ALBERT

Notes: The impure marbles of the internal Sesia-Lanzo Zone underwent a multi-stage metamorphic evolution of Alpine age and retain early-Alpine eclogitic assemblages, partially recrystallized under blueschist to greenschist facies conditions. These high-P assemblages consist of carbonates, phengite, quartz, omphacite, grossular-rich (locally spessartinic) garnet, zoisite and Al-rich titanite. Retrogressive stages are characterized by the growth of glaucophane, paragonite, phlogopite, tremolite and albite. Halogen-rich biotite and amphibole are also present. P-T estimates of the early-Alpine metamophism have been calculated from these unique high-P assemblages, in order to test the applicability of some calibrations to impure carbonate systems. In particular, some Gt-Cpx calibrations and the phengite geobarometer give results (T= 575 ± 45° C at 15 kbar for the eclogitic climax and T≤ 500° C at PH2O ≤ 9 kbar for early-Alpine retrogressive stages) which are within the range obtained from the surrounding lithologies.Phase relationships in P-T-XCO2 space indicate that mineral assemblages in the impure marbles coexisted with H2O-rich fluids (XCO2 〈0.03) during their entire Alpine evolution.

Notes: Analysis of the precision of the illite ‘crystallinity’technique shows that machine errors are 〈5%, while intra- and inter-sample errors are variable but are up to 12% and 14%, respectively (1σ). Consideration of this error analysis shows that the isocryst approach, which involves close contouring (e.g. 0.03 Δ2°) of illite ‘crystallinity’data, has a very low degree of confidence (〈0.5) and thus is not regarded as statistically valid. If contouring is to be undertaken with a high degree of confidence (〉0.8) it is necessary that contours should be at intervals of 0.1 ΔΘ2°, which is equivalent to subdivision of the anchizone into upper and lower units. Where previous interpretations have relied upon an isocryst method of contouring at less than 0.1 ΔΘ2° the conclusions must be regarded as unsubstantiated.Centrifuge separation of clay fractions (based on a Stokes’law application) gives separations in which a significant, but variable, percentage of grains have long axes greater than the size calculated. For the typical 〈2-μm fraction utilized, some 20% of grains lie in the 2–4-μm range, although the proportion is not believed to have a significant effect upon ‘crystallinity’values. The formula is applicable for grain-sizes down to 0.5 μm. Illite ‘crystallinity’values on samples prepared by an ultrasonic disaggregation method show a small increase on those prepared by ball mill crushing. The differences are minimal at the epi/anchizone level but increase to some 10% at the anchizone/diagenetic level. The effect on grade determinations is again thought to be minimal and indicates that concern over unsuitability of the ultrasonic disaggregation method is unfounded.

Notes: The amphibolite facies Puolankajärvi Formation (PjF) occupies the western margin of the Early Proterozoic Kainuu Schist Belt (KSB) of northern Finland. The lower and middle parts of the PjF consist of turbiditic psammites and pelites and tempestitic semipelites. This report concentrates on the pelitic lithologies which include quartz–two-mica–plagioclase schists with variable amounts of garnet, staurolite, andalusite and biotite porphyroblasts as well as sillimanite and cordierite segregations.The KSB forms a major north–south-trending synclinorium between two Archaean blocks. It contains both autochthonous and allochthonous units and is cut by faults and shear zones. The PjF lies on the western side of the KSB and is probably allochthonous. The formation has undergone six major deformation phases (D1, D2, D3a, D3b, D4 and D5). During D3a-D5 the maximum principal stress (σ1) changed in a clockwise direction from south-west to north-east. Between D2 and D3 the intermediate principal stress (σ2) changed from horizontal to vertical and the interval between D2 and D3 marks a transition from thrust to strike-slip tectonics.Relict structures in the porphyroblasts indicate the following mineral growth–deformation evolution in the PjF. (1) Throughout the PjF there was a successive crystallization of garnet (syn-D1), poryphyroblastic biotite (inter-D3/4) and staurolite (inter-D3/4) during the pre-D4 stage. (2) A syn-D4-inter-D4/5 crystallization of kyanite, sillimanite (fibrolite), porphyroblastic tourmaline, magnetite, rutile, cordierite and muscovite–biotite–plagioclase pseudomorphs after staurolite was most localized at and near D4 shear zones. (3) A syn- to post-D5 generation of andalusite, ilmenohematite and sheet silicates after staurolite and after cordierite occurred near D5 faults.The evolution outlined here permits the relative dating of the PjF parageneses, which is used in the second part of the study (Tuisku & Laajoki, 1990), and, together with the knowledge of the pressure–temperature conditions during various growth events, makes it possible to compile pressure–temperature–deformation paths for the PjF.

