped in the developing summer easterly flow and circulated around the polar region during the "anticyclonic phase" (early April to the end of May). During this phase, the FrIAC crossed directly over the pole between 7 and 14 April. The VITA and Replay simulations transported the N2O anomaly intact during this crossing, in agreement with MLS, but unrealistic dispersion of the anomaly occurred in the GMI simulation due to excessive numerical mixing of the polar cap. The vortex associated with the FrIAC was apparently resistant to the weak vertical shear during the anticyclonic phase, and it thereby protected the embedded N2O anomaly from stretching. The vortex decayed in late May due to diabatic processes, leaving the N2O anomaly exposed to horizontal and vertical wind shears during the "shearing phase" (June to August). The observed lifetime of the FrIAC during this phase is consistent with timescales calculated from the ambient horizontal and vertical wind shear. Replay maintained the horizontal structure of the N2O anomaly similar to MLS well into August. Isentropic simulations using VITA also captured the horizontal structure of the FrIAC during this phase, but small-scale structures maintained by VITA are problematic and show that important mixing processes are absent from this single-level simulation.

Description: To investigate the energy, matter and reactive and non-reactive trace gas exchange between the atmosphere and a spruce forest in the German mountain region, two intensive measuring periods were conducted at the FLUXNET site Waldstein-Weidenbrunnen in September/October 2007 and June/July 2008. They were part of the project "ExchanGE processes in mountainous Regions" (EGER). Beyond a brief description of the experiment and links to the already published results of both experiments, the main focus of the paper is the problem of the coupling of the trunk space, the canopy and the atmosphere. Therefore, the relevant coherent structures were analyzed in different canopy levels and an already published coupling classification was applied to gradients and fluxes. It could be shown that fluxes above the canopy are only related to the gradient between the canopy and the atmosphere in the case of a fully coupled system. Changes in the concentration of especially reactive trace gases (NO-NO2-O3 and HONO) could only be interpreted together with the coupling stage. Finally it was pointed out that the combination of air chemical measurements with micrometeorological turbulence measurements is urgently needed to understand the biosphere-atmosphere interaction.

Description: The land and ocean absorb on average over half of the anthropogenic emissions of carbon dioxide (CO2) every year. These CO2 "sinks" are modulated by climate change and variability. Here we use a suite of nine Dynamic Global Vegetation Models (DGVMs) and four Ocean Biogeochemical General Circulation Models (OBGCMs) to quantify the global and regional climate and atmospheric CO2 – driven trends in land and oceanic CO2 exchanges with the atmosphere over the period 1990–2009, attribute these trends to underlying processes, and quantify the uncertainty and level of model agreement. The models were forced with reconstructed climate fields and observed global atmospheric CO2; Land Use and Land Cover Changes are not included for the DGVMs. Over the period 1990–2009, the DGVMs simulate a mean global land carbon sink of −2.4 ± 0.7 Pg C yr−1 with a small significant trend of −0.06 ± 0.03 Pg C yr−2 (increasing sink). Over the more limited period 1990–2004, the ocean models simulate a mean ocean sink of –2.2 ± 0.2 Pg C yr–1 with a trend in the net C uptake that is indistinguishable from zero (−0.01 ± 0.02 Pg C yr−2). The two ocean models that extended the simulations until 2009 suggest a slightly stronger, but still small trend of −0.02 ± 0.01 Pg C yr−2. Trends from land and ocean models compare favourably to the land greenness trends from remote sensing, atmospheric inversion results, and the residual land sink required to close the global carbon budget. Trends in the land sink are driven by increasing net primary production (NPP) whose statistically significant trend of 0.22 ± 0.08 Pg C yr−2 exceeds a significant trend in heterotrophic respiration of 0.16 ± 0.05 Pg C yr−2 – primarily as a consequence of wide-spread CO2 fertilisation of plant production. Most of the land-based trend in simulated net carbon uptake originates from natural ecosystems in the tropics (−0.04 ± 0.01 Pg C yr−2), with almost no trend over the northern land region, where recent warming and reduced rainfall offsets the positive impact of elevated atmospheric CO2 on carbon storage. The small uptake trend in the ocean models emerges because climate variability and change, and in particular increasing sea surface temperatures, tend to counteract the trend in ocean uptake driven by the increase in atmospheric CO2. Large uncertainty remains in the magnitude and sign of modelled carbon trends in several regions, and on the influence of land use and land cover changes on regional trends.

