ALBERT

Description: The discharges from industrial processes constitute the main source of copper contamination in aqueous ecosystems. In this study we investigated the capacity of different types of biochar (derived from chicken manure, eucalyptus, corncob, olive mill and pine sawdust) to remove copper from aqueous solution in a continuous-flow system. The flow rate of the system strongly influenced the amount of copper retained. The adsorption to the corncob biochar varied from 5.51 to 3.48 mg Cu g-1 as the flux decreased from 13 to 2.5 mL min-1. The physicochemical characteristics of biochar determine the copper retention capacity and the underlying immobilization mechanisms. Biochars with high inorganic contents retain the largest amounts of copper and may be suitable for using in water treatment systems to remove heavy metals. The copper retention capacity of the biochars ranged between ~1.3 and 26 mg g-1 and varied in the following order: chicken manure 〉 olive mill 〉〉 corncob 〉 eucalyptus 〉 sawdust pine.

Description: The majority of methane produced in many anoxic sediments is released via ebullition. These bubbles are subject to dissolution as they rise, and dissolution rates are strongly influenced by bubble size. Current understanding of natural methane bubble size distributions is limited by the difficulty in measuring bubble sizes over wide spatial or temporal scales. Our custom optical bubble size sensors recorded bubble sizes and release timing at 8 locations in Upper Mystic Lake, MA continuously for 3 months. Bubble size distributions were spatially heterogeneous even over relatively small areas experiencing similar flux, suggesting that localized sediment conditions are important to controlling bubble size. There was no change in bubble size distributions over the 3 month sampling period, but mean bubble size was positively correlated with daily ebullition flux. Bubble data was used to verify the performance of a widely used bubble dissolution model, and the model was then used to estimate that bubble dissolution accounts for approximately 10% of methane accumulated in the hypolimnion during summer stratification, and at most 15% of the diffusive air–water–methane flux from the epilimnion.

Description: Laboratory sediment incubations and continuous ebullition monitoring over an annual cycle in the temperate Saar River, Germany confirm that impounded river zones can produce and emit methane at high rates (7 to 30 (g CH4 m–3 d–1) at 25 °C and 270 to 700 (g CH4 m–2 yr–1), respectively). Summer methane ebullition (ME) peaks were a factor of 4 to 10 times the winter minima, and sediment methane formation was dominated by the upper sediment (depths of 0.14 to 0.2 m). The key driver of the seasonal ME dynamics was temperature. An empirical model relating methane formation to temperature and sediment depth, derived from the laboratory incubations, reproduced the measured daily ebullition from winter to midsummer, although late summer and autumn simulated ME exceeded the observed ME. A possible explanation for this was substrate limitation. We recommend measurements of methanogenically available carbon sources to identify substrate limitation and help characterize variation in methane formation with depth and from site to site.

Description: Microplastics (MPs, 〈5 mm) have been reported as emerging environmental contaminants, but reliable data are still lacking. We compared the two most promising techniques for MP analysis, namely, Raman and Fourier transform infrared (FTIR) spectroscopy, by analyzing MPs extracted from North Sea surface waters. Microplastics 〉500 μm were visually sorted and manually analyzed by μ-Raman and attenuated total reflection (ATR)-FTIR spectroscopy. Microplastics ≤500 μm were concentrated on gold-coated filters and analyzed by automated single-particle exploration coupled to μ-Raman (ASPEx-μ-Raman) and FTIR imaging (reflection mode). The number of identified MPs 〉500 μm was slightly higher for μ-Raman (+23%) than ATR-FTIR analysis. Concerning MPs ≤500 μm, ASPEx-μ-Raman quantified two-times higher MP numbers but required a four-times higher analysis time compared to FTIR imaging. Because ASPEx-μ-Raman revealed far higher MP concentrations (38–2621 particles m–3) compared to the results of previous water studies (0–559 particles m–3), the environmental concentration of MPs ≤500 μm may have been underestimated until now. This may be attributed to the exceptional increase in concentration with decreasing MP size found in this work. Our results demonstrate the need for further research to enable time-efficient routine application of ASPEx-μ-Raman for reliable MP counting down to 1 μm.

Description: Water supply of the islands is a global challenge, especially in the countries which have highly indented coastlines with numerous islands. The island of Mljet in Croatia was investigated due to its unique source of water supply: desalination of water from brackish lakes—blatinas—fed by groundwater and connected to the sea by karst conduits. Water sampling and chemical analyses were performed during hydrological minimum and maximum with regard to groundwater levels in 2005/2006 and minimum in 2016. A total of 13 samples were analysed within the study: 10 samples were taken from blatinas, 1 from pit well, and 2 from borehole wells. All waters sampled from the lakes are of Na-Cl type. The seawater percentage in the lakes used to extract feed water for desalination plants, calculated by conservative mixing approach, is relatively low (0.7-9.8%) and varies in correlation with hydrological seasons. Low proportion of seawater is an essential factor of cost minimisation in desalination by the installed reverse osmosis (RO) plants. Daily monitoring of total dissolved solids in the feed water was introduced in May 2016, and its results were analysed in the context of precipitation—a sole source of island aquifer recharge. Maximum concentrations were observed during September and interpreted to be caused by a combination of natural and anthropogenic pressure during the summer tourist season. Minimum concentrations were expected after the rainy season in the cold part of the year but were observed in June instead. Due to a short observation period and untypical distribution of precipitation in the same time interval, the data can only be considered indicative. An unusual pattern of sulphate anion concentrations, which cannot be attributed solely to fresh- and seawater mixing, was observed in one of the blatinas, but its origin could not be determined based on available data. Taking into account all the presented data on groundwater quality, climate change predictions, the connection of water supply system to the mainland and problems with the effluent treatment, it is clear that the main future challenge will be the creation of an island-wide sustainable water management plan followed by continuous monitoring and research.

Description: The cage occupancy plays a crucial role in the thermodynamic stability of clathrate hydrates and is an important quantity for understanding the CO2–CH4 replacement phenomenon. In this work, the occupancy isotherms of pure CH4, pure CO2, and their mixture in sI and sII hydrates are studied by GCMC + MD simulations. The adsorption of CH4 and CO2 + CH4 in the sI and sII hydrates can be categorized as the one-site Langmuir type. The calculated occupancy ratio θL/θS and the abundance ratio of CO2 to CH4 vary with the temperature and pressure, which provide the prerequisite information for the prediction of CH4 recovery yield at different conditions in the CO2–CH4 gas exchange process. The phase equilibria of clathrate hydrates of pure gases and mixtures are explored and the corresponding heat of dissociation and hydration numbers are determined. The current investigation provides new perspectives to understand the mechanism behind the gas adsorption behavior of clathrate hydrates.