ALBERT

Notes: Abstract Quantitative tectonic modelling demonstrates an interaction of flexure of the lithosphere underlying the western Betics with crustal thinning in the Alboran Basin and flank uplift in the Internal Zone. In the eastern Betics the flexural response is overprinted by post-thrusting extensional events. Lateral variations in thermal structure and rheology of the lithosphere along strike of the Betics shed light on changes in tectonic configuration and are consistent with evidence for lateral variations in the mode of extension in the Alboran Basin. Flexural modelling and subsidence analysis of Neogene basins in the Internal Zone of the Betics, with spatial development controlled by contrasts in lithosphere rheology, demonstrate that at least two extensional events have affected the orogenic evolution of the Betics. The first event appears to reflect Oligocene-Early Miocene rifting observed throughout the Western Mediterranean. The second phase, which caused the present configuration of the Betics, corresponds to Tortonian-Recent extension centered in the Alboran Basin.

Notes: Abstract  We examined the effects of pollen competition (pollen load size) on sporophytic vigor and gametophytic performance in Cucurbita texana, a wild gourd, while controlling for alternative interpretations of the data. Under field conditions we compared the vigor of progeny produced from large and small pollen loads and examined the in vitro performance of the pollen produced by the progeny. We found that the progeny from large pollen loads germinated faster and had a greater reproductive output (male flowers and fruits) than progeny produced from small pollen loads. In addition, we found that the pollen produced on plants derived from large pollen loads grew faster in vitro than the pollen produced on plants derived from small pollen loads. These findings indicate that pollen competition affects the performance of the resulting sporophytic generation and the microgametophytes they produce.

Notes: Abstract Experiments were designed to clone and identify genes of the fungal phytopathogen Colletotrichum gloeosporioides expressed at high levels during growth on the compatible host Stylosanthes guianensis when compared with expression in axenic culture. A cDNA clone (pCgGS) that hybridised preferentially to a cDNA probe prepared from infected leaves was isolated by the differential screening of a cDNA library from a nitrogen-starved axenic culture of C. gloeosporioides. The DNA sequence of pCgGS is highly homologous to genes for glutamine synthetase (GS) in other organisms. pCgGS contained all of the conserved regions assigned as catalytic domains in GS enzymes. Comparison with genomic sequences indicated that in C. gloeosporioides the GS gene is present as a single copy with three introns. To our knowledge this is the first report of the cloning of a GS from a filamentous fungus. A second clone (pCgRL1) was also isolated and represented a partial cDNA of the 25s rRNA of C. gloeosporioides. Because pCgRL1 did not hybridise to plant rRNA under high-stringency hybridisation conditions, it was used as a reference to quantify the expression of fungal GS mRNA during pathogenesis in S. guianensis compared to fungal growth in axenic culture. The results indicated that elevated expression of GS occurred during pathogenesis of C. gloeosporioides on S. guianensis, particularly at early stages of infection where expression was about six-times higher than during growth in rich culture media. This work also demonstrates that fungal-specific 25s rRNA fragments, such as pCgRL1, have considerable utility as a reference for quantifying pathogen gene expression in infected plants.

Notes: Abstract The first intron of the human Proα1(I) collagen gene contains an orientation-dependent enhancer composed of both positive and negative cis-acting elements involved in the transcriptional regulation of this gene. Deletion of a 360 bp Sau 3A intronic fragment spanning nucleotide + 494 to + 854 (S360) resulted in dramatic down-regulation of pCOL-KT (Thompson et al., J Biol Chem 266: 2549–2556, 1991). Using a DNaseI protection assay, we demonstrate a single footprint located at + 590 to + 615 in the S360 fragment; nuclear extracts prepared from mesenchymal and nonmesenchymal cells exhibited similar binding characteristics. A double stranded oligonucleotide representing a consensus Ap-1 binding sequence competed with S360 for binding. In contrast to what occurred in response to S360 deletion which was always accompanied by reduced expression, the deletion of the Ap-1 binding site (+ 598 to + 604) caused either increased or decreased expression of the reporter gene depending on the target cell. Site-directed mutations in the Ap-1-like cis-element of Proα1(I) were also tested in transient expression assays. Consistent with the paradoxical results of Ap-1 deletion, we observed that the functional consequences of mutations in the Ap-1 site also varied in different cells. In A204 cells, one point mutation, which resulted in the loss of protein binding to S360, led to increased CAT activity while another point mutant, which retained binding of the Ap-1 like trans-acting factor(s), showed decreased CAT expression. The effects of these two mutations in the HFL-1 cells were exactly opposite of what was seen for A204 cells. Based on these observations, we postulate that the Ap-1 site plays a critical role in the transcriptional activity of the human Proα1(I) gene. The implications of an apparently dual mode of regulation through a single cis-regulatory element are discussed. (Mol Cell Biochem 118: 119–129, 1992)

