ALBERT

Description: Zero-age basalts dredged from the Kolbeinsey Ridge directly north of Iceland are mafic quartz tholeiites (MgO 6-10 wt. %), strongly depleted in incompatible elements. Fractionation-corrected Na2O contents ('Na(sub 8)') are amongst the lowest found on the global ridge system, implying that the degree of partial melting at Kolbeinsey is amongst the highest for all mid-ocean ridge basalt (MORB). In contrast, the basalts show large ranges of incompatible-element ratios (e.g., K2O/TiO2 of 0.01 to 0.12 and Nd/Sm of 2.1 to 2.9) not related to variations in radiogenic isotope ratios; this suggests recent enrichment/depletion events associated with small-degree partial melting as their cause, rather than long-lived source heterogeneity. Tholeiitic MORB from many regions globally show similar or more extreme variations in K2O/TiO2. Dynamic melting of an adiabatically upwelling source can reconcile these conflicting indications of the degree of melting. Through dynamic melting, the incompatible elements are partially separated into different melt fractions based on their bulk partition coefficients, more incompatible elements being concentrated in deeper, smaller-degree partial melts. The final erupted magma is a mix of melts from all depths in the melting column. The concentration of highly incompatible elements in the mix will be very sensitive to the physical processes allowing the deep melts to separate and migrate to the site of mixing, and small fluctuations in the efficiency of the separation process can account for the large range of trace element ratios seen at Kolbeinsey. The major element chemistry of the erupted mix (and Na(sub 8) is much more robust, depending mainly on the integrated total amount of melting. The large variations of incompatible element ratios seen at Kolbeinsey, and in MORB in general, therefore give no information about the total degree of melting occuring beneath the ridge, nor do they require a heterogeneous source.

Description: Seismic reflection and refraction data from the SE Greenland margin provide a detailed view of a volcanic rifted margin from Archean continental crust to near-to-average oceanic crust over a spatial scale of 400 km. The SIGMA III transect, located ∼600 km south of the Greenland-Iceland Ridge and the presumed track of the Iceland hot spot, shows that the continent-ocean transition is abrupt and only a small amount of crustal thinning occurred prior to final breakup. Initially, 18.3 km thick crust accreted to the margin and the productivity decreased through time until a steady state ridge system was established that produced 8–10 km thick crust. Changes in the morphology of the basaltic extrusives provide evidence for vertical motions of the ridge system, which was close to sea level for at least 1 m.y. of subaerial spreading despite a reduction in productivity from 17 to 13.5 km thick crust over this time interval. This could be explained if a small component of active upwelling associated with thermal buoyancy from a modest thermal anomaly provided dynamic support to the rift system. The thermal anomaly must be exhaustible, consistent with recent suggestions that plume material was emplaced into a preexisting lithospheric thin spot as a thin sheet. Exhaustion of the thin sheet led to rapid subsidence of the spreading system and a change from subaerial, to shallow marine, and finally to deep marine extrusion in ∼2 m.y. is shown by the morphological changes. In addition, comparison to the conjugate Hatton Bank shows a clear asymmetry in the early accretion history of North Atlantic oceanic crust. Nearly double the volume of material was emplaced on the Greenland margin compared to Hatton Bank and may indicate east directed ridge migration during initial opening.