ALBERT

All Library Books, journals and Electronic Records Telegrafenberg

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
Filter
  • Articles  (18)
  • Springer  (18)
  • 1990-1994  (18)
  • Electrical Engineering, Measurement and Control Technology  (9)
  • Geography  (6)
  • Economics  (2)
  • Architecture, Civil Engineering, Surveying  (1)
Collection
  • Articles  (18)
Years
Year
  • 1
    Electronic Resource
    Electronic Resource
    Springer
    International journal of biometeorology 37 (1993), S. 89-95 
    ISSN: 1432-1254
    Keywords: Airborne pollen ; Airborne spores ; Pollen diagrams ; Meteorological factors
    Source: Springer Online Journal Archives 1860-2000
    Topics: Geography , Physics
    Notes: Abstract A qualitative and quantitative analysis of airborne pollen and spores was carried out over 2 years (from September 1987 to August 1989) in the city of León. Slides were prepared daily using a volumetric pollen trap, which was placed on the Faculty of Veterinary Science building (University of León) 12m above ground-level. Fifty-one pollen types were observed; the most important of these were: Cupressaceae during the winter,Pinus andQuercus in spring, and Poaceae, Leguminosae and Chenopodiaceae in the summer. The results also showed the existence of a rich mould spore assemblage in the atmosphere. The group of Amerospores (Penicillium, Aspergillus andCladosporium) as well as Dictyospores (Alternaria) were the most abundant;Puccinia was common in the air in August. Fluctuations in the total pollen and spores m3 of air were compared with meteorological parameters (temperature, relative humidity and rainfall). From the daily sampling of the atmosphere of León, considering the maximum and minimum temperature and duration of rainfall, the start of the pollen grain season was observed generally to coincide with a rise in temperature in the absence of rain.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    Springer
    Journal of applied electrochemistry 23 (1993), S. 531-546 
    ISSN: 1572-8838
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology , Electrical Engineering, Measurement and Control Technology
    Notes: Abstract We present a critical review on the use of STM as anin situ technique to characterize electrochemical systems based on the work performed in our laboratory. Contributions ofin situ STM studies include: (i) atomic resolution of electrodeposited lead on graphite; (ii) imaging of modifications on metallic electrode surfaces induced by electrochemical oxidation-reduction processes; (iii) imaging of corrosion process on aluminium and Al-Ta alloy electrodes in NaCl solution; (iv) characterization of semiconductor-solution interfaces. These studies allowed: (a) establishment of STM as a technique which, for some systems, yields atomic resolution of metallic surfaces in air and in solution; (b) establishment of a mechanism for the electrochemical growth of oxide films on metal electrodes; (c) establishment of a corresponding mechanism for the reduction of those electrochemically grown oxide films; (d) direct monitoring of corrosion processes on a scale of nm to μm; and (e) determination of the presence of surface states and their energy position at the semiconductor-solution interfaces.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 3
    Electronic Resource
    Electronic Resource
    Springer
    Journal of applied electrochemistry 23 (1993), S. 641-645 
    ISSN: 1572-8838
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology , Electrical Engineering, Measurement and Control Technology
    Notes: Abstract Electrodeposited Ni-Zn and Ni-S on a mild steel substrate have shown very good performance as cathode materials for the HER in alkaline media. The materials were studied previously with surface techniques and evaluated through current-potential curves and long term operation. This paper describes a detailed mechanistic study of the HER on Ni-Zn and Ni-S carried out with impedance techniques. In both cases the reaction proceeds through a Volmer-Heyrovsky mechanism. As predicted by kinetic theory, the temperature study shows that the energy of activation of the rate determining step is the same as the energy of activation of the overall reaction.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 4
    Electronic Resource
    Electronic Resource
    Springer
    Journal of applied electrochemistry 22 (1992), S. 888-892 
    ISSN: 1572-8838
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology , Electrical Engineering, Measurement and Control Technology
    Notes: Abstract The characteristics and mechanism of the hydrogen evolution reaction on a nickel sulphide electrode incorporating molybdenite particles are described. At 25°C the overpotential for the reaction is 300 mV lower than that of the mild steel cathodes used in unipolar electrolysers. The material shows good stability under long term operation.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 5
    Electronic Resource
    Electronic Resource
    Springer
    Journal of applied electrochemistry 22 (1992), S. 973-977 
    ISSN: 1572-8838
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology , Electrical Engineering, Measurement and Control Technology
    Notes: Abstract This paper describes the preparation of Ni−Zn and Ni−Co−Zn coatings by electrodeposition on a mild steel substrate. After treatment in a KOH solution to leach out part of the zinc, the materials were evaluated as cathodes for the hydrogen evolution reaction in alkaline solutions. The materials were found to have high surface areas and low Tafel slopes. Overpotentials at current densities of technological interest are significantly lower than those of the traditional materials used in water electrolysis.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 6
    ISSN: 1572-8838
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology , Electrical Engineering, Measurement and Control Technology
    Notes: Abstract The pitting corrosion of copper in alkaline solutions in the presence of benzotriazole (BTA) was investigated. The presence of BTA shifts the breakdown (E b) and the repassivating (E p) potentials positively with respect to the blanks. However, the shift ofE p becomes smaller than that ofE b, particularly at pH9 and 11. Pitting corrosion involves the formation of crystallographic pits. The kinetics of the process fits a nucleation and growth mechanism involving instantaneous nucleation and 3D growth under charge transfer control. The spatial distribution of pits indicates that there is no marked influence of a pit on the nucleation and growth of other pits.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 7
