ISSN:
1745-6584
Source:
Blackwell Publishing Journal Backfiles 1879-2005
Topics:
Energy, Environment Protection, Nuclear Power Engineering
,
Geosciences
Notes:
Cutoff walls are becoming increasingly attractive options for the control of solute migration from long-term sources of contamination. The main advantage of low permeability enclosures is that they restrict advective transport of solutes away from the source. However, with high concentration source zones surrounded by cutoff walls, there exists the potential for notable mass fluxes outward due to diffusive transport. This paper shows, through the use of the steady-state flux equations, that there is an optimal range of hydraulic conductivities for barrier materials which permit the outward diffusive flux to be counter balanced by an inward advective and dispersive flux. This concept of designing optimum contaminant containment using an inward advective flux to counter the outward diffusive flux is valid for sealable joint sheet pile walls, bentonite-slurry walls and clay liners, but not synthetic membrane materials with extremely low hydraulic conductivities. The effective diffusion coefficient for the common chlorinated organic solvents such as TCE in water-saturated clayey materials is approximately 1 × 10−6 cm2/sec, resulting in an optimum hydraulic conductivity ranging from 1 × 10−6 to 1 × 10−8 cm/sec. This range in hydraulic conductivity is within the range of common barrier materials but not the lowest achievable. The steady-state concentration profile in a slurry cutoff wall can result in a substantial amount of contaminant mass stored within the wall which will need to be considered over the long term or dealt with during site remediation. Large inward advective fluxes reduce the total chemical mass stored within the low permeability barrier material.
Type of Medium:
Electronic Resource
URL:
http://dx.doi.org/10.1111/j.1745-6584.1996.tb02060.x
Permalink