Notes: Abstract Microprobe analyses of feldspars in granite mylonites containing flame perthite give compositions that invariably plot as three distinct clusters on a ternary feldspar diagram: orthoclase (Or92–97), albite and oligoclase-andesine. The albite occurs as grains in the matrix, as flame-shaped lamellae in orthoclase, and in patches within plagioclase grains.We present a metamorphic model for albite flame growth in the K-feldspar in these rocks that is related to reactions in plagioclase, rather than alkali feldspar exsolution. Flame growth is attributed to replacement and results from a combination of two retrograde reactions and one exchange reaction under greenschist facies conditions. Reaction 1 is a continuous or discontinuous (across the peristerite solvus) reaction in plagioclase, in which the An component forms epidote or zoisite. Most of the albite component liberated by Reaction 1 stays to form albite in the host plagioclase, but some Na migrates to form the flames within the K-feldspar. Reaction 2 is the exchange of K for Na in K-feldspar. Reaction 3 is the retrograde formation of muscovite (as ‘sericite’) and has all of the chemical components of a hydration reaction of K-feldspar. The Si and Al made available in the plagioclase from Reaction 1 are combined with the K liberated from the K-feldspar, to produce muscovite in Reaction 3. The muscovite forms in the plagioclase, rather than the K-feldspar, as a result of the greater mobility of K relative to Al. The composition of the albite flames is controlled by both the peristerite and the alkali feldspar miscibility gaps and depends on the position of these solvi at the pressure and temperature that existed during the reaction. Using an initial plagioclase composition of An20, the total reaction can be summarized as:20 oligoclase + 1 K-feldspar + 2 H2O = 2 zoisite + muscovite + 2 quartz + 15 albiteplagioclase+ 1 albiteflame.This model does not require that any additional feldspar framework be accreted at replacement sites: Na and K are the only components that must migrate a significant distance (e.g. from one grain to the next), allowing Al to remain within the altering plagioclase grain. The resulting saussuritization is isovolumetric.The temperature and extent of replacement depends on when, and how much, water infiltrates the rock. The fugacity of the water, and therefore the pressure of the fluid, may have been significantly lower than lithostatic during flame growth.

Notes: Abstract In metapelitic schists of the north-eastern Weekeroo Inliers, Olary Block, Willyama Supergroup, South Australia, syn-S1 and syn-S2 assemblages involving staurolite, garnet, biotite and another mineral, most probably cordierite, were overgrown by large syn-S3 andalusite porphyroblasts, owing to isobaric heating from metamorphic conditions that existed during the development of S2. Conditions during the development of S3 probably just reached the andalusite—sillimanite transition. During the development of S4, at somewhat lower temperatures than those that accompanied the development of S3, the following reaction occurred:staurolite + chlorite + muscovite ± biotite + andalusite + quartz + H2O.The amount of retrogression is controlled primarily by the amount of H2O added by infiltration. As the syn-S3 matrix assemblage was stable during the development of S4, but the andalusite porphyroblasts were no longer stable with the matrix when H2O was added, the retrogression is focused in and around the porphyroblasts. With enough H2O available, and if quartz was consumed before biotite in a porphyroblast, then the following reaction occurred:staurolite + chlorite + muscovite + corundum ± biotite + andalusite + H2O.This reaction allowed corundum inclusions in the andalusite to grow, regardless of the presence of quartz in the matrix assemblage.

