ALBERT

All Library Books, journals and Electronic Records Telegrafenberg

feed icon rss

Ihre E-Mail wurde erfolgreich gesendet. Bitte prüfen Sie Ihren Maileingang.

Leider ist ein Fehler beim E-Mail-Versand aufgetreten. Bitte versuchen Sie es erneut.

Vorgang fortführen?

Exportieren
Filter
  • Artikel  (33)
  • Springer  (29)
  • American Chemical Society  (2)
  • Blackwell Publishing Ltd  (1)
  • Cambridge University Press  (1)
  • Maschinenbau  (21)
  • Werkstoffwissenschaften, Fertigungsverfahren, Fertigung  (12)
Sammlung
  • Artikel  (33)
Verlag/Herausgeber
Erscheinungszeitraum
Zeitschrift
  • 1
    Digitale Medien
    Digitale Medien
    s.l. : American Chemical Society
    Industrial and engineering chemistry 1 (1962), S. 285-287 
    Quelle: ACS Legacy Archives
    Thema: Chemie und Pharmazie , Werkstoffwissenschaften, Fertigungsverfahren, Fertigung
    Materialart: Digitale Medien
    Standort Signatur Erwartet Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 2
    Digitale Medien
    Digitale Medien
    Oxford, UK : Blackwell Publishing Ltd
    Journal of the American Ceramic Society 87 (2004), S. 0 
    ISSN: 1551-2916
    Quelle: Blackwell Publishing Journal Backfiles 1879-2005
    Thema: Maschinenbau , Physik
    Notizen: Nanocrystalline SnOx particles (x= 0–2) were synthesized using tetramethyltin (Sn(CH3)4) vapor as the particle precursor reactant in hydrogen/oxygen/argon (H2/O2/Ar) flames. The particle composition and morphology were characterized using X-ray diffractometry, transmission electron microscopy, and nitrogen (N2) surface adsorption. By controlling the concentration of oxygen in the reactant gases and the flame temperatures, metallic tin (Sn), tin monoxide (romarchite SnO), and/or tin dioxide (cassiterite SnO2) were generated. The crystalline powders consisted of both discrete primary particles and agglomerates, with average primary particle sizes of 23–24 nm for SnO2 and 69 nm for Sn (based on specific surface area measurements of bulk powders collected in the exhaust region of the flame). The compositional results were interpreted using equilibrium and detailed chemical kinetics models.
    Materialart: Digitale Medien
    Standort Signatur Erwartet Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 3
    Digitale Medien
    Digitale Medien
    Springer
    Colloid & polymer science 183 (1962), S. 84-84 
    ISSN: 1435-1536
    Quelle: Springer Online Journal Archives 1860-2000
    Thema: Chemie und Pharmazie , Maschinenbau
    Materialart: Digitale Medien
    Standort Signatur Erwartet Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 4
    ISSN: 1435-1536
    Quelle: Springer Online Journal Archives 1860-2000
    Thema: Chemie und Pharmazie , Maschinenbau
    Materialart: Digitale Medien
    Standort Signatur Erwartet Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 5
    Digitale Medien
    Digitale Medien
    Springer
    Applied microbiology and biotechnology 44 (1996), S. 693-698 
    ISSN: 1432-0614
    Quelle: Springer Online Journal Archives 1860-2000
    Thema: Biologie , Werkstoffwissenschaften, Fertigungsverfahren, Fertigung
    Notizen: Abstract The photosynthetic productivity of the filamentous cyanobacteriumSpirulina platensis was investigated in a cone-shaped helical tubular photobioreactor. A laboratory-scale photobioreactor was constructed with a 0.255-m2 basal area and a conical shape (0.64 m high × 0.57 m top diameter). The photostage comprised transparent reinforced polyvinyl chloride (PVC) tubing with spirally wound, metal-wire reinforcing in the tubing wall (31 m in length and 1.6 cm internal diameter with 0.25 cm wall thickness; total volume = 6.23 l). The inner surface of the photostage (0.651 m2) was illuminated with compact fluorescent cool white lamps; the photosynthetically active radiation (400–700 nm) energy input into the photobioreactor was 1249 KJ day−1 (12 h day/12 h night). The operation of an air-lift photobioreactor with CO2-enriched air (4%) at a flow rate of 0.3 l min−1 showed a maximum daily photosynthetic efficiency of 6.83% under batch-culture conditions. This corresponded to a production rate of 15.9 g dry biomass m−2(basal area) day−1 or 0.51 g dry biomass l medium−1 day−1.
