ISSN:
0032-3888
Keywords:
Chemistry
;
Chemical Engineering
Source:
Wiley InterScience Backfile Collection 1832-2000
Topics:
Chemistry and Pharmacology
,
Mechanical Engineering, Materials Science, Production Engineering, Mining and Metallurgy, Traffic Engineering, Precision Mechanics
,
Physics
Notes:
It is the objective of this paper to demonstrate the applicability of cold compaction molding followed by a sintering treatment to the processing of polystyrene powders. The influence of pressure, compaction speed, and peak pressure dwell time on the green (as compacted) density and the green tensile strength, as well as the effect of sintering on the tensile strength and dimensional change, were evaluated. The resulting data indicate that room temperature compaction alone is insufficient to provide adequate tensile strength for the compacts. Sintering the green compacts at temperatures of 150 to 173°C markedly improves the tensile strength while simultaneously causing a thickness change in the compacts. This thickness change results from gas evolution, pore shrinkage, and viscoelastic recovery of the residual stresses induced by pressure. For compacts of 0.225 in. thickness, an optimum sintering treatment of 173°C for 30 mins is recommended to provide a tensile strength of 4,000 psi and a thickness change of less than + 7 percent. Coining (repressing) the green compacts does not appreciably affect the sintered strength. However, a finer particle size improves the sintered properties. A review of the literature on the flow behavior of polystyrene suggests that a non-Newtonian viscous flow mechanism is followed by a Newtonian one as sintering progresses.
Additional Material:
13 Ill.
Type of Medium:
Electronic Resource
URL:
http://dx.doi.org/10.1002/pen.760160802
Permalink