Notes: Abstract Thin boron films were produced on Si substrates from a solid boron source and a hydrogen plasma. The plasma was generated using a 13.56 MHz generator and films were deposited with a forward radio frequency (RF) power of 2.0 kW. At pressures from 0.931–2.26×102 Pa under high hydrogen concentrations a capacitively coupled plasma (CCP) was observed whereas at low hydrogen concentrations an inductively coupled plasma (ICP) was observed. The films were predominantly deposited with an ICP but in one case a film was deposited using a CCP discharge. The deposited films consisted primarily of boron, but they also contained oxygen and silicon. The films were amorphous at 225 and 350°C, but revealed X-ray diffractions at 475°C. It was concluded that the hydrogen concentration, RF plasma power and surface temperature as well as the plasma-boron source interactions strongly influenced the film thickness and composition.

Notes: Abstract  The development of large panels of simple-to-analyse genetic markers for tagging agronomically important genes and diversity studies in hexaploid bread wheat is an important goal in applied cereal genetic research. We have isolated and sequenced over 200 clones containing microsatellites from the wheat genome and have tested 153 primer pairs for genetic polymorphism using a panel of ten wheat varieties, including the parents of our main mapping cross. A subset comprising 49 primer pairs detects 76 loci, of which 74 can be unequivocably allocated to one of the wheat chromosomes. A relatively low frequency of the loci detected are from the D genome, and these loci show less polymorphism than those from the A and B genomes. Generally, the microsatellites show high levels of genetic polymorphism and an average of 3.5 alleles per locus with an average polymorphism information content (PIC), value of 0.51. The observed levels of polymorphism are positively correlated with the length of the microsatellite repeats. A high proportion, approximately two-thirds, of primer pairs designed to detect simple sequence repeat (SSR) variation in wheat do not generate the expected amplification products and, more significantly, often generate unresolvable PCR products. In general, our results agree closely with those obtained from other recent studies using microsatellites in plants.

Notes: Abstract A bioassay was used to evaluate the effects of cuticular leaf components, isolated fromN. tabacum, N. glutinosa (accessions 24 and 24a), and 23other Nicotiana species, on germinationof P. tabacina (blue mold). The leaf surface compounds includedα- andβ-4,8,13,-duvatriene-l,3-diols (DVT-diols), (13-E)-labda-13-ene-8α-,15-diol (labdenediol), (12-Z)-labda-12,14-diene-8α-ol (cis-abienol), (13-R)-labda-8,14-diene-13-ol (manool), 2-hydroxymanool, a mixture of (13-R)-labda-14-ene-8α,13-diol (sclareol), and (13-S)-labda-14-ene-8α,13-diol (episclareol), and various glucose and/or sucrose ester isolates. The above in acetone were applied onto leaf disks of the blue moldsusceptibleN. tabacum cv. TI 1406, which was then inoculated with blue mold sporangia. Estimated IC50 values (inhibitory concentration) were 3.0μg/cm2 forα-DVT-diol, 2.9μ/cm2 forβ-DVT-diol, 0.4μg/cm2 for labdenediol and 4.7μg/cm2 for the sclareol mixture. Manool, 2-hydroxymanool, andcis-abienol at application rates up to 30μg/cm2 had little or no effect on sporangium germination. Glucose and/or sucrose ester isolates from the cuticular leaf extracts of 23Nicotiana species and three different fractions fromN. bigelovii were also evaluated for antimicrobial activity at a concentration of 30μg/cm2. Germination was inhibited by 〉20% when exposed to sugar esters isolated fromN. acuminata, N. benthamiana, N. attenuata, N. clevelandii, andN. miersii, and accessions 10 and 12 ofN. bigelovii. These results imply that a number of compounds may influence resistance to blue mold in tobacco.