    Materialart: Digitale Medien
    Standort Signatur Erwartet Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 6
    Digitale Medien
    Digitale Medien
    Springer
    Applied microbiology and biotechnology 44 (1996), S. 693-698 
    ISSN: 1432-0614
    Quelle: Springer Online Journal Archives 1860-2000
    Thema: Biologie , Werkstoffwissenschaften, Fertigungsverfahren, Fertigung
    Notizen: Abstract  The photosynthetic productivity of the filamentous cyanobacterium Spirulina platensis was investigated in a cone-shaped helical tubular photobioreactor. A laboratory-scale photobioreactor was constructed with a 0.255-m2 basal area and a conical shape (0.64 m high×0.57 m top diameter). The photostage comprised transparent reinforced polyvinyl chloride (PVC) tubing with spirally wound, metal-wire reinforcing in the tubing wall (31 m in length and 1.6 cm internal diameter with 0.25 cm wall thickness; total volume=6.23 l). The inner surface of the photostage (0.651 m2) was illuminated with compact fluorescent cool white lamps; the photosynthetically active radiation (400–700 nm) energy input into the photobioreactor was 1249 KJ day-1 (12 h day/12 h night). The operation of an air-lift photobioreactor with CO2-enriched air (4%) at a flow rate of 0.3 l min-1 showed a maximum daily photosynthetic efficiency of 6.83% under batch-culture conditions. This corresponded to a production rate of 15.9 g dry biomass m-2(basal area) day-1 or 0.51 g dry biomass l medium-1 day-1.
    Materialart: Digitale Medien
    Standort Signatur Erwartet Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 7
    ISSN: 1432-0614
    Quelle: Springer Online Journal Archives 1860-2000
    Thema: Biologie , Werkstoffwissenschaften, Fertigungsverfahren, Fertigung
    Notizen: Abstract The influence of (NH4)2SO4 concentration and dilution rate (D) on actual and potential H2 photoproduction has been studied in ammonium-limited chemostat cultures of Rhodobacter capsulatus B10. The actual H2 production in a photobioreactor was maximal (approx. 80 ml h−1 l−1) at D = 0.06 h−1 and 4 mM (NH4)2SO4. However, it was lower than the potential H2 evolution (calculated from hydrogen evolution rates in incubation vials), which amounted to 100–120 ml h−1 l−1 at D = 0.03–0.08 h−1. Taking into account the fact that H2 production in the photobioreactor under these conditions was not limited by light or lactate, another limiting (inhibiting) factor should be sought. One possibility is an inhibition of H2 production by the H2 accumulated in the gas phase. This is apparent from the non-linear kinetics of H2 evolution in the vials or from its inhibition by the addition of H2; initial rates were restored in both cases after the vials had been refilled with argon. The actual H2 production in the photobioreactor at D = 0.06 h−1 was shown to increase from approximately 80 ml h−1 l−1 to approximately 100 ml h−1 l−1 under an argon flow at 100 ml min−1. Under maximal H2 production rates in the photobioreactor, up to 30% of the lactate feedstock was utilised for H2 production and 50% for biomass synthesis.
    Materialart: Digitale Medien
    Standort Signatur Erwartet Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 8
    Digitale Medien
    Digitale Medien
    Springer
    Applied microbiology and biotechnology 49 (1998), S. 463-468 
    ISSN: 1432-0614
    Quelle: Springer Online Journal Archives 1860-2000
    Thema: Biologie , Werkstoffwissenschaften, Fertigungsverfahren, Fertigung
