ALBERT

Notes: The deep-tow instrument package of Scripps Institution of Oceanography provides a unique opportunity to delineate small-scale features of a size comparable to those features usually described from ancient deep-sea fan deposits. On Navy Fan, the deep-tow side-scanning sonar readily detected steep channel walls and steps and terraces within channels. The most striking features observed in side-scan are large crescentic depressions commonly occurring in groups. These appear to be large scours or flutes carved by turbidity currents. Four distinct acoustic facies were mapped on the basis of qualitative assessment of reflectivity of 4 kHz reflection profiles. There is a distinct increase in depth of acoustic penetration, number of sub-bottom reflectors, and reflector continuity from the upper fan-valley to the lower fan. These changes are accompanied by a decrease in surface relief.Navy Fan is made up of three active sectors. The active upper fan is dominated by a single channel with prominent levees that decrease in height downstream. The active mid-fan region or suprafan is where sand is deposited. Well defined distributary channels with steps, terraces, and other mesotopography terminate in depositional lobes. Interchannel areas are rough, containing giant scours as well as other relief. The active lower fan accumulates mud and silt and is without resolvable surface morphology.The morphological features seen on Navy Fan other than levees, interchannel areas, and lobes are principally erosional. The distributary channels are up to 0.5 km wide and 5–15 m deep. Such features, because of their large size and low relief, are rarely completely exposed or easily detectable in ancient rock sequences. Some flute-shaped scours are larger than channels in cross section but many are 5-30 m across and 1-2 m deep. If observed in ancient rocks transverse to palaeo-current direction, they would perhaps be indistinguishable from channels. Surface sediment distribution combined with fan morphology can be used to relate modern sediments to facies models for ancient fan sediments. Gravel and sand occur in the upper valley, massive sand beds in the mid-fan distributary channels, classical complete Bouma sequences on depositional lobes, incomplete Bouma sequences (lacking division a) on the lower mid-fan, and Bouma sequence with lenticular shape or other limited extent on mid-fan interchannel areas and on levees.

Notes: Microcrystalline dolomite and related carbonate minerals have been forming throughout the Quaternary in shallow ephemeral alkaline lakes on the coastal plain of the Coorong area in southern Australia. These Coorong dolomites differ significantly from sabkha-type dolomites. They form in areas where evaporation rates during summer months exceed groundwater inflow rates to a series of alkaline lakes. This results in the lakes becoming desiccated during summer months. Brines resulting from this drying phase are then refluxed out of the system into seaward-flowing groundwaters of an unconfined coastal aquifer. Dolomites and other fine-grained carbonates remain behind, whilst saline and sulphate evaporite minerals are flushed out of the system. Progressive restriction by sedimentation in and around the Holocene coastal dolomite lakes results in an upward-shoaling sedimentary cycle. Basal sediments which formed in a restricted marine environment pass upwards to lacustrine dolomites or magnesites exhibiting desiccation and groundwater resurgence structures such as mudcracks and teepees. The upper Proterozoic Skillogallee Dolomite Formation, an early rift basin unit of the Adelaide Supergroup, contains dolomites which show many of the features characteristic of the peculiar groundwater hydrology which plays an important role in Coorong dolomite genesis. These features include aphanitic dolomites which lack relict saline or sulphate evaporite minerals. The Skillogallee Dolomite Formation in some areas overlies an earlier dolomitic unit, informally named the Callanna Beds, typified by abundant pseudomorphs after sulphate minerals. Sabkha style dolomites characterizing the Callanna Beds are replaced up-section by the Coorong-type dolomite of the Skillogallee Dolomite Formation. This implies the development of an increasingly more active groundwater regime. The ultimate source and mode of concentration of the necessary Mg required to form both the modern and ancient dolomites remain imperfectly understood.

Notes: The Encyclopedia of Sedimentology.

