ALBERT

Description: A middle Eocene to lower Oligocene sedimentary sequence was drilled at Site 841 in the Tonga forearc region during Ocean Drilling Program Leg 135. A 56-m-thick sequence of volcanic sandstone, spanning from Cores 135-841B-4IR to -47R (549.1 to 605 mbsf), unconformably overlies rhyolitic volcanic basement. The middle Eocene planktonic foraminifer assemblages (P Zone?), which occur in association with larger benthic foraminifers, include spinose species of Acarinina, Morozovella, and Truncorotaloides, but their abundance is low. Late Eocene and early Oligocene faunas are abundant and show the highest diversity of the Paleogene sequence drilled at this site. They have been assigned to Zones P15-16 and P18, respectively. The Eocene/Oligocene boundary was not recognized because of a hiatus in which Zone P17 (37.2-36.6 Ma) was missing. Another hiatus is recorded in the interval between the middle and late Eocene, spanning at least 1.8 Ma. Paleogene assemblages of Site 841 contain equal numbers of warm- and cool-water species, an attribute of the warm middle-latitude Paleogene fauna of the Atlantic Ocean. In particular, common to high abundances of cool-water taxa, such as Globorotaloides, Catapsydrax, Tenuitella, and small globigerinids, may be related to the opening of a shallow seaway south of Tasmania permitting the influx of cool Indian Ocean waters into the South Pacific before the late Eocene (approximately 37 Ma).

Description: A felsic volcanic series (605-825 mbsf) overlain by upper Eocene shallow-water sediments (500-605 mbsf) and basalticandesitic sills that intruded into sediments of Holocene to Miocene age (0-500 mbsf) was drilled in the forearc region of the Lau Basin at a water depth of 4810 m. The volcanic sequence at Site 841 includes altered and mineralized calc-alkaline rhyolites and dacites, dacitic tuffs, lapilli tuffs, flow breccias, and welded tuffs. These rocks formed subaerially or in a very shallow-water environment suffering a subsidence of 〉5000 m since Eocene times. Calculations of gains and losses of the major components during alteration show most pronounced changes in the uppermost 70 m of the volcanic sequence. Here, Al, Fe, Mg, and K are enriched, whereas Si and Na are strongly depleted. Illite, vermiculite, chlorite, and hematite predominate in this part of the hole. Throughout the section, quartz, plagioclase, kaolinite, and calcite are present. Sulfide mineralization (up to 10 vol%) consisting mainly of disseminated pyrite (with minor pyrrhotite inclusions) and marcasite together with minor amounts of chalcopyrite is pervasive throughout. Locally, a few sulfide-bearing quartz-carbonate veins as well as Ti-amphibole replacement by rutile and then by pyrite were observed. Strong variations in the As content of sulfides (from 0 to 0.69 wt%) from the same depth interval and local enrichments of Co, Ni, and Cu in pyrite are interpreted to result from fluctuations in fluid composition. Calculations of oxygen and sulfur fugacities indicate that fO2 and fS2 were high at the top and lower at the bottom of the sequence. Sulfur isotope determinations on separated pyrite grains from two samples give d34S values of +6.4ë and +8.4ë, which are close to those reported from Kuroko and Okinawa Trough massive sulfide deposits and calc-alkaline volcanic rocks of the Japanese Ryukyu Island Arc. Calculated chlorite formation temperatures of 265°-290°C at the top of the sequence are consistent with minimum formation temperatures of fluid inclusions in secondary quartz, revealing a narrow range of 270°-297°C. Chlorite formation temperatures are constant downhole and do not exceed 300°C. The presence of marcasite and 4C-type pyrrhotite indicates a formation temperature of 〈= 250°C. At a later stage, illite was formed at the top of the volcanic series at temperatures well below 200°C.