    Notizen: Abstract Removal of nitrate and phosphate ions from water, by using the thermophilic cyanobacterium Phormidium laminosum, immobilized on cellulose hollow fibres in the tubular photobioreactor at 43 °C, was studied by continuously supplying dilute growth medium for 7 days and then secondarily treated sewage (STS) for 12 days. The concentrations of NO− 3 and PO3− 4 in the effluent from the dilute growth medium decreased from 5.0 mg N/l to 3.1 mg N/l, and from 0.75 mg P/l to 0.05 mg P/l respectively, after a residence time of 12 h. The concentrations of NO− 3 and PO3− 4 in the effluent from STS decreased from 11.7 mg N/l to 2.0 mg N/l, and from 6.62 mg P/l to 0.02 mg P/l respectively, after a residence time of 48 h. The removal rates of nitrogenous␣and phosphate ions from STS were 0.24 and 0.11 mmol day−1 l reactor−1 respectively, under the same conditions. Although, among nitrogenous ions, nitrate and ammonium ions were efficiently removed by P.␣laminosum, the nitrite ion was released into the effluent when STS was used as influent. Treatment of water with thermophilic P. laminosum immobilized on hollow fibres thus appears to be an appropriate means for the removal of inorganic nitrogen and phosphorus from treated wastewater.
    Materialart: Digitale Medien
    Standort Signatur Erwartet Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 9
    Digitale Medien
    Digitale Medien
    Springer
    Experiments in fluids 10 (1991), S. 237-240 
    ISSN: 1432-1114
    Quelle: Springer Online Journal Archives 1860-2000
    Thema: Maschinenbau
    Notizen: Abstract Fast response flame ionisation detectors react to small combustible particles in the gas stream as well as to ionisable gases, producing unwanted large, short duration spikes in the output signal. During some wind tunnel dispersion modelling experiments, this problem arose due to sampling the atmospheric aerosol. An effective solution to the problem was found, which is described.
    Materialart: Digitale Medien
    Standort Signatur Erwartet Verfügbarkeit
    BibTip Andere fanden auch interessant ...
  • 10
    Digitale Medien
    Digitale Medien
    Springer
    Oxidation of metals 42 (1994), S. 431-449 
    ISSN: 1573-4889
    Schlagwort(e): acoustic emission ; oxide failure ; mechanisms ; iron oxide ; nickel oxide
    Quelle: Springer Online Journal Archives 1860-2000
    Thema: Maschinenbau
    Notizen: Abstract A small four-point-bend jig has been used in a scanning electron microscope (SEM) to monitor the tensile fracture processes in iron and nickel oxide scales in situ. The scales were 3–40 μm thick, the strain rate was 4×10−5 sec−1 and acoustic emission (AE) was used to correlate signals with specific cracking events. The technique provided detailed information of the failure processes, and several micrographs were taken as the crack pattern developed during testing. Failure started with short random through-scale cracks. These cracks soon formed a regular pattern. Spallation only occurred at much higher strains and resulted in very energetic AE signals. These signals were used together with the SEM observations to determine the strain to cause spallation. Measurements of the crack spacing as a function of strain showed that plastic stress relaxation by interfacial slip and/or substrate yielding processes affected cracking. Thus, the oxide remained attached to the substrate longer than would be expected from purely elastic behavior. An analysis based on the observed crack spacing at the onset of spallation gave ratios of 0.8–1.9 and ∼0.9 between tensile and interfacial strength for iron and nickel oxides scales, respectively.
    Materialart: Digitale Medien
    Standort Signatur Erwartet Verfügbarkeit
    BibTip Andere fanden auch interessant ...
Schließen ⊗
Diese Webseite nutzt Cookies und das Analyse-Tool Matomo. Weitere Informationen finden Sie hier...