ISSN:
1525-1314
Source:
Blackwell Publishing Journal Backfiles 1879-2005
Topics:
Geosciences
Notes:
Analysis of the precision of the illite ‘crystallinity’technique shows that machine errors are 〈5%, while intra- and inter-sample errors are variable but are up to 12% and 14%, respectively (1σ). Consideration of this error analysis shows that the isocryst approach, which involves close contouring (e.g. 0.03 Δ2°) of illite ‘crystallinity’data, has a very low degree of confidence (〈0.5) and thus is not regarded as statistically valid. If contouring is to be undertaken with a high degree of confidence (〉0.8) it is necessary that contours should be at intervals of 0.1 ΔΘ2°, which is equivalent to subdivision of the anchizone into upper and lower units. Where previous interpretations have relied upon an isocryst method of contouring at less than 0.1 ΔΘ2° the conclusions must be regarded as unsubstantiated.Centrifuge separation of clay fractions (based on a Stokes’law application) gives separations in which a significant, but variable, percentage of grains have long axes greater than the size calculated. For the typical 〈2-μm fraction utilized, some 20% of grains lie in the 2–4-μm range, although the proportion is not believed to have a significant effect upon ‘crystallinity’values. The formula is applicable for grain-sizes down to 0.5 μm. Illite ‘crystallinity’values on samples prepared by an ultrasonic disaggregation method show a small increase on those prepared by ball mill crushing. The differences are minimal at the epi/anchizone level but increase to some 10% at the anchizone/diagenetic level. The effect on grade determinations is again thought to be minimal and indicates that concern over unsuitability of the ultrasonic disaggregation method is unfounded.
Type of Medium:
Electronic Resource
URL:
http://dx.doi.org/10.1111/j.1525-1314.1990.tb00476.x