Notes: Ten samples from a Late Messinian section measured at Capo Rossello, a few hundred metres laterally from and stratigraphically immediately below the Miocene/ Pliocene boundary stratotype, have been investigated by various techniques: carbonate content, grain-size analysis, loss on ignition, clay mineral composition, frequency of euryhaline ostracods. Two lithological sub-units. with different palaeoenvironmental implications, are recognized. Both sub-units were deposited after the termination of evaporitic conditions, and immediately after deposition of an ash fall tuff. The lower unit is the Congeria marl which yields the ‘lago-mare’faunal assemblage, the autochthony of which is supported by biometrical analysis of Cyprides agrigentina, indicating brackish, shallow-water conditions with Paratethyan affinities, and the upper, the Arenazzolo, a thin sandy unit indicating a higher energy environment whose duration is estimated at some thousand years. Marine faunas yielded by the Arenazzolo are interpreted as allochthonous. Sedimentary structures suggest a littoral setting at the edge of the lake, or a delta lobe.The main environmental change occurs at the base of the immediately overlying Trubi Formation, where open marine conditions indicative of oceanic depths mark the termination of the Messinian salinity crisis.

Notes: An extensive sequence of small patch-reefs occurs within the middle member of the Upper Coralline Limestone Formation (Upper Miocene) in western Malta. In the lower horizons of the Tal Pitkal Member these structures are lensoidal in cross section and are surrounded by coarse flanking biosparites. Towards the top of the member they become more irregular in form. Extensive biostrome developments occur in association with the later structures but unlike the patch-reefs they were killed off periodically by episodes of exposure.The resistance of these structures to wave action is verified by the presence of extensive mollusc borings both in patch-reefs and biostromes. The initial binders within both structures are considered to be stromatolitic algae. Early diagenetic rims were also precipitated around allochems and added further strength to the frame work. Within this framework pelleted micrites accumulated which contrast strongly with the sparite cements of the flanking sediments.The organic framebuilders were finally killed off by a particularly strong episode of submarine erosion, with the subsequent establishment of an oolite shoal over the entire region.

Notes: The Guelph esker (Ontario, Canada) consists of a sinuous, steep-sided and segmented ridge which comprises poorly sorted, matrix-supported sands and gravels. These sands and gravels were probably deposited during the sliding bed stage which has been observed by others in closed-conduit hydraulic experiments. The poor sorting probably resulted from a high concentration of bed-material load in the lower part of a subglacial tunnel, sorting being restricted to that produced by particle collisions. Inclusive graphic standard deviation is characteristically large for the sands and gravels, indicating that virtually all sizes available were in transport. The overall grain size distribution shows a characteristic undulatory shape on arithmetic probability paper, mostly because of selective removal of pebble gravel and granule sizes. This poorly sorted fades is believed to be diagnostic of transport in a subglacial tunnel flowing full of water, and may be used to identify subglacial conditions in other eskers. Deltaic sands and gravels occur downcurrent of the esker and contain a greater diversity of structures; climbing-ripple cross-laminae, parallel laminae and massive structure, deposited in large-scale foresees at the end of a subglacial tunnel. These deltaic sands and gravels grade distally into outwash sands and gravels.

Notes: Generalized curves for grain threshold under liquid flow and under gas flow (air), based on laboratory data summarized in a previous paper, are utilized to generate a series of threshold curves for unusual sedimentary environments and little-studied sedimentary materials of interest to geologists. These are aeolian and water flow threshold on the planet Mars, and the threshold of foraminiferal sands in the deep-sea. Such extrapolations from the generalized curves are necessary because of the difficulty or impossibility of obtaining satisfactory data for these sediments or environments, and the procedures demonstrate the importance of the general threshold curves.

Notes: Three orders of aeolian bounding surface are arranged in a hierarchy based on their extent and regularity.First order surfaces are the most extensive. They are flat-lying bedding planes cutting across all other aeolian structures and are attributed to the passage of the largest aeolian bedforms—draas—across an area. First order surfaces cut across second order surfaces, which are gentle to moderately dipping surfaces bounding sets of cross-strata. Second order surfaces are attributed to the passage of dunes across draas, or to longitudinal dunes migrating across the lower ice slopes of draas. Third order surfaces bound bundles of laminae within coscts of cross laminae and are due either to local fluctuations in wind direction and velocity or to changes in airflow patterns caused by configurational changes in dune patterns. All these bounding surfaces could be explained by wind variations and dune migration, but the rates of dune migration relative to probable sediment deposition rates are incompatible with this general explanation of the form and spacing of the bounding surfaces. The concept of climbing bedforms of different hierarchical order together with subsidence provides a better explanation. Analogous bounding surfaces in aqueous bedforms have already been attributed to climbing bedforms of differing hierarchical order.