Notes: Abstract Effects of post-entrapment fluid-inclusion modification are examined with reference to retrogression-related quartz veins from the Caledonian, Øse Thrust, northern Norway. The inclusions occur in secondary trails, and contain high-density hypersaline aqueous fluids. On morphological characteristics, they are subdivided into, Type A: elongate, ellipsoidal and/or irregular inclusions, and Type B: more equant, regular, and/or negative crystal form. With reference to previous research on post-entrapment modification of inclusions in quartz it is proposed that Type A inclusions experienced little or no post-entrapment modification, whereas Type B inclusions show features characteristic of post-entrapment permanent inelastic stretching and/or leakage. This produces increased homogenization temperatures (Th), associated with increased inclusion volume and lowering of density, whilst maintaining constant salinity. The similarity of data for degree of fill and salinity between Type A and Type B inclusions indicates that Type B inclusions have primarily modified by stretch rather than leakage. However, the spread towards slightly larger volume of vapour in Type B inclusions suggests that some leakage has also occurred. Because stretched and/or partially leaked inclusions have increased Th, isochore projections significantly underestimate trapping pressure (Pt) relative to unmodified inclusions. Therefore, recognition of post-entrapment inclusion modification due to overpressure is crucial to avoid misinterpretation of data, but has considerable potential for constraining the detail of P-T trajectories of individual rocks. On this basis, rocks from the Øse Thrust zone, north Norway, are shown to have experienced rapid uplift on a ‘clockwise’P-T-t path during the final stages of Caledonian (Scandian) orogenesis.

Notes: Abstract The Erzgebirge Crystalline Complex (ECC) is a rare example where both‘crustal’eclogites and mantle-derived garnet-bearing ultramafic rocks (GBUs) occur in the same tectonic unit. Thus, the ECC represents a key complex for studying tectonic processes such as crustal thickening or incorporation of mantle-derived material into the continental crust. This study provides the first evidence that high-pressure metamorphism in the ECC is of Variscan age. Sm-Nd isochrons define ages of 333 ± 6 (Grt-WR), 337± 5 (Grt-WR), 360± 7 (Grt-Cpx-WR) (eclogites) and 353 ± 7 Ma (Grt-WR) (garnet-pyroxenite). 40Ar/39Ar spectra of phengite from two eclogite samples give plateau ages of 348 ± 2 and 355 ± 2 Ma. The overlap of ages from isotopic systems with blocking temperatures that differ by about 300 ° C indicates extremely fast tectonic uplift rates. Minimum cooling rates were about 50° C Myr-1. As a consequence, the closure temperature of the specific isotopic system is of minor importance, and the ages correspond to the time of high-pressure metamorphism. Despite textural equilibrium and metamorphic temperatures in excess of 800° C, clinopyroxene, garnet and whole rock do not define a three-point isochron in three of four samples. The metamorphic clinopyroxenes seem to have inherited their isotopic signature from magmatic precursors. Rapid tectonic burial and uplift within only a few million years might be the reason for the observed Sm-Nd disequilibrium. The εNd values of the eclogites (+4.4 to +6.9) suggest the protoliths were derived from a long-term depleted mantle, probably a MORB source, whereas the isotopically enriched garnet-pyroxenite (εNd–2.9) might represent subcontinental mantle material, emplaced into the crust prior to or during collision. The similarity of ages of the two different rock types suggests a shared metamorphic history.

Notes: Abstract The crystalline core of the Himalayan orogen in the Langtang area of Nepal, located between the Annapurna-Manaslu region and the Everest region, contains middle to upper amphibolite grade pelitic gneisses and schists. These rocks are intimately associated with the Main Central Thrust (MCT), one of the major compressional structures in the northern Indian plate, which forms a 3.7-km-wide zone containing rocks of both footwall and hangingwall affinity. An inverted metamorphic gradient is noticeable from upper footwall through hangingwall rocks, where metamorphic conditions increase from garnet grade near the MCT zone to sillimanite + K-feldspar grade in the upper hangingwall. Petrographic data distinguish two metamorphic episodes that have affected the area: a high-pressure, moderate-temperature episode (M1) and a moderate-pressure, high-temperature episode (M2). Comparison with appropriate reaction boundaries suggests that conditions for M1 in the hangingwall were approximately 900–1200 MPa and 425–525°C. Thermobarometric results for 24 samples from the footwall, MCT zone and hangingwall reflect P-T conditions during the M2 phase of 400–1200 MPa and 490–660° C. The decrease in estimated palaeopressures from footwall to hangingwall approximate a lithostatic gradient of 27 MPa km-1, with slight fluctuations in the MCT zone reflecting structural discontinuities. In contrast to the palaeopressures, palaeotemperatures are indistinguishable across the entire area sampled. Although field evidence suggests the presence of the inverted palaeothermal gradient well known in the Himalaya, quantitative thermobarometry indicates that temperatures of final equilibration were all within error of each other across 17 km of section. At Langtang, change in pressure is responsible for the presence of the sequence of index minerals through the section. I interpret these data to reflect diachronous attainment of equilibrium temperature conditions in a lithostatic palaeopressure profile after ductile faulting of the sequence.