ALBERT

Description: One of the most puzzling characteristics of sea-floor morphology is the occurrence of anomalously shallow, fracture-zone–parallel, oceanic transverse ridges. A model is proposed for the formation of transverse ridges near lat 21° and 24°N on the Mid-Atlantic Ridge in which the differential responses of large-offset and small-offset fracture zones to recent changes in spreading direction result in the generation of normal faults that coincide with the off-axis traces of fracture zones. Numerical models of the flexural response of the lithosphere to normal faulting suggest that modest amounts of extension (〈5 km) along low-angle faults (〈45°) are responsible for the transverse ridges.

Description: The early breakup of western Pangea has been investigated by mapping the pattern of fracture zones and distribution of seismic reflectors within the sedimentary cover of the Atlantic between the Cape Verde Islands and the equator. Two distinct sets of transverse oceanic lineaments are present, separated by the Guinea Fracture Zone near lat 10°N. Lineaments to the north are associated with the formation of the central Atlantic in the Late Jurassic and Early Cretaceous; those in the south relate to the Cretaceous opening of the South Atlantic. The Guinea Fracture Zone is thus the conjugate of the Jurassic transform boundary under peninsular Florida, which linked the Atlantic with the Gulf of Mexico. The distribution of dated seismic reflectors suggests that deposition of deep-water sediments was confined to the region north of the Guinea transform until Aptian time, when the Sierra Leone Basin began to open. The latter started to widen at least 15 m.y. after the initiation of the Cape Basin off southwest Africa, an age difference that can be explained if a short-lived plate boundary developed in either Africa or South America during the Early Cretaceous. Neither the trends of the equatorial fracture zones nor the seismic stratigraphy supports the existence of a predrift gap between west Africa and Brazil.

Description: Logs collected while drilling measured density in situ, through the accretionary prism and decollement zone of the northern Barbados Ridge. Consolidation tests relate void ratio (derived from density) to effective stress and predict a fluid pressure profile, assuming that the upper 100 m of the prism is at a hydrostatic pressure gradient. The calculated fluid pressure curve rises to 〉90% of lithostatic below thrusts in the prism, presumably due to the increase in overburden and lateral tectonic loading. Thin (0.5–2.0 m) intervals of anomalously low density and resistivity in the logs through the basal decollement zone suggest dilation and perhaps hydrofracturing. A peak in hydraulic head in the upper half of the decollement zone requires lateral influx of fluid, a conclusion consistent with previous geochemical studies. Although the calculated fluid-pressure profile is model dependent, its inherent character ties to major structural features.

Description: One method of testing the concept of sequence stratigraphy is to compare it to Quaternary sediments in which chronology, stratigraphic relations, and facies geometry are more clearly understood than in older rocks. Rapid deposition rates during Quaternary glacial-eustatic cycles in large deltaic depocenters generate sequences comparable to those in the ancient stratigraphic record. In the northern Gulf of Mexico, the late Wisconsinan-Holocene Mississippi River has deposited a Type 1 sequence that includes lowstand, transgressive, and high-stand systems tracts. Characteristics of modern Mississippi River sedimentary environments support the methodology used in sequence analysis, but the short time taken for sequence generation here raises important questions about sequence time scales, correlation, and driving mechanisms.

Description: Logs collected while drilling measured density in situ, through the accretionary prism and decollement zone of the northern Barbados Ridge. Consolidation tests relate void ratio (derived from density) to effective stress and predict a fluid pressure profile, assuming that the upper 100 m of the prism is at a hydrostatic pressure gradient. The calculated fluid pressure curve rises to 〉90% of lithostatic below thrusts in the prism, presumably due to the increase in overburden and lateral tectonic loading. Thin (0.5–2.0 m) intervals of anomalously low density and resistivity in the logs through the basal decollement zone suggest dilation and perhaps hydrofracturing. A peak in hydraulic head in the upper half of the decollement zone requires lateral influx of fluid, a conclusion consistent with previous geochemical studies. Although the calculated fluid-pressure profile is model dependent, its inherent character ties to major structural features.

Description: The interrelation between deformation styles and behavior of fluids in accretionary prisms is under debate, particularly the possibility that overpressuring within the basal decollement may enable mechanical decoupling of the prism from the subducting material. Anisotropy of magnetic susceptibility (AMS) data from sediments spanning the basal decollement of the Barbados accretionary prism show a striking progression across this structure that strongly supports the hypothesis that it is markedly overpressured. In the accretionary prism, above the decollement, the minimum AMS axes are subhorizontal and oriented nearly east-west, whereas the maximum AMS axes are oriented nearly north-south and shallowly inclined. At the top of the decollement, the minimum AMS axes orientations abruptly change to nearly vertical; this orientation is maintained throughout the decollement and in the underthrust sediments below. The AMS orientations in the prism sediments above the decollement are consistent with lateral shortening due to regional tectonic stress, as the minimum axes generally parallel the convergence vector of the subducting South American plate and the maximum axes are trench-parallel. Because the orientations of the AMS axes in deformed sediments usually parallel the orientations of the principal strains, the AMS results indicate that the incremental strain state in the Barbados prism is one dominated by subhorizontal shortening. In contrast, the AMS axes within and below the decollement are consistent with a strain state dominated by vertical shortening (compaction). This abrupt change in AMS orientations at the top of the decollement at Site 948 is a direct manifestation of mechanical decoupling of the off-scraped prism sediments from the underthrust sediments. The decoupling horizon occurs at the top of the decollement zone, coinciding with the location of flowing, high-pressure fluids.