Description: In the face of ongoing global warming and glacier retreat, the composition and flux of organic matter in glacier–fjord systems are key variables for updating the carbon cycle and budget, whereas the role of Arctic valley glaciers seems unimportant when compared with the huge Greenland Ice Sheet. Our field observations of the glacier-fed Bayelva River, Svalbard, and the adjacent Kongsfjorden allowed us to determine the compositions of particulate organic matter from glacier to fjord and also to estimate the flux of organic carbon, both for the river and for Svalbard in general. Particulate organic carbon (POC) and dissolved organic carbon (DOC) in the Bayelva River averaged 56 and 73 μM, respectively, in August 2012. Amino acids (AAs) and phytoplankton pigments accounted for ~ 10 % of the particulate organic matter (POM) in the Bayelva River, while AAs represented 〉 90 % of particulate nitrogen in fjord surface water, suggesting the strong in situ assimilation of organic matter. Bacteria accounts for 13 and 19 % of the POC in the Bayelva River and the Kongsfjorden, respectively, while values for particulate nitrogen (PN) are much higher (i.e., 36 % in Kongsfjorden). The total discharge from the Bayelva River in 2012 was 29 × 106 m3. Furthermore, we calculated the annual POC, DOC, and PN fluxes for the river as 20 ± 1.6, 25 ± 5.6, and 4.7 ± 0.75 t, respectively. Using the POC content and DOC concentration data, we then estimated the annual POC and DOC fluxes for Svalbard glaciers. Although the estimated POC (0.056 ± 0.02 × 106 t yr−1) and DOC (0.02 ± 0.01 × 106 t yr−1) fluxes of Svalbard glaciers are small compared with those of the Greenland Ice Sheet, the area-weighted POC flux of Svalbard glaciers is twice that of the Greenland Ice Sheet, while the flux of DOC can be 4 to 7 times higher. Therefore, we propose that valley glaciers are efficient high-latitude sources of organic carbon.

Description: When a capillary bridge of a constant volume is formed between two surfaces, the shape of the liquid bridge will change as the separation between those surfaces is varied. To investigate the variable forces and Laplace pressure of the capillary bridge, as the shape the bridge evolves, a pseudo-three-dimensional force model of the capillary bridge is developed. Based on the characteristics of the slender structured surface, an efficient method is employed to directly solve the differential equations defining the shape of the capillary bridge. The spacing between the plates satisfying the liquid confined within the hydrophobic region of the structured surface is calculated. The method described in this paper can prevent meshing liquid surfaces such that, compared with Surface Evolver simulations, the computing speed is greatly improved. Finally, by comparing the results of the finite element simulations performed with Surface Evolver with those of the method employed in this paper, the practicality of the method is demonstrated.

