ALBERT

Notes: The S.W. Nabitah Mobile Belt, Saudi Arabia, contains a Proterozoic island-arc complex. In the Qadda area, the metavolcanic-dominated supracrustal sequence records amphibolite facies regional metamorphism of high-T , low-P type. Calcsilicate rocks and aluminous dolomitic marbles within the supracrustal sequence have been studied in detail to refine estimates of peak metamorphic P–T  conditions and assess the role of fluids during prograde and retrograde metamorphism.Fluid-independent thermobarometers (including the calcite–dolomite thermometer and P-sensitive equilibria involving grossular, wollastonite, anorthite, meionite, quartz and calcite) yield peak P–T  conditions of c. 650–660 °C, 4 kbar, both higher than previous estimates, giving a revised average thermal gradient of c. 45 °C km–1.The close match between the peak temperatures implied by calcite–dolomite thermometry and those recorded by univariant devolatilization equilibria suggests that the calcareous rocks were fluid-bearing during late-prograde and peak metamorphic stages. These fluids were essentially binary H2O–CO2 mixtures with low NaCl and HF concentrations. Most were H2O-rich, with XCO2 between 0.02 and 0.2, but values of c. 0.6 are recorded by two samples. High modal abundances of the solid products of decarbonation reactions (e.g. c. 10–50% wollastonite) in many of the rocks that record low-XCO2 equilibrium fluids implies infiltration of significant quantities of externally derived aqueous fluid during late-prograde metamorphism, but not enough to exhaust the buffering capacity of the rocks. Calculated minimum time-integrated fluid-to-rock ratios of five wollastonite-bearing calcsilicate rocks range from 0.7±0.22 to 1.39±0.46 (1σ); those of six marbles range from c. 0 to 4±1.4. The latter variation occurs on a metre-scale, implying focusing of fluid flow. Diopside-rich rocks record fluid-to-rock ratios of up to 88±48. Penetrative wollastonite lineations indicate a temporal link between infiltration and distributed ductile deformation. Infiltrating fluids were probably derived both from the prograde dehydration of adjacent metabasalts and metatuffs and from crystallization of voluminous pretectonic granitoid intrusions. In general, fluid-to-rock ratios deduced for the metavolcanic-dominated Qadda area are similar to those recorded by rocks in the metasediment-dominated terrane of N. New England.The occurrence of post-tectonic retrograde hydration textures in both carbonate-bearing and carbonate-free rocks otherwise lacking hydrous minerals testifies to infiltration of aqueous fluids during retrograde metamorphism in the absence of penetrative deformation. Minimum fluid-to-rock ratios calculated for secondary grossular reaction rims in some calcsilicates are c. 0.04. Later patchy hydration of scapolite probably utilized static, pore-filling fluids remaining after the early retrograde infiltration.

Notes: Abstract A natural example of phengite that had undergone partial thermal decomposition at a pressure of about 0.5 kbar and a temperature of about 680° C in a contact aureole was exmined in the transmission electron microscope (TEM). Partially pseudomorphed phengites were found to consist of combinations of phengite, biotite, K-feldspar, mullite, sillimanite, spinel and cordierite. Different areas within individual, partially pseudomorphed, phengite grains show various degrees of reaction and different reaction products; the cores are the least reacted and the margins have reacted most. In the cores the assemblage Al-, Mg-enriched phengite+biotite +K-feldspar+mullite±spinel has formed, whereas the assemblage K-feldspar+mullite+sillimanite+spinel +biotite+cordierite has formed at the edges. According to our thermodynamic calculations, the breakdown of phengite should have produced cordierite+spinel +corundum+K-feldspar in regions isolated from the influx of SiO2 and cordierite+andalusite+quartz+K-feldspar in regions near the edge of the grains that were essentially saturated with SiO2. Chemical equilibrium was not achieved in any part of the partially pseudomorphed phengites on a micron scale or larger. Breakdown theoretically should have been complete by about 550° C; the reaction temperature was overstepped by at least 130° C for 20–25 years. The variations in the degree and type of reaction are probably due partly to the availability of suitable nucleation sites in different regions, partly to the need to remove H2O from reaction sites and partly to the influence of SiO2, which diffused into the grains during metamorphism. The presence of SiO2 lowers the equilibrium temperatures. Thus there is a higher driving force for breakdown near the grain boundaries than in the cores. Most of the products show an orientation relationship with the parent phengite and have consistent habit planes; they have their closest-packed planes and closest-packed directions parallel to one another and to those of phengite. Such relationships minimize the strain and surface energies at nucleation and favour most rapid nucleation and growth of the reaction products. The great structural similarity of biotite to phengite resulted in its having the highest rate of nucleation and growth of any product and it occurred in all areas of the phengite pseudomorphs studied. Mullite and sillimanite were produced metastably. Mullite has more rapid nucleation kinetics than other aluminosilicates because it is structurally disordered. Sillimanite formed rather than andalusite in regions of the partially pseudomorphed phengites where the reaction reached an advanced stage, because the reaction from phengite to andalusite requires an energetically unfavourable change in aluminium co-ordination state.