Description: The upper Quaternary pyroclastic flow deposits of Laacher See volcano show compositional and structural facies variations on four different scales: (1) eruptive units of pyroclastic flows, composed of many flow units; (2) depositional cycles of as many as five flow units; flow units containing (3) regional intraflow-unit facies; and (4) local intraflow-unit subfacies. These facies can be explained by successively overlapping processes beginning in the magma column and ending with final deposition. The pyroclastic flow deposits thus reflect major aspects of the eruptive history of Laacher See volcano: (a) drastic changes in eruptive mechanism due to increasing access of water to the magma chamber and (b) change in chemical composition and crystal and gas content as evacuation of a compositionally zoned magma column progressed. The four scales of facies result from four successive sets of processes: (1) differentiation in the magma column and external factors governing the mechanism of eruption; (2) temporal variations of factors inducing eruption column collapse; (3) physical conditions in the eruption column and the way in which its collapse proceeds; and (4) interplay of flow-inherent and morphology-induced transport mechanics.

Description: Cellular nutrient ratios are often applied as indicators of nutrient limitation in phytoplankton studies, especially the so-called Redfield ratio. For periphyton, similar data are scarce. We investigated the changes in cellular C: N: P stoichiometry of benthic microalgae in response to different levels and types of nutrient limitation and a variety of abiotic conditions in laboratory experiments with natural inocula. C: N ratios increased with decreasing growth rate, irrespective of the limiting nutrient. At the highest growth rates, the C: N ratio ranged uniformly around 7.5. N: P ratios 〈13 indicated N limitation, while N: P ratios 〉22 indicated P limitation. Under P limitation, the C: P ratios increased at low growth rate and varied around 130 at highest growth rates. For a medium with balanced supply of N and P, an optimal stoichiometric ratio of C: N: P = 119 : 17 : 1 could be deduced for benthic microalgae, which is slightly higher than the Redfield ratio (106 : 16 : 1) considered typical for optimally growing phytoplankton. The optimal ratio was stable against changes in abiotic conditions. In conclusion, cellular nutrient ratios are proposed as an indicator for nutrient status in periphyton.

Description: Scaled sandbox experiments with high basal friction, simulating the growth of accretionary wedges, display cycles alternating between frontal imbricate thrusting and underthrusting of long, undeformed sheets. By contrast, low basal friction experiments with otherwise similar and constant, initial conditions produce a classic frontal imbricate fan through repeated failure along frontal thrusts. The cyclical behavior observed in high basal friction experiments is expressed by three quantities: (1) the average spacing between frontal thrusts, (2) the advance and retreat of the deformation front, and (3) the frontal slope (Alpha) of the actively deforming wedge. As a long sheet is underthrust, the front is steepened through slumping until the maximum critical angle is reached. Then frontal thrusting resumes and the accretion of imbricate slices builds the wedge forward, thereby lowering the taper to the minimum critical angle. At shallow tapers, a long unit is underthrust and subsequently uplifts, shortens, and steepens the overlying wedge through backthrust deformation, thus completing the cycle. Underthrusting of long units offers a simple mechanism for underplating overlying units. It also provides a possible explanation for temporally and spatially varying wedge geometries in nature, when basal frictions attain 80%–90% of the internal friction.

Description: High-resolution records of carbon and oxygen isotopes and benthic foraminiferal accumulation rates for the Eocene-Oligocene section at Ocean Drilling Program Site 689(Maud Rise, Weddell Sea; paleodepth about 1500 m) were used to infer variations in paleoproductivity in relation to changes in climate and ventilation of the deeper-water column. The benthic foraminiferal abundance and isotope records show short-term fluctuations at periodicities of 100 and 400 ka, implying orbitally driven climatic variations. Both records suggest that intermediate-depth water chemistry and primary productivity changed in response to climate. During the Eocene, productivity increased during cold periods and during cold-to-warm transitions, possibly as a result of increased upwelling of nutrient-rich waters. In the Oligocene, in contrast, productivity maxima occurred during intervals of low d18O values (presumably warmer periods), when a proto–polar front moved to the south of the location of Site 689. This profound transition in climate-productivity patterns occurred around 37 Ma, coeval with rapid changes toward increasing variability of the oxygen and carbon isotope and benthic abundance records and toward larger-amplitude d18O fluctuations. Therefore, we infer that, at this time, temperature fluctuations increased and a proto–polar front formed in conjunction with the first distinct pulsations in size of the Antarctic ice sheet. We speculate that this major change might have resulted from an initial opening of the Drake Passage at 37 Ma, at least for surface- and intermediate-water circulation.