ALBERT

Description: The 1992 Nicaragua earthquake was a ‘tsunami earthquake’, which generated tsunamis disproportionately large for its surface wave magnitude Ms = 7.2. Seismological studies and tsunami simulation indicated that the event was a slow earthquake, which occurred on the plate boundary between the subducting Cocos plate and the overriding Caribbean plate. We present a finite element model that enables us to estimate for the first time the temperature and inferred frictional conditions in the rupture area of a tsunami earthquake. Direct and indirect observations are used to constrain all model parameters, and surface heat-flux measurements provide independent information to verify the model results. Furthermore, we used a genetic algorithm to perform a sensitivity analysis of all model parameters and to define the spatial range of thermally defined updip limit of the seismogenic zone. The earthquake nucleated in the seismogenic zone at temperatures of ∼150 °C and propagated updip towards the trench axis. The centroid or centre of mass of moment release was located in a region characterized by temperatures of ∼50 °C. Thus, the rupture propagated through a region where plate motion is normally accommodated by aseismic creep. Our observations support a model in which tsunami earthquakes nucleate in the seismogenic zone near its updip limit. However, in such an environment coupled asperities are perhaps too small to cause large earthquakes. Seamounts, however, are abundant on the incoming Cocos plate. Therefore, in addition to temperature-dependent metamorphic induration of sediments, increased normal stress by seamount subduction may contribute to accumulate stress sufficiently large to release enough energy near the updip limit of the seismogenic zone to promote dynamic slip along a normally aseismic décollement all way to the ocean.