Description: The Tibetan Plateau and nearby surrounding area (the Third Pole area) dramatically impacts the world’s environment and especially controls climatic and environmental changes in China, Asia and even in the Northern Hemisphere. Supported by the Chinese Academy of Sciences (CAS) and some international organizations, the Third Pole Environment (TPE) Programme is now under way. First, the background of the establishment of the TPE, the establishment and monitoring plans on long-term for the TPE and six comprehensive observation and study stations are introduced. Then the preliminary observational analysis results on atmosphere−land interaction are presented. The study on the regional distribution of land surface heat fluxes is of paramount importance over the heterogeneous landscape of the Third Pole area. A parameterization methodology based on satellite and in situ data is described and tested for deriving the regional surface heat fluxes (net radiation flux, soil heat flux, sensible heat flux and latent heat flux) over the heterogeneous landscape. As a case study, the methodology was applied to the whole Tibetan Plateau area. Eight images of MODIS data and four images of AVHRR data were used for the comparison among winter, spring, summer and autumn, and the annual variation analyses. The derived results were also validated by using the ‘‘ground truth’’ measured in the stations of the TPE. The results show that the derived surface heat fluxes in the four different seasons over the Tibetan Plateau area are in good agreement with the ground measurements. The results from AVHRR were also in agreement with MODIS. It is therefore concluded that the proposed methodology is successful for the retrieval of surface heat fluxes using the MODIS data, AVHRR data and in situ data over the Tibetan Plateau area.

Description: Landslide monitoring is important in predicting the behavior of landslides, thereby ensuring environmental, life, and property safety. On the basis of our previous studies, we conducted the double shear test by using a third-generation optical fiber transducer that uses expandable polystyrene (EPS) as base material. However, the third-generation transducer has poor performance when cohesive force is present between the grout and capillary stainless steel pipe of the transducer. Thus, the fourth-generation optical fiber transducer was invented. Similar to the third-generation transducer, the fourth-generation transducer also used EPS as its base material. Single shear test was conducted on the fourth-generation transducer after being grouted with cement mortar (1:1 mix ratio). The micro-bend loss mechanism of the optical fiber was considered, and the optical time domain reflectometry instrument was used. The fact that the loss sequence of optical fibers subjected to loading is different at various locations is found. The relationship of the loading-point displacement VS. optical fiber sliding distance and optical loss were measured. Results show that the maximum initial measurement precision of the newly proposed device is 1mm, the corresponding sliding distance is 21 mm, and the dynamic range is 0–20 mm. The fourth-generation transducer can measure the movement direction of loadings, thus making this transducer applicable for landslide monitoring.

Description: Landslide monitoring is important in predicting the behavior of landslides, thereby ensuring environmental, life, and property safety. On the basis of our previous studies, we conducted the double shear test by using a third-generation optical fiber transducer that uses expandable polystyrene (EPS) as base material. However, the third-generation transducer has poor performance when cohesive force is present between the grout and capillary stainless steel pipe of the transducer. Thus, the fourth-generation optical fiber transducer was invented. Similar to the third-generation transducer, the fourth-generation transducer also used EPS as its base material. Single shear test was conducted on the fourth-generation transducer after being grouted with cement mortar (1 : 1 mix ratio). The micro-bend loss mechanism of the optical fiber was considered, and the optical time domain reflectometry instrument was used. The fact that the loss sequence of optical fibers subjected to loading is different at various locations is found. The relationship of the loading-point displacement vs. optical fiber sliding distance and optical loss were measured. Results show that the maximum initial measurement precision of the newly proposed device is 1 mm, the corresponding sliding distance is 21 mm, and the dynamic range is 0–20 mm. The fourth-generation transducer can measure the movement direction of loadings, thus making this transducer applicable for landslide monitoring.

Description: As a unique geological and geographical unit, the Tibetan Plateau dramatically impacts the world's environment and especially controls climatic and environmental changes in China, Asia and even in the Northern Hemisphere. Tibetan Plateau, therefore, provides a field laboratory for studying global change. With support from various agencies in the People's Republic of China, a Tibetan Observation and Research Platform (TORP) is now implementing. Firstly the background of the establishment of the TORP, the establishing and monitoring plan of long-term scale (5–10 years) of the TORP has been introduced. Then the preliminary observational analysis results, such as the characteristics of land surface heat fluxes and CO2 flux partitioning (diurnal variation and inter-monthly variation etc.), the characteristics of atmospheric and soil variables, the structure of the Atmospheric Boundary Layer (ABL) and the turbulent characteristics have also been shown in this paper.