ALBERT

Description: Analyses by atomic absorption spectrophotometry and spark-source mass spectrography of 25 basal metalliferous sediment units from widely spaced locations on the western flank of the East Pacific Rise show that the deposits are enriched relative to normal pelagic sediment in Fe, Mn, Ni, Cu, Pb, Zn, and many trace elements. The elements are partitioned differently between the various mineralogic constituents of the sediment, with Fe and Mn largely in separate phases and many of the remaining elements primarily associated with reducible ferromanganese oxide minerals but also with iron minerals and other phases. Most of the iron in the deposits is probably of volcanic origin, and much of the manganese and minor elements is derived from sea water. The bulk composition of the deposits varies with age; this is thought to be due to variations in the incidence of volcanic activity at the East Pacific Rise crest where the deposits were formed.

Description: It is believed that C4 to C7 hydrocarbons in petroleum are formed by the cracking of organic matter at depths generally exceeding 1,000 m at temperatures in excess of 50 °C (Cordel, 1972; Dow, 1974; Tissot et al., 1974)). Also, none of the alkanes in the butane-heptane range are formed biologically as far as is known at present. Consequently, it is thought that they do not occur in shallow, Recent sediments. In 1962, I analysed 22 samples of Recent sediments from 7 different environments and verified that these hydrocarbons were not present at the p.p.m. level (Dunton and Hunt, 1962) although traces of a few hydrocarbons such as butane, isobutane, isopentane and n-heptane have been found (Sokolov, 1957; Veber and Turkeltaub, 1958; Erdman et al., 1958; Emery and Hoggan, 1958). No identification of individual hexanes or heptanes has been reported except when there has been clear evidence of seepage from deeper source sediments (McIver, 1973).

Description: Analysis of manganese in sediments of the equatorial Pacific.

Description: The concentrations of Sc, Ti, Fe, Mn, Co, Ni, Cu, La, Th and U have been measured in several Pacific pelagic clays having widely different accumulation rates, 0.4-9.0 mm/103 yr. The authigenic fractions and deposition rates of these elements have been estimated from the measured concentrations using various models. The results show that in Pacific clays about 90% Mn, 80% Co and Ni and 50% Cu are authigenic whereas the major fraction (〉90%) of Sc, Ti, Fe, La, Th and U are of detrital origin. Anticorrelation between the clay accumulation rates and the concentrations of Mn, Co, Ni and Cu is observed. This suggests a uniform authigenic deposition of these elements superimposed on varying amounts of detrital materials. The concentrations of Sc, Ti and Th are almost independent of sedimentation rates, indicating that their authigenic deposition is small compared to their detrital contribution. Comparison of the authigenic deposition and river input rates shows that Mn, Co and Ni are accumulating in excess of their supply by factors of 2-10, whereas the converse is true for Cu and U. Additional sources to account for the budgetary discrepancies of Mn, Co and Ni are discussed, with particular reference to in situ leaching of detrital phases transported to the oceans via rivers.

Description: The uranium content of glass from chilled margins of oceanic tholeiitic basalt flows is generally 〈0.1 ppm, even for old samples with highly altered crystalline interiors. Such low values represent the original whole rock concentrations, although subsequent to eruption low-temperature weathering has added uranium, and other elements, to the crystalline portions of these basalts. Consideration of the K/U ratios of altered samples suggests that basalt weathering may provide the major oceanic sink for these two elements.

Description: Accumulation rates of Mg, Al, Si, Mn, Fe, Ni, Cu, Zn, opal, and calcium carbonate have been calculated from their concentrations in samples from equatorial Deep Sea Drilling Project sites. Maps of element accumulation rates and of Q-mode factors derived from raw data indicate that the flux of trace metals to equatorial Pacific sediments has varied markedly through time and space in response to changes in the relative and absolute influence of several depositional influences: biogenic, detrital, authigenic, and hydrothermal sedimentation. Biologically derived material dominates the sediment of the equatorial Pacific. The distributions of Cu and Zn are most influenced by surface-water biological activity, but Ni, Al, Fe, and Mn are also incorporated into biological material. All of these elements have equatorial accumulation maxima similar to those of opal and calcium carbonate at times during the past 50 m.y. Detritus distributed by trade winds and equatorial surface circulation contributes Al, non-biogenic Si, Fe, and Mg to the region. Detrital sediment is most important in areas with a small supply of biogenic debris and low bulk-accumulation rates. Al accumulation generally increases toward the north and east, indicating its continental source and distribution by the northeast trade winds. Maxima in biological productivity during middle Eocene and latest Miocene to early Pliocene time and concomitant well-developed surface circulation contributed toward temporal maxima in the accumulation rates of Cu, Zn, Ni, and Al in sediments of those ages. Authigenic material is also important only where bulk-sediment accumulation rates are low. Ni, Cu, Zn, and sometimes Mn are associated with this sediment. Fe is almost entirely of hydrothermal origin. Mn is primarily hydrothermal, but some is probably scavenged from sea water by amorphous iron hydroxide floes along with other elements concentrated in hydrothermal sediments, Ni, Cu, and Zn. During the past 50 m.y. all of these elements accumulated over the East Pacific Rise at rates nearly an order of magnitude higher than those at non-rise-crest sites. In addition, factor analysis indicates that some of this material is carried substantial distances to the west of the rise crest. Accumulation rates of Fe in basal metalliferous sediments indicate that the hydrothermal activity that supplied amorphous Fe oxides to the East Pacific Rise areas was most intense during middle Eocene and late Miocene to early Pliocene time.