Notes: Summary Single fibres of different sarcomere length at rest have been isolated from the claw muscle of the yabby (Cherax destructor), a decapod crustacean. Fibres of either long (SL 〉 6 μm) or short (SL 〈 4 μm) sarcomere length have been mechanically skinned and were maximally activated by Ca2+ and Sr2+ under various experimental conditions (ionic strength, in the presence of 2,3 butanedione monoxime (BDM)) to determine differences in their contractile properties. Isometric force was measured simultaneously with either myofibrillar MgATPase or fibre stiffness in both fibre types. The ultrastructure of individual long- and short-sarcomere fibres was also determined by electron microscopy. The long-sarcomere fibres developed greater tension (30.48±1.72 N cm−2) when maximally activated by Ca2+ compared with the short-sarcomere fibres (18.60±0.80 N cm−2). The difference in the maximum Ca2+-activated force can be explained by the difference in the amount of filament overlap between the two fibre types. The maximum Ca2+-activated myofibrillar MgATPase rate in the short-sarcomere fibres (1.60±0.27 mmol ATP l−1 s−1) was higher, but not significantly different from the ATPase rate in fibres with long-sarcomeres (1.09±0.14 mmol ATP l−1 s−1). As the concentration of myosin is estimated to be higher only by a factor of 1.22 in the short-sarcomere preparations there is no evidence to suggest that the myofibrillar MgATPase activity is different in the long- and short-sarcomere preparations. The maximum Ca2+-activated force (P 0) of both short- and long-sarcomere fibres was quite insensitive to BDM compared with vertebrate muscle. Force decreased to 60.2±5.3% and 76.1±2.7% in the short- and long-sarcomere fibres respectively in the presence of 100 mmol l−1 BDM. The difference in the force depression between the. long- and short-sarcomere fibres is statistically significant (p〈0.05). Fibre stiffness during maximum Ca2+-activation expressed as percentage maximum force per nm per half sarcomere was higher by a factor of 3.5 in short-sarcomere fibres than in long-sarcomere fibres suggesting that the compliance of the filaments in the long-sarcomere fibres is considerably higher than in the short-sarcomere fibres. Sr2+ could not activate the contractile apparatus to the same level as that seen by Ca2+ in either fibre type: the maximum Sr2+-activated force was (20±3%) and (63±3%) of the maximum Ca2+-activated force response in short- and long-sarcomere fibres, respectively. The ratio between fibre stiffness in the maximum Sr2+-activating solution and the Ca2+-activating solution was very similar to the ratio between the maximum Sr2+-activated force and Ca2+-activated force in either type of fibres, suggesting that the number of attached crossbridges is lower in the fibres when maximally activated by Sr2+ than when maximally activated by Ca2+. The short-sarcomere fibres were also more sensitive to changes in ionic strength than long-sarcomere fibres. In conclusion these results indicate that while several important specific characteristics of the short- and long-sarcomere length fibres (ATPase, maximum Ca2+-activated force and fibre stiffness) can be explained solely on differences in the ultrastructure (length and density per cross-sectional area of myosin filaments) there are also differences in the properties of the proteins involved in the force production and regulation evidenced by the differential effect of Sr2+, BDM and ionic strength on contractile activation in the two fibre types.

Notes: Abstract The rate, magnitude and pharmacology of inorganic phosphate (Pi) transport into the sarcoplasmic reticulum were estimated in single, mechanically skinned skeletal muscle fibres of the rat. This was done, indirectly, by using a technique that measured the total Ca2+ content of the sarcoplasmic reticulum and by taking advantage of the 1:1 stoichiometry of Ca2+ and Pi transport into the sarcoplasmic reticulum lumen during Ca--Pi precipitation- induced Ca2+ loading. The apparent rate of Pi entry into the sarcoplasmic reticulum increased with increasing myoplasmic [Pi] in the 10 mm--50 mm range at a fixed, resting myoplasmic pCa of 7.15, as judged by the increase in the rate of Ca--Pi precipitation-induced sarcoplasmic reticulum Ca2+ uptake. At 20 mm myoplasmic [Pi] the rate of Pi entry was calculated to be at least 51 μm s−1 while the amount of Pi loaded appeared to saturate at around 3.5 mm (per fibre volume). These values are approximations due to the complex kinetics of formation of different species of Ca--Pi precipitate formed under physiological conditions. Phenylphosphonic acid (PhPA, 2.5 mm inhibited Pi transport by 37% at myoplasmic pCa 6.5 and also had a small, direct inhibitory effect on the sarcoplasmic reticulum Ca2+ pump (16%). In contrast, phosphonoformic acid (PFA, 1 mm) appeared to enhance both the degree of Pi entry and the activity of the sarcoplasmic reticulum Ca2+ pump, results that were attributed to transport of PFA into the sarcoplasmic reticulum lumen and its subsequent complexation with Ca2+. Thus, results from these studies indicate the presence of a Pi transporter in the sarcoplasmic reticulum membrane of mammalian skeletal muscle fibres that is (1) active at physiological concentrations of myoplasmic Pi and Ca2+ and (2) partially inhibited by PhPA. This Pi transporter represents a link between changes in myoplasmic [Pi] and subsequent changes in sarcoplasmic reticulum luminal [Pi]. It might therefore play a role in the delayed metabolic impairment of sarcoplasmic reticulum Ca2+ release seen during muscle fatigue, which should occur abruptly once the Ca--Pi solubility product is exceeded in the sarcoplasmic reticulum lumen