    Electronic Resource
    Electronic Resource
    Springer
    Journal of applied electrochemistry 24 (1994), S. 426-433 
    ISSN: 1572-8838
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology , Electrical Engineering, Measurement and Control Technology
    Notes: Abstract The voltammetric formation and potentiostatic growth of anodic films on Ru/Pt electrodes in HClO4 and HCl solutions were studied by single negative potential sweeps and cathodic charging curves in the potential range from −0.25 to 1.1 V vs SCE. The growth of the anodic layer proceeds through the formation of two layers of different reduction reversibility. At potentials below 500 mV, the layer more reversibly reduced, grows slowly to a maximum coverage equivalent to one oxygen monolayer. The thicker, and more stable, layer increases with holding time to a maximum of about three oxygen monolayers during the period of time studied (7 h). At holding potentials above 500 mV, the reduction charge of the anodic layer reaches a constant value after polarization for 1 h. Growth starts with formation of two layers which, with time, become a single layer which is hardly reducible. The results suggest the eventual formation of anhydrous RuO2, In HCl solutions, Cl− adsorption inhibits the formation of the anodic layer, decreasing its growth rate but reaching no limiting thickness for 7 h. At holding potentials below 650 mV vs SCE, only a single layer is formed with slight structural changes. At potentials above 650 mV, the initially homogeneous film converts with holding time into a bilayer where the outer layer becomes hardly reducible. This layer is assumed to be a stable anionic hydroxy species (RuCl5OH2−) which dissolves as Ru2O2Cl6(H2O)2−. In HClO4 and HCl the layer growth follows a direct logarithmic law.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 8
    Electronic Resource
    Electronic Resource
    Springer
    Journal of applied electrochemistry 21 (1991), S. 189-202 
    ISSN: 1572-8838
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology , Electrical Engineering, Measurement and Control Technology
    Notes: Abstract Current extractive metallurgy techniques for lead refining by the Betts Electrorefining Process (BEP) are reviewed. In the BEP, refined lead (〉99.99%) can be produced by the electrorefining of impure lead anodes. The process relies on the selective dissolution of lead which leaves behind a strong and adherent layer of solids (slimes) containing the noble impurities originally present in the anode. The properties of this layer are closely linked to the physical metallurgy of the lead anode. Careful control of microstructure and level of impurities in the lead anode is required, and an essential attribute of the process is the use of the H2SiF6−PbSiF6 electrolyte. This paper focuses mainly on the relationship between the anodic process and its effects. The effect of impurities and electrolysis parameters on the cathodic process are also reviewed. Descriptions of industrial operations of the BEP throughout the world are tabulated.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 9
    Electronic Resource
    Electronic Resource
    Springer
    Journal of applied electrochemistry 23 (1993), S. 1151-1161 
    ISSN: 1572-8838
    Source: Springer Online Journal Archives 1860-2000
    Topics: Chemistry and Pharmacology , Electrical Engineering, Measurement and Control Technology
    Notes: Abstract A resistive grid model was used to study the current and ohmic overpotential distributions along the surface of lead-acid battery electrodes. Analyses were made under two different regimes: the initial behaviour at high current densities and the response with time at low current densities. At high discharge currents the theoretical results show that the geometry of the electrodes and the position of the lug play the most important role in controlling the magnitude of ohmic losses. The best geometry is a square grid with the lug positioned at the upper centre of the electrode. At low discharge currents the model was used to follow the current distribution along the electrode surface as a function of time. In this last study the appearance, for long discharge times, of short-circuited concentration microcells localized in certain regions of the electrode surface was noted. The other regions of the electrode supply the external discharge current and the excess current necessary to charge the internal microcell.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 10
    Electronic Resource
    Electronic Resource
    Springer
    Natural hazards 4 (1991), S. 119-139 
    ISSN: 1573-0840
    Keywords: Tsunamis ; ocean measurements ; model comparisons
    Source: Springer Online Journal Archives 1860-2000
    Topics: Energy, Environment Protection, Nuclear Power Engineering , Geography , Geosciences
    Notes: Abstract Excellent deep ocean records have been obtained of two tsunamis recently generated in the Alaskan Bight on 30 November 1987 and 6 March 1988, providing the best available data set to date for comparison with tsunami generation/propagation models. Simulations have been performed with SWAN, a nonlinear shallow water numerical model, using source terms estimated by a seafloor deformation model based on the rectangular fault plane formalism. The tsunami waveform obtained from the model is quite sensitive to the specific source assumed. Significant differences were found between the computations and observations of the 30 November 1987 tsunami, suggesting inadequate knowledge of the source characteristics. Fair agreement was found between the data and the model for the first few waves of the 6 March 1988 tsunami. Model estimates of the seismic moment and total slip along the fault plane are also in fair agreement with those derived from the published Harvard centroid solution for the 6 March 1988 event, implying that the computed seafloor deformation does bear some similarity to the actual source.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...