ALBERT

All Library Books, journals and Electronic Records Telegrafenberg

feed icon rss

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
Filter
  • Chemical Engineering  (60)
  • unknown
  • 1980-1984
  • 1975-1979  (60)
  • 1955-1959
  • 1979  (60)
  • 1
    Electronic Resource
    Electronic Resource
    Hoboken, NJ : Wiley-Blackwell
    AIChE Journal 25 (1979), S. 759-762 
    ISSN: 0001-1541
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Process Engineering, Biotechnology, Nutrition Technology
    Notes: Calculation of the phase diagram for saturated aqueous multi-ion solutions of strong electrolytes, based upon use of the thermodynamic solubility products, is illustrated for the four-ion system: Na+, K+, Mg++, SO4=. Solid phases are identified along with the ion concentrations of the associated saturated solutions.
    Additional Material: 1 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 2
    Electronic Resource
    Electronic Resource
    Stamford, Conn. [u.a.] : Wiley-Blackwell
    Polymer Engineering and Science 19 (1979), S. 1046-1053 
    ISSN: 0032-3888
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: The hot drawing of extruded composite sheets can be used to control the orientation of both matrix and reinforcing fibers. A study was made of the effect of draw ratio on the properties of an extruded polystyrene sheet containing 0 to 1 percent of short glass fibers. An increase in draw ratio resulted in an increase in fiber orientation. A model of a rigid fiber rotating in an elongational flow field was used to describe the effect of draw ratio on the final orientation distribution. An increase in draw ratio also caused an increase in the amount of fiber breakage. A shear-lag analysis was used to estimate the extent of damage as a function of draw ratio. It was also found that the mechanical properties were dependent upon both the draw ratio and fiber concentration.
    Additional Material: 14 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 3
    Electronic Resource
    Electronic Resource
    Stamford, Conn. [u.a.] : Wiley-Blackwell
    Polymer Engineering and Science 19 (1979), S. 162-165 
    ISSN: 0032-3888
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics , Physics
    Notes: The thermal and mechanical degradation of glassy polystyrene has been studied by Fourier Transform Infrared, FT-IR, spectroscopy. Using difference spectroscopy we have found that the products formed from these two modes of degradation were significantly different. This result is in contrast with other workers who found similar products for the thermal and mechanical degradation of polystyrene by mass spectroscopy. Our result suggests a reassessment of the thermal activation mechanism for mechanically-induced bond scission. We have also found that the distribution of oxidation products appears to depend upon the environment in which the polymer is mechanically degraded. Finally, we have demonstrated the utility of FT-IR spectroscopy for studying the mechanical degradation of polymers.
    Additional Material: 5 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 4
    Electronic Resource
    Electronic Resource
    Hoboken, NJ : Wiley-Blackwell
    AIChE Journal 25 (1979), S. 188-190 
    ISSN: 0001-1541
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Process Engineering, Biotechnology, Nutrition Technology
    Additional Material: 1 Tab.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 5
    ISSN: 0001-1541
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Process Engineering, Biotechnology, Nutrition Technology
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 6
    Electronic Resource
    Electronic Resource
    Hoboken, NJ : Wiley-Blackwell
    AIChE Journal 25 (1979), S. 773-781 
    ISSN: 0001-1541
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Process Engineering, Biotechnology, Nutrition Technology
    Notes: A series of seven coals of different ranks and from various locations were heated in air under relatively mild conditions to measure the rates of oxidation and the production of carbonic gases in the effluent stream. The gas flow rate, coal particle size, and reactor temperature were changed as independent variables. Each sample was exposed for from 6 to 9 hr under atmospheric pressure at temperatures in the range of 200° to 250°C. The results show two kinds of rate behavior depending primarily on the relative porosity of the coal under study. The small pore coals followed the expectations of the earlier Kam-Hixson-Perlmutter (KHP) model, but the large pore coals gave rates sensitive to transport effects. Correlations were also obtained on the ratio of carbon dioxide and carbon monoxide produced and on the relationship between the carbon content of an exposed coal and its heating value.
    Additional Material: 19 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 7
    ISSN: 0001-1541
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Process Engineering, Biotechnology, Nutrition Technology
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 8
    Electronic Resource
    Electronic Resource
    Hoboken, NJ : Wiley-Blackwell
    AIChE Journal 25 (1979), S. 583-591 
    ISSN: 0001-1541
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Process Engineering, Biotechnology, Nutrition Technology
    Notes: The present research concerns mechanism and rate of reaction between dissolved ozone and phenol in homogeneous solutions. The stopped-flow technique was employed to obtain absorbances during reactions; the kinetic experiments were conducted at temperatures varying from 5° to 35°C in aqueous solutions with pH values ranging from 1.5 to 5.2.The kinetic data indicated that the absorbance of a mixed solution increased rapidly in the very early portion of the reaction and then declined slowly in the remaining period. The rate of reaction in the early period was first order with respect to both phenol and ozone concentrations. The rate constant increased with pH value and temperature, and an activation energy of 5.74 K cal/mole was obtained. Further tests showed that the dissolved ozone was consumed completely in the first period and that in the second period the intermediate products were decomposed without depletion of ozone. Catechol, o-quinone, hydroquinone, oxalic acid, humic acid, and a dimer were identified from mass spectra as products of the ozonization reaction.A free radical mechanism, with initiation of an electrophilic reaction for the formation of catechyl radical, has been proposed to explain the experimental data for phenol-ozone reaction in aqueous solutions. According to the proposed mechanism, the reaction path through the attachment to ortho position is much more favorable compared with that through the paraposition because of geometric advantage, though quinones and hydroxyphenol can be formed through parallel paths. The products of reaction detected in this research, therefore, are accountable by this mechanism. A rate equation derived on the basis of this mechanism also agrees well with that observed from the kinetic experiments.
    Additional Material: 8 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 9
    Electronic Resource
    Electronic Resource
    Hoboken, NJ : Wiley-Blackwell
    AIChE Journal 25 (1979), S. 327-332 
    ISSN: 0001-1541
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Process Engineering, Biotechnology, Nutrition Technology
    Notes: The relationship between the shear stress and strain rate of a mixture consisting of solid particles suspended in a Newtonian fluid depends upon the physical properties of the mixture as well as kinematic features of the flow. Functional relationships for rheological properties of mixtures are derived and compared to measured results obtained by previous investigators.
    Additional Material: 4 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 10
    Electronic Resource
    Electronic Resource
    Hoboken, NJ : Wiley-Blackwell
    AIChE Journal 25 (1979), S. 345-351 
    ISSN: 0001-1541
    Keywords: Chemistry ; Chemical Engineering
    Source: Wiley InterScience Backfile Collection 1832-2000
    Topics: Chemistry and Pharmacology , Process Engineering, Biotechnology, Nutrition Technology
    Notes: Residence time distribution measurements in a twin screw extruder are compared with a model based on ideally mixed chambers. Special attention is given to the tail of the distribution. These measurements are compared with the residence time distributions in single screw extruders and an empty pipe.
    Additional Material: 10 Ill.
    Type of Medium: Electronic Resource
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...