ALBERT

All Library Books, journals and Electronic Records Telegrafenberg

Your email was sent successfully. Check your inbox.

An error occurred while sending the email. Please try again.

Proceed reservation?

Export
Filter
  • 04. Solid Earth  (3)
  • Springer  (2)
  • Frontiers  (1)
  • American Chemical Society
  • Frontiers Media
  • 2020-2022  (3)
  • 1935-1939
  • 1
    Publication Date: 2021-07-07
    Description: A number of oil- and gas-producing leases have been operating in Italy in the last decades, many of which are located in the surroundings of tectonically active regions. Identifying human-induced seismicity in areas with high levels of natural seismicity is a difficult task for which virtually any result can be a source of controversy. We implemented a large-scale analysis aiming at tracking significant departures of background seismicity from a stationary behavior around active oil and gas development leases in Italy. We analyzed seismicity rates before and after hydrocarbon peak production in six oil-producing and 43 gas-producing leases, and evaluate the significance of possible seismicity rate changes. In a considerable number of cases seismicity rate results stationary. None of the observed cases of seismicity rate increase after the peak production is statistically significant (at a s.l. = 0.05). Conversely, considering cases of seismicity rate decrease after peak production, our results suggest that the seismicity rate reduction is statistically significant (s.l. = 0.05) around one oil-producing lease (Val d’Agri, Basilicata) and around a cluster of gas-producing leases in Sicily. Our results put in evidence correlated changes between the rates of shallow seismicity and hydrocarbon production in these areas, which are then identified as hotspots requiring more detailed research; assessing actual causal relationships between these processes will require further physically-based modelling. If a physical causative link between these processes exists, then the observed seismicity rate reduction could either be due to increased seismicity during the progressive increase in production before reaching its maximum, or to an actual seismicity rate reduction after that peak. Considering that there is evidence of seismicity occurring before the start of hydrocarbon production, which contrasts with the evident reduction of events observed after the peak production, we think it likely that the seismicity inhibition is a plausible hypothesis. Using a simple model we also calculate Coulomb stress changes in planes optimally oriented for failure, and we show that under some conditions the inhibition of seismicity is feasible in at least one of these cases. We conclude that more efforts to study the mechanisms and the possible consequences of anthropogenically-driven seismicity inhibition are required.
    Description: This study was performed with the support of Clypea, the Innovation Network for Future Energy financed by the Italian Ministry of Economic Development, Direzione Generale per le Infrastrutture e la Sicurezza dei Sistemi Energetici e Geominerari (MISE—DGISSEG)
    Description: Published
    Description: 673124
    Description: 4T. Sismicità dell'Italia
    Description: JCR Journal
    Keywords: regional seismicity ; hydrocarbon production ; correlation analysis ; seismicity rate changes ; Italy, ; anthropogenic hazards ; 04. Solid Earth
    Repository Name: Istituto Nazionale di Geofisica e Vulcanologia (INGV)
    Type: article
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 2
    Publication Date: 2021-06-22
    Description: The densely populated Po Plain, a very deep sedi- mentary basin in northern Italy, is prone to heavy shaking during earthquakes. Seismic hazard assessment must account for local variation in wave amplification. Standard ground motion prediction equations may fail to picture the complexity of strong lateral gradients in seismic response, due to sharp structural heterogeneity. For this reason, there is an increasing demand for full waveform predictions for engineering applications. Here, we present an implementation of a hybrid broadband simulation based on the method of Mai et al. (Bull Seismol Soc Am 100(6):3338–3339, 2010), to obtain complete broadband seismograms of 0.1–10 Hz. With this method, low frequency (〈1 Hz) and high frequency (1–10 Hz) seismograms are simulated separately using a deter- ministic and a stochastic method, respectively. We apply the method to four events recorded within the Po basin, with magnitude ranging from Mw = 4.4 to Mw = 5.6. The low frequency (LF) simulation is performed using SPECFEM3D on a few test sub- surface velocity models. The three-dimensional velocity model MAMBo (Molinari et al. in Bull Seismol Soc Am 105(2A):753–764, 2015)—consisting of a detailed structural description of the basin, based on extensive active-source data, embedded within a regional 3D crustal model—provided the best results for broadband simulations that most closely corresponded with the observations. It performed better than an ambient noise tomography model with more accurate S-wave velocities but less well defined layer topographies, emphasizing the importance of first order velocity discontinuities. The high frequency (HF) seis- mograms are simulated using the multiple scattering approach of Zeng et al. (J Geophys Res Solid Earth 96(B1):607–619, 1991). The scattering coefficients are obtained by performing a non linear inversion for each station to find best fitting synthetic envelopes. HF energy is then combined at 1 Hz to match the amplitude and phase spectra of the LF signal. We are able to simulate full waveforms throughout the Po Plain, of which shaking duration matches observed data for stations located in the basin. Shaking amplitudes are generally overestimated in the low frequency simulation by the MAMBo velocity model. Updating the MAMBo velocity model with more accurate S-wave velocity information of the ambient noise tomography model should improve the fit in future simulations.
    Description: Published
    Description: 2181–2198
    Description: 1T. Struttura della Terra
    Description: JCR Journal
    Keywords: Ground motion ; hybrid method ; sedimentary basin ; Seismic shaking scenario ; 04. Solid Earth
    Repository Name: Istituto Nazionale di Geofisica e Vulcanologia (INGV)
    Type: article
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
  • 3
    Publication Date: 2020-03-03
    Description: A critical point in the analysis of ground dis- placement time series, as those recorded by space geodetic techniques, is the development of data-driven methods that allow the different sources of deformation to be discerned and characterized in the space and time domains. Multivariate statistic includes several approaches that can be considered as a part of data-driven methods. A widely used technique is the principal component analysis (PCA), which allows us to reduce the dimensionality of the data space while maintain- ing most of the variance of the dataset explained. However, PCA does not perform well in finding the solution to the so-called blind source separation (BSS) problem, i.e., in recovering and separating the original sources that gener- ate the observed data. This is mainly due to the fact that PCA minimizes the misfit calculated using an L 2 norm (χ 2 ), look- ing for a new Euclidean space where the projected data are uncorrelated. The independent component analysis (ICA) is a popular technique adopted to approach the BSS problem. However, the independence condition is not easy to impose, and it is often necessary to introduce some approximations. To work around this problem, we test the use of a modi- fied variational Bayesian ICA (vbICA) method to recover the multiple sources of ground deformation even in the presence of missing data. The vbICA method models the probability density function (pdf) of each source signal using a mix of Gaussian distributions, allowing for more flexibility in the description of the pdf of the sources with respect to standard ICA, and giving a more reliable estimate of them. Here we present its application to synthetic global positioning system (GPS) position time series, generated by simulating deforma- tion near an active fault, including inter-seismic, co-seismic, and post-seismic signals, plus seasonal signals and noise, and an additional time-dependent volcanic source. We evaluate the ability of the PCA and ICA decomposition techniques in explaining the data and in recovering the original (known) sources. Using the same number of components, we find that the vbICA method fits the data almost as well as a PCA method, since the χ 2 increase is less than 10 % the value cal- culated using a PCA decomposition. Unlike PCA, the vbICA algorithm is found to correctly separate the sources if the correlation of the dataset is low (〈0.67) and the geodetic network is sufficiently dense (ten continuous GPS stations within a box of side equal to two times the locking depth of a fault where an earthquake of Mw 〉 6 occurred). We also provide a cookbook for the use of the vbICA algorithm in analyses of position time series for tectonic and non-tectonic applications.
    Description: Published
    Description: 323–341
    Description: 1T. Struttura della Terra
    Description: 2T. Deformazione crostale attiva
    Description: JCR Journal
    Keywords: 04. Solid Earth ; 04.03. Geodesy
    Repository Name: Istituto Nazionale di Geofisica e Vulcanologia (INGV)
    Type: article
    Location Call Number Expected Availability
    BibTip Others were also interested in ...
Close ⊗
This website uses cookies and the analysis tool Matomo. More information can be found here...