ALBERT

Description: Seafloor topography is neither spatially homogeneous, nor does it obey Gaussian statistics; deviations from both of these assumptions are important from a geological and acoustic point of view. It has been found that the distribution of topographic slopes can be used as a primary tool for understanding the sources and extent of spatial heterogeneities and patterns on the seafloor. The covariance function has been widely used to characterize seafloor topography, but requires the assumption of Gaussian joint probability statistics to be valid. For heterogeneous topography characterized by large transient signals such as steep scarps and volcanoes, the covariance becomes dominated by the transients; in contrast the family slope distributions can still be used to derive stable descriptors for regions with large transient signals, as well as regions containing asymmetric features, and regions with only limited sampling. Knowledge of slopes is useful because a direct relation exists between the covariance and the slope distributions at different spatial scales. Studies of the slope distribution provide a means of identifying the presence of the non‐Gaussian elements in the topography, and flagging their spatial locations. The methods used here are demonstrated by applying them to three small patches of topography located within 20 km of each other in the Eastern Pacific. It is found that dominant azimuthal directions and dip angles differ widely between the patches. In addition, asymmetries in the cross‐sectional shapes of faulted abyssal hills are documented. [Work supported by ONR.]

Description: High‐frequency bottom acoustic and geoacoustic data from three well‐characterized sites of different bottom composition are compared with scattering models in order to clarify the roles played by interface roughness and sediment volume inhomogeneities. Model fits to backscattering data from two silty sites lead to the conclusion that scattering from volume inhomogeneities was primarily responsible for the observed backscattering. In contrast, measured bottom roughness was sufficient to explain the backscattering seen at a sandy site. Although the sandy site had directional ripples, the model and data agree in their lack of anisotropy.

Description: Tables for the speed of sound in sea water are presented. These tables have been prepared from an empirical formula which was derived to fit measured sound‐speed data obtained over the temperature range −3°C to 30°C, the pressure range 1.033 kg/cm2 to 1000 kg/cm2, and the salinity range 33‰ to 37‰. The discrepancy of −3.0 m/sec found by Del Grosso at 1 atm., as compared to the tables of Kuwahara, is substantiated. In addition, the pressure coefficient of sound speed observed in the present work differs from that predicted by Kuwahara.

Description: In this study, the impact of oceanic data assimilation on ENSO simulations and predictions is investigated. The authors’ main objective is to compare the impact of the assimilation of sea level observations and three-dimensional temperature measurements relative to each other. Three experiments were performed. In a control run the ocean model was forced with observed winds only, and in two assimilation runs three-dimensional temperatures and sea levels were assimilated one by one. The root-mean-square differences between the model solution and observations were computed and heat content anomalies of the upper 275 m compared to each other. Three ensembles of ENSO forecasts were performed additionally to investigate the impact of data assimilation on ENSO predictions. In a control ensemble a hybrid coupled ocean–atmosphere model was initialized with observed winds only, while either three-dimensional temperatures or sea level data were assimilated during the initialization phase in two additional forecast ensembles. The predicted sea surface temperature anomalies were averaged over the eastern equatorial Pacific and compared to observations. Two different objective skill measures were computed to evaluate the impact of data assimilation on ENSO forecasts. The authors’ experiments indicate that sea level observations contain useful information and that this information can be inserted successfully into an oceanic general circulation model. It is inferred from the forecast ensembles that the benefit of sea level and temperature assimilation is comparable. However, the positive impact of sea level assimilation could be shown more clearly when the forecasted temperature differences rather than the temperature anomalies themselves were compared with observations.

Description: The seasonal cycle over the tropical Pacific simulated by 11 coupled ocean–atmosphere general circulation models (GCMs) is examined. Each model consists of a high-resolution ocean GCM of either the tropical Pacific or near-global means coupled to a moderate- or high-resolution atmospheric GCM, without the use of flux correction. The seasonal behavior of sea surface temperature (SST) and eastern Pacific rainfall is presented for each model. The results show that current state-of-the-art coupled GCMs share important successes and troublesome systematic errors. All 11 models are able to simulate the mean zonal gradient in SST at the equator over the central Pacific. The simulated equatorial cold tongue generally tends to be too strong, too narrow, and extend too far west. SSTs are generally too warm in a broad region west of Peru and in a band near 10°S. This is accompanied in some models by a double intertropical convergence zone (ITCZ) straddling the equator over the eastern Pacific, and in others by an ITCZ that migrates across the equator with the seasons; neither behavior is realistic. There is considerable spread in the simulated seasonal cycles of equatorial SST in the eastern Pacific. Some simulations do capture the annual harmonic quite realistically, although the seasonal cold tongue tends to appear prematurely. Others overestimate the amplitude of the semiannual harmonic. Nonetheless, the results constitute a marked improvement over the simulations of only a few years ago when serious climate drift was still widespread and simulated zonal gradients of SST along the equator were often very weak.

Description: Seismic data are usually acquired and processed for imaging reflections. This paper describes a method of processing seismic data for imaging discontinuities (e.g., faults and stratigraphic features). One application of this nontraditional process is a 3-D volume, or cube, of coherence coefficients within which faults are revealed as numerically separated surfaces. Figure 1 compares a traditional 3-D reflection amplitude time slice with the results of the new method. To our knowledge, this is the first published method of revealing fault surfaces within a 3-D volume for which no fault reflections have been recorded.

Description: Two sets of equations, covering all world oceans and seas, are presented to calculate pressure from depth for the computation of sound speed, and depth from pressure for use in ocean engineering. They are based on the algorithm of UNESCO 1983 [N. P. Fofonoff and R. C. Millard, Jr., Unesco Tech. Papers in Mar. Sci. No. 44 (1983)], and on calculations from temperature and salinity profiles. The pressure to depth conversion is presented first. The equations can be used in those cases where the desired accuracy is reduced to ±0.8 m. The equations to convert depth to pressure provide an overall accuracy between ±8000 Pa and ±1000 Pa. This leads to errors in sound speed consistently smaller than ±0.02 m/s. The discussion, and comparisons with results and other formulas, suggest that the new equations are a substantial improvement on the previous simplified ones, which should now be abandoned.

Description: Attributes have proliferated recently with different selections available on different workstations. What do they all mean? When do we use one and when another? The answers to these questions are not easy but the first step is to understand what our options are, and herein lies the purpose of this article.

Description: In this paper the performance of the global coupled general circulation model (CGCM) ECHO-2, which was integrated for 10 years without the application of flux correction, is described. Although the integration is rather short, strong and weak points of this CGCM can be clearly identified, especially in view of the model's performance of the annual cycle in the tropical Pacific. The latter is simulated with more success relative to the earlier version, ECHO-I. A better representation of the low-level stratus clouds in the atmosphere model associated with a reduction in the shortwave radiative flux at the air-sea interface improved the coupled model's performance in the southeastern tropical oceans, with a strongly reduced warm bias in these regions. Modifications in the atmospheric convection scheme also eliminated the AGCM's tendency to simulate a double ITCZ, and this behavior is maintained in the CGCM simulation. Finally, a new numerical scheme for active tracer advection in the ocean model strongly reduced the numerical mixing, which seems to enhance considerably the level of interannual variability in the equatorial Pacific. One weak point is an overall cold bias in the Tropics and midlatitudes, which typically amounts to 1°C in open ocean regions. Another weak point is the still too strong equatorial cold tongue, which penetrates too far into the western equatorial Pacific. Although this model deficiency is not as pronounced as in ECHO-1, the too strong cold tongue reduces the level of interannual rainfall variability in the western and central equatorial Pacific. Finally, the interannual fluctuations in equatorial Pacific sea surface temperatures (SSTs) are too equatorially trapped, a problem that is also found in ocean-only simulations. Overall, however, the authors believe that the ECHO-2 CGCM has been considerably improved relative